forming maintenance work under the vehi-
cle.
R Avoid changing the wheel on uphill and
downhill slopes.
R Before raising the vehicle, secure it from
rolling away by applying the parking brake
and inserting wheel chocks. Never disen-
gage the parking brake while the vehicle is
raised.
R The jack must be placed on a firm, flat and
non-slip surface. On a loose surface, a
large, flat, load-bearing underlay must be
used. On a slippery surface, a non-slip
underlay must be used, e.g. rubber mats.
R Do not use wooden blocks or similar
objects as a jack underlay. Otherwise, the
jack will not be able to achieve its load-
bearing capacity due to the restricted
height.
R Make sure that the distance between the
underside of the tires and the ground does not exceed 1.2 in (3 cm).
R Never place your hands and feet under the
raised vehicle.
R Do not lie under the vehicle.
R Do not start the engine when the vehicle is
raised.
R Never open or close a door or the tailgate
when the vehicle is raised.
R Make sure that no persons are present in
the vehicle when the vehicle is raised. X
Using lug wrench 0043, loosen the bolts on
the wheel you wish to change by about one full turn. Do not unscrew the bolts com-
pletely.
The jacking points are located just behind the
wheel housings of the front wheels and just in front of the wheel housings of the rear wheels(arrows).
X Take the ratchet wrench out of the tire-
changing tool kit and place it on the hexa-
gon nut of the jack so that the letters AUF
are visible. X
Position jack 0087at jacking point 0044. Example350
Changing a wheelWheels and tires
All other models Capacity
Refrigerant
22.9 ± 0.4 oz
(650 ± 10 g) PAG oil
4.2 oz
(120 g) Vehicle data
General notes
Please note that for the specified vehicle
data: R the heights specified may vary as a result
of:
- tires
- load
- condition of the suspension
- optional equipment
R optional equipment reduces the maximum
payload. Dimensions and weights Model
0043 0043
Maximum
headroom 0044
0044
Opening height GLA 250
73.6 in
(1876 mm) 80.5 in
(2045 mm) GLA 250
4MATIC
75.4 in
(1914 mm) 82.0 in
(2083 mm) AMG vehicles
73.5 in
(1866 mm) 79.5 in
(2019 mm) Missing values were not available at time of
going to print.
AMG vehicles
Vehicle length
175.0 in
(4445 mm) Vehicle width
including exterior
mirrors
79.6 in
(2022 mm) Vehicle height
58.2 in
(1479 mm) Wheelbase
106.3 in
(2699 mm) Turning radius
38.7 ft
(11.8 m) Maxi
mum roof
load 220.5 lb
(100 kg) All other models
Vehicle length
173.9 in
(4417 mm) Vehicle width
including exterior
mirrors
79.6 in
(2022 mm) 368
Vehicle dataTechnical data
All other models
Wheelbase
106.3 in
(2699 mm) Turning radius
38.8 ft
(11.84 m) Model Vehicle height
GLA 250
58.8 in
(1494 mm) GLA 250 4MATIC
60.3 in
(1532 mm) Model Maximum trunk
load GLA 250
220.5 lb
(100 kg) GLA 250 4MATIC
Model Roof load
GLA 250
166.3 lb
(75 kg) GL
A 250 4MATIC Vehicle data for off-road driving
Maximum water depth
! The water depth must not exceed the
specified value. Note that the permissible
water depth is less in flowing water. Missing values for maximum water depth
0043
were unavailable at the time of going to print.
When the vehicle is loaded and ready to drive, it has a full tank, all fluids have been refilled
and the driver is in the vehicle.
Further information about driving on flooded
roads (Y page 167). Approach/departure angle
Missing values for the approach/departure
angles at front
0043and rear 0044were not avail-
able at the time of going to print.
For further information about approach/
departure angles, see (Y page 170). Maximum gradient-climbing capabil-
ity
Note that the vehicle's gradient-climbing
capability depends on the off-road conditions
and the road surface conditions.
GLA 250 4MATIC: the maximum gradient
climbing ability is 65%. Vehicle data for off-road driving
369Technical data Z
