2015 MERCEDES-BENZ G-Class hood open

Dashboard ....................................
.302
Front-passenger footwell .............. .302
Transmission tunnel ....................... 302
Fuse extractor ................................... 301
Fuses
Allocation chart ............................ .301
Before changing ............................ .301
Dashboard fuse box ....................... 302
Fuse allocation chart ..................... 301
Fuse box in the front-passenger
footwell .......................................... 302
Fuse box in the transmission tun-
nel ................................................. 302
Important safety notes .................. 301
In the battery case ......................... 303 G
Garage door opener Clearing the memory ..................... 270
General notes ................................ 266
Important safety notes .................. 267
Opening/closing the garage door .. 270
Programming the remote control ... 267
Gasoline ............................................. 338
Gear indicator (on-board com-
puter) ................................................. .209
Gear or selector lever (cleaning
guidelines) ......................................... 286
Genuine parts ...................................... 20
Genuine wood trim and trim strips
(cleaning instructions) ......................286
Glove box .......................................... .249
Gradient-climbing capability (max-
imum) ................................................. 161
GTW (Gross Trailer Weight) (defini-
tion) .................................................... 325 H
Hazard warning lamps ......................104
Head restraints
Adjusting ......................................... 86
Adjusting (rear) ................................ 87
Installing/removing (rear) ................ 88
Luxury .............................................. 87
Resetting (front) ............................... 87
see NECK-PRO head restraints see NECK-PRO luxury head restraints
Headlamps
Adding fluid to cleaning system ..... 278
Cleaning ......................................... 284
Cleaning system (function) ............ 103
Cleaning system (notes) ................ 343
Fogging up ..................................... 105
Protective grille .............................. 112
see Automatic headlamp mode
Heating
see Climate control
High-beam headlamps
Display message ............................ 219
Switching on/off ........................... 103
Hill start assist .................................. 135
HOLD function
Function/notes ............................ .180
Hood
Closing .......................................... .275
Display message ............................ 233
Important safety notes .................. 274
Opening ......................................... 275
Horn ...................................................... 30
Hydroplaning ..................................... 156 I
Immobilizer .......................................... 65
Instrument cluster
Overview ........................................ 197
Warning and indicator lamps ......... 234
Instrument cluster lighting .............. 197
Interior lighting
Automatic control .......................... 106
Cargo compartment lamp .............. 107
Delayed switch-off (on-board
computer) ...................................... 208
Manual control ............................... 106
Overview ........................................ 105
Reading lamp ................................. 105
Rear interior lighting ..................... .108 J
Jack Pump lever ..................................... 329
Storage location ............................ 290
Using ............................................. 328 10
Index

Cockpit
Function Page
:
Combination switch 103
;
Steering wheel paddle shifters 144
=
Instrument cluster 197
?
Horn
A
Overhead control panel 36
B
PARKTRONIC warning display 182
C
Climate control systems 118
D
Ignition lock 133
E
Adjusts the steering wheel 90
F
Cruise control lever 163
G
Light switch 98
H
Opens the hood 27530
CockpitAt a glance

ATA (anti-theft alarm system)
X
To arm: lock the vehicle with the Smart-
Key.
Indicator lamp :flashes. The alarm sys-
tem is armed after approximately
15 seconds.
X To disarm: unlock the vehicle with the
SmartKey.
i If you then do not open a side door or the
rear door, the alarm system switches back
on again after approximately 40 seconds.
X To stop the alarm: insert the SmartKey
into the ignition lock.
The alarm is switched off.
or X Press the %or& button on the
SmartKey.
The alarm is switched off.
A visual and audible alarm is triggered if the
alarm system is armed and you open:
R a door
R a door using the mechanical key
R the rear door
R the hood
The alarm is also triggered if:
R the position of the vehicle is changed.
R a window is smashed.
The alarm is not switched off, even if you
close the open door that triggered it, for
example. i
If the alarm stays on for more than
30 seconds, the mbrace emergency call
system (USA only) or Tele Aid system (Can- ada only) initiates a call to the Customer
Assistance Center automatically. The
mbrace emergency call system initiates the
call if:
R you have subscribed to the Tele Aid ser-
vice.
R the Tele Aid service has been activated
properly.
R the required mobile phone, power supply
and GPS are available. 66
Theft deterrent locking systemSafety

Switching the rear window wiper on/
off Combination switch
:
è Switch
2 b To wipe with washer fluid
3 ITo switch on intermittent wiping
4 0To switch off intermittent wiping
5 b To wipe with washer fluid
X Turn the SmartKey to position 1or 2in the
ignition lock.
X Turn switch :on the combination switch
to the corresponding position.
When the rear window wiper is switched on,
the icon appears in the instrument cluster.
i The rear window wiper comes on auto-
matically if you shift the selector lever to R
while the windshield wipers are on. Replacing the wiper blades
Important safety notes G
WARNING
If the windshield wipers begin to move while
you are changing the wiper blades, you could be trapped by the wiper arm. There is a risk of
injury.
Always switch off the windshield wipers and
ignition before changing the wiper blades.
! To avoid damaging the wiper blades,
make sure that you touch only the wiper
arm of the wiper. !
Never open the hood if a windshield wiper
arm has been folded away from the wind-
shield.
Never fold a windshield wiper arm without a
wiper blade back onto the windshield/rear window.
Hold the windshield wiper arm firmly whenyou change the wiper blade. If you release
the windshield wiper arm without a wiper
blade and it falls onto the windshield, the
windshield may be damaged by the force of
the impact.
Mercedes-Benz recommends that you have the wiper blades changed at a qualified
specialist workshop.
Removing the wiper blades :
Windshield wiper arm
; Wiper blade
= Locking spring
? Hinge piece
X Remove the SmartKey from the ignition
lock.
X Fold wiper arm :away from the wind-
shield until it engages.
X Position wiper blade ;horizontally.
X Press locking spring =.
X Slide wiper blade ;with hinge piece ?
from wiper arm :. Windshield wipers
115Lights and windshield wipers Z

X
To deactivate: press theÁbutton.
The indicator lamp in the Ábutton goes
out.
i Residual heat is deactivated automati-
cally:
R after approximately 30 minutes
R when the ignition is switched on
R if the battery voltage drops
R if the coolant temperature is too low Setting the air vents
Important safety notes
G
WARNING
Very hot or very cold air can flow from the air vents. This could result in burns or frostbite in the immediate vicinity of the air vents. There
is a risk of injury.
Make sure that all vehicle occupants always
maintain a sufficient distance to the air out-
lets. If necessary, redirect the airflow to
another area of the vehicle interior. General notes
In order to ensure the direct flow of fresh air
through the air vents into the vehicle interior,
please observe the following notes:
R keep the air intake grill on the hood free of
blockages, such as ice, snow or leaves.
R never cover the air vents or air intake grilles
in the vehicle interior.
i For virtually draft-free ventilation, adjust
the sliders of the air vents to the center
position.
i If the automatic climate control con-
stantly differs from the set temperature or
if undesired drafts are noticeable, proceed
as follows:
XOpen the side air vents
X Open the center air vents X
Open the rear air vents
X Set the temperature to 72 ‡ (22 †).
The automatic climate control adjusts
to the set temperature. Setting the center air vents
Center air vents
:
Center air vent, left
; Center air vent, right
= Center vent thumbwheel, right
? Center vent thumbwheel, left
X To open/close: turn thumbwheels =
and ?to the right or left. Setting the side air vents
Side air vents
:
Side air vent
; Swiveling side air vent
= Control for side air vent
X To open/close: turn thumbwheel =to the
left or right. 128
Setting the air ventsClimate control

R
the vehicle is stationary.
R the outside temperature is within the com-
fort range.
R the engine is at normal operating temper-
ature.
R the set temperature for the vehicle interior
has been reached.
R the battery is sufficiently charged.
R the system detects that the windshield is
not fogged up when the air-conditioning
system is switched on.
R the hood is closed.
R the driver's door is closed and the driver's
seat belt is fastened.
If conditions for automatic engine switch-off
have not been fulfilled, the ¤symbol will
be shown in yellow.
In addition, the Stop/Start inactive Stop/Start inactive mes-
sage is shown in the AMG menu in the multi- function display.
i If you shift the transmission from
Rto D,
the ECO start/stop function is available
again once the ¤symbol reappears in
green in the multifunction display.
i The engine can be automatically switched
off an unlimited number of times.
i You can still activate the HOLD function
when the vehicle is stationary, even if the
engine has been switched off automati-
cally. It is then not necessary to continue
applying the brakes during the automatic
stop phase. When you depress the accel-
erator pedal, the engine starts automati-
cally and the braking effect of the HOLD
function is deactivated. Depress the accel-
erator pedal carefully, as the engine must
be started first.
i During automatic engine switch-off, the
climate control system only operates at a
reduced capacity. If you require full climate
control capacity, the ECO start/stop func-
tion can be deactivated by pressing the
ECO button (Y page 136). Automatic engine start The engine starts automatically if:
R In general:
- you switch off the ECO start/stop func-
tion by pressing the ECO button.
- you release the brakes when in transmis-
sion position Dor Nand when the HOLD
function is not active.
R By the driver:
- you release the brakes when in transmis-
sion position Dor N.
- you depress the accelerator pedal.
- you engage reverse gear R.
- you move the transmission out of posi-
tion P.
- you switch to drive program Sor M.
- you unfasten your seat belt or open the
driver's door.
R By the system:
- the vehicle starts to roll.
- the brake system requires this.
- the temperature in the vehicle interior
deviates from the set range.
- the system detects moisture on the
windshield when the air-conditioning
system is switched on.
- the battery's condition of charge is too
low.
i Shifting the transmission to position
P
does not start the engine. Driving
137Driving an d parking Z

Displays and operation
Instrument cluster
Instrument cluster: miles
:
Speedometer with segments (Y page 198)
; Multifunction display (Y page 199)
= Tachometer (Y page 198)
? Coolant temperature (Y page 197)
A Fuel gage
B Instrument cluster lighting (Y page 197)Instrument cluster lighting
The brightness control knob is located on the bottom left of the instrument cluster
(Y page 197).
X Turn the brightness control knob clockwise
or counter-clockwise.
If the light switch is set to Ã,Tor
L, the brightness is dependent upon
the brightness of the ambient light.
i The light sensor in the instrument cluster
automatically controls the brightness of
the multifunction display.
In daylight, the displays in the instrument
cluster are not illuminated. Displaying the coolant temperature
G
WARNING
Driving when your engine is overheated can
cause some fluids which may have leaked into the engine compartment to catch fire. You
could be seriously burned.
Steam from an overheated engine can cause
serious burns which can occur just by opening
the engine hood. Stay away from the engine if you see or hear steam coming from it.
Stop the vehicle in a safe location away from
other traffic. Turn off the engine, get out of the
vehicle and do not stand near the vehicle until
the engine has cooled down.
! A display message is shown if the coolant
temperature is too high. Displays and ope
ration
197On-board computer and displays Z

Display messages
Possible causes/consequences and
M
MSolutions ?
Coolant Too Hot Coolant Too Hot
Stop Vehicle Stop Vehicle
Switch Engine Off Switch Engine Off The coolant is too hot.
A warning tone also sounds.
G WARNING
Do not drive when your engine is overheated. This can cause some
fluids which may have leaked into the engine compartment to
catch fire.
Steam from the overheated engine can also cause serious burns
which can occur just by opening the hood.
There is a risk of injury.
X Pull over and stop the vehicle safely and switch off the engine,
paying attention to road and traffic conditions.
X Secure the vehicle against rolling away (Y page 150).
X Leave the vehicle and keep a safe distance from the vehicle until
the engine has cooled down.
X Make sure that the air supply to the engine radiator is not
blocked, e.g. by snow, slush or ice.
X Do not start the engine again until the display message goes out
and the coolant temperature is below 248 ‡ (120 †). Other-
wise, the engine could be damaged.
X Pay attention to the coolant temperature display.
X If the temperature increases again, visit a qualified specialist
workshop immediately.
Under normal operating conditions and with the specified coolant
level, the coolant temperature may rise to 248 ‡ (120 †). The poly-V-belt may have torn.
X Pull over and stop the vehicle safely and switch off the engine,
paying attention to road and traffic conditions.
X Check the poly-V-belt.
If the poly-V-belt is torn:
! Do not continue driving. The engine could otherwise overheat.
X Consult a qualified specialist workshop.
If the poly-V-belt is not damaged:
X Wait until the display message disappears before restarting the
engine. Otherwise, the engine could be damaged.
X Pay attention to the coolant temperature display.
X Visit a qualified specialist workshop. 222
Display
messagesOn-board computer and displays