2015 MITSUBISHI L200 manual transmission

Automatic transmissionSports Mode 4A/T, 5A/T E00603200710NOTElDuring running-in period or immediately af-
ter reconnection of the battery cable, there may be a case where gear shifts are not
made smoothly. This does not indicate a faulty transmission.
Gear shifts will become smooth after the transmission has been shifted several times
by the electronic control system.Selector lever operation
E00603301082
The transmission has 4 forward gears (4A/T),
5 forward gears (5A/T) and 1 reverse gear.
The individual gears are selected automati- cally, depending on the position of the gear selector lever, the speed of the vehicle and
the position of the accelerator pedal.
The selector lever has 2 gates; the main gate
(1) and the manual gate (2).NOTEl For information on manual gate operation,
please refer to “Sports mode” on page 6-21.In the main gate, the selector lever has 4 po-
sitions, and is equipped with a lock button
(A) to avoid inadvertent selection of the wrong gear.The lock button must be pushed while the brake pedal is depressed to move
the selector lever.The lock button must be pushed to move the selector lever.
Automatic transmission Sports Mode 4A/T, 5A/T
6-19OKTE15E3Starting and driving6

CAUTIONlNever shift into the “P” (PARK) or “R”
(REVERSE) position while the vehicle is in motion to avoid transmission damage.
“N” NEUTRAL
At this position the transmission is disengag-
ed. It is the same as the neutral position on aM/T , and should only be used when the vehi-
cle is stationary for an extended length of time during driving, such as in a traffic jam.
WARNINGl Never move the selector lever to the “N”
(NEUTRAL) position while driving. A se-rious accident could occur since you could
accidentally move the lever into the “P” (PARK) or “R” (REVERSE) position or
you will lose engine braking.
l On a gradient the engine should be star-
ted in the “P” (PARK) position, not in the “N” (NEUTRAL) position.
l Always keep your right foot on the brake
pedal when shifting into or out of “N” (NEUTRAL), to minimize the risk of loss
of control.
“D” DRIVE
This position is for normal driving. The
transmission automatically selects a suitable
gear ratio for your speed and acceleration.
CAUTIONl Never shift into the “D” (DRIVE) position
from the “R” (REVERSE) position while the
vehicle is in motion to avoid transmission damage.Sports mode
E00603901323
Whether the vehicle is stationary or in mo-
tion, sports mode is selected by gently push-ing the selector lever from the “D” (DRIVE)
position into the manual gate (A). To return to “D” range operation, gently push the selec-tor lever back into the main gate (B).

In sports mode, gear shifts can be made rap-
idly simply by moving the selector lever backward and forward. In contrast to a man- ual transmission, the sports mode allows gear shifts with the accelerator pedal depressed.SHIFT UPSHIFT DOWN
+ (SHIFT UP)
Push the lever forward once to shift up
one gear.

- (SHIFT DOWN)
Pull the lever backward once to shift
down one gear.
CAUTIONl In sports mode, the driver must execute up-
ward shifts in accordance with prevailingroad conditions, taking care to keep the en-
gine speed below the red zone.
Automatic transmission Sports Mode 4A/T, 5A/T
6-21OKTE15E3Starting and driving6

NOTElWhen the selector lever position indicator in
the instrument panel blinks, it means that there is an abnormal condition in the trans-
mission. Refer to “When the selector lever position indicator blinks” on page 6-22.Easy select 4WD*
E00614700148
Shifting to rear-wheel drive or 4-wheel drive can be made by operating the transfer shiftlever (A). Shift the transfer shift lever to an
appropriate position according to the road surface conditions. In addition, the
2WD/4WD operation indication lamp indi- cates the transfer shift lever shifting state.Refer to “2WD/4WD operation indicationlamp” on page 6-27.Transfer shift lever position
and 2WD/4WD operation indi- cation lamp
E00614800080
Transfer shift lever position
2WD/4WD operation
indication lamp
Driving
conditions2HRear-wheel driveWhen driv-
ing on dry paved road.
4H4-wheel drive
When driv-
ing on rough, sand
or snow covered
roads.
Easy select 4WD*
6-25OKTE15E3Starting and driving6 Vehicles with manual transmissionVehicles with automatic transmission

Transfer shiftlever position
2WD/4WD operation
indication lamp
Driving
conditions
4L
Low range 4-wheel drive
When driv-
ing up or down steep
hills, on rough or
muddy
roads (es- pecially
when in-
creased tor-
que is re- quired).
: Illuminate
: Remain off
NOTEl On vehicles with automatic transmission,
when the transfer shift lever is in “4L”, the transmission will not shift into the overdrivegear.CAUTIONl The “4L” range gives maximum torque for
lowspeed driving on steep slopes, as well assandy, muddy, and other difficult surfaces.
On vehicles with automatic transmission, do not exceed speeds of approximately 70 km/h
(43 mph) in “4L” range.
l Do not drive your vehicle in the “4H” or
“4L” on dry paved roads and highways. Do-
ing so may result in excessive tyre wear, in-
creased fuel consumption, and possible noise
generation. It may also increase the differen-
tial oil temperature, which may damage the drive system. Further, the drive train will besubjected to excessive loading, resulting in
oil leakage, component seizure, or other seri-
ous problems. On dry paved roads and high- ways, drive the vehicle in “2H” only.Transfer shift lever operation
E00614900111
The shift pattern is shown on the transfer
shift lever knob.
The transfer shift lever should be positioned
in accordance with the following operating conditions:
To shift fromToProcedureVehicles with manual transmissionVehicles with automatic transmission2H4HThe transfer shift lever can be operated while the ve-
hicle is either moving or stationary.The transfer shift lever can be operated while thevehicle is either moving or stationary.
Easy select 4WD*
6-26OKTE15E3Starting and driving6

To shift fromToProcedureVehicles with manual transmissionVehicles with automatic transmission
4H2H
When the vehicle is not in motion, shift the gearshift
lever to the “N” (Neutral) position before operating
the transfer shift lever.
When the vehicle is moving, and only while it can be steered straight ahead, release the accelerator pedal
before operating the transfer shift lever.When the vehicle is not in motion, shift the selector
lever to the “N” (NEUTRAL) position before oper-
ating the transfer shift lever.
When the vehicle is moving, and only while it can
be steered straight ahead, shift the selector lever to
the “D” (DRIVE) position, and release the accelera- tor pedal before operating the transfer shift lever.4H4L
Stop the vehicle, depress the clutch pedal to the floor
and operate the transfer shift lever.
Stop the vehicle, shift the selector lever to the “N”
(NEUTRAL) position, and operate the transfer shift
lever.
If operation is made with the selector lever placed
in any other position than “N” (NEUTRAL) posi-
tion, a gear noise may be generated, with a possible
failure to shift into a proper gear.
4L4H
NOTEl Shifting of the transfer shift lever between
“2H” ↔ “4H” should only be done at speeds below 100 km/h (62 mph).
l During driving, never attempt to shift from
“4H” to “4L”.
l When shifting from “2H” to “4H” in cold
weather while the vehicle is in motion, the transmission gear may make some noise. In
cold weather, try to shift the gear while the
vehicle is stopped.NOTEl There may be a case that the transfer shift
lever feels heavy when it is moved from
“4H” to “2H” with the steering wheel in
turned position.
This is normal and not any indication of trouble.CAUTIONl Do not operate the transfer shift lever while
the rear wheels of the vehicle are slipping on snow or ice.2WD/4WD operation indica-
tion lamp
E00615000122Easy select 4WD*
6-27OKTE15E3Starting and driving6

Transfer shift leverposition2WD/4WD opera-
tion indication lamp
4L
: Illuminate
: Remain off
NOTEl The 2WD/4WD operation indication lamp
will go out momentarily during shiftingprocess from “4H” to “4L” or vice versa, as
the transfer shift lever passes through the neutral position.
Be sure to operate the transfer shift lever un- til the 2WD/4WD operation indication lampilluminates again.NOTEl If, after a “4H” ↔ “4L” selection has been
made, the 2WD/4WD operation indication lamp remains off and the desired range is not
actually selected, return the transfer shift
lever to its previous position. Place the steer- ing wheel in the straight ahead position,
drive the vehicle forward, and release the ac- celerator pedal. Next, hold down the clutch
pedal (with manual transmission) or place the selector lever in the “N” (NEUTRAL)
position (with automatic transmission) and make the range selection again.Super select 4WD*
E00605700214
Shifting to rear-wheel drive or 4-wheel drive can be made by operating the transfer shiftlever (A). Shift the transfer shift lever to an
appropriate position according to the road surface conditions. In addition, the
2WD/4WD operation indication lamp indi- cates the transfer shift lever shifting state.Refer to “2WD/4WD operation indicationlamp” on page 6-32.
Super select 4WD*
6-29OKTE15E3Starting and driving6 Vehicles with manual transmissionVehicles with automatic transmission

Transfer shift lever operation
E00605900173
The shift pattern is shown on the transfer
shift lever knob.
The transfer shift lever should be positioned
in accordance with the following operating conditions:
: Not push down the transfer shift
lever
: Push down the transfer shift lever
To shift fromToProcedureVehicles with manual transmissionVehicles with automatic transmission2H4HThe transfer shift lever can be operated while the ve- hicle is either moving or stationary.
When the vehicle is not in motion, shift the gearshift
lever to the “N” (Neutral) position before operating
the transfer shift lever.
When the vehicle is moving, and only while it can be
steered straight ahead, and release the accelerator ped- al before operating the transfer shift lever.The transfer shift lever can be operated while the
vehicle is either moving or stationary.
When the vehicle is not in motion, shift the selector
lever to the “N” (NEUTRAL) position before oper-
ating the transfer shift lever.
When the vehicle is moving, and only while it can
be steered straight ahead, shift the selector lever to
the “D” (DRIVE) position, and release the accelera-
tor pedal before operating the transfer shift lever.4H2H or 4HLc
4HLc4H4HLc4LLc
Stop the vehicle, depress the clutch pedal to the floor
and operate the transfer shift lever while keeping the
transfer shift lever pushed down.
Keep depressing the clutch pedal while the
2WD/4WD operation indication lamp continues to
blink.Stop the vehicle, shift the selector lever to the “N”
(NEUTRAL) position, and operate the transfer shift
lever while keeping the transfer shift lever pushed
down.
If operation is made with the selector lever placed
in any other position than “N” (NEUTRAL) posi-
Super select 4WD*
6-31OKTE15E3Starting and driving6

To shift fromToProcedureVehicles with manual transmissionVehicles with automatic transmission4LLc4HLction, a gear noise may be generated, with a possible
failure to shift into a proper gear.NOTEl Shifting of the transfer shift lever between
“2H” ↔ “4H” should only be done at speeds below 100 km/h (62 mph).
l During driving, never attempt to shift from
“4HLc” to “4LLc”.
l When shifting from “2H” to “4H” in cold
weather while the vehicle is in motion, the transmission gear may make some noise. In
cold weather, try to shift the gear while the
vehicle is stopped.
l When the transfer shift lever is shifted from
“4H” to “4HLc” while the vehicle is stop- ped, the 2WD/4WD operation indication lamp blinks while the selection is in process. Drive slowly and normally after confirmingthat the lamp is illuminated. (Refer to “2WD/4WD operation indication lamp” on
page 6-32.)
l Do not move the selector lever while the
2WD/4WD operation indication lamp is blinking.
l The 2WD/4WD operation indication lamp
will go out momentarily during shifting process from “4HLc” to “4LLc” or vice ver-sa, as the transfer shift lever passes through the neutral position.
Be sure to operate the transfer shift lever un-
til the 2WD/4WD operation indication lamp illuminates again.NOTEl There may be a case that the transfer shift
lever feels heavy when it is moved from
“2H” to “4H” with the steering wheel in
turned position.
This is normal and not any indication of trouble.CAUTIONl Do not operate the transfer shift lever while
the rear wheels of the vehicle are slipping on snow or ice.2WD/4WD operation indica-
tion lamp
E00625900036
A- Front wheel lamp B- Centre differential lock lamp
C- Rear wheel lamp
When the ignition switch is in the “ON” posi-
tion, the 2WD/4WD operation indication lamp shows the shifting condition. The 2WD/4WD operation indication lamp comeson at each transfer shift lever position as fol-
lows:
Super select 4WD*
6-32OKTE15E3Starting and driving6