2015 MERCEDES-BENZ C-CLASS COUPE heating

Vehicl
eidentificatio nnumber (VIN) X
Slide the right-hand front sea ttoits rearmost
position.
X Fol dfloor covering ;upwards.
VIN :is visible.
The VIN can also be found on the vehicl eide n-
tification plate (Y page 370).
Onl yfor certain countries: the VIN can also be
found at the lowe redgeoft he windscreen. Engine number
The engine numbe risstampe dinto the crank-
case. Yo ucan obtai nfurther informatio nfrom
any qualified specialist workshop. Servic
eproducts and capacities Important safety notes
G
WARNING
Service product can be poisonou sand haz-
ardou stohealth.There is ariskofi njury.
Observe the instructions on the respective
original containe rwhenu sing ,storing and dis-
posing off service products. Alway sstor eser-
vice products in the seale doriginal container.
Alway skeeps ervice products ou tofthe reach
of children. H
Environmental note
Dispose of service products in an environ-
mentally-responsibl emanner. Service products includ
ethe following:
R Fuels
R Exhaus tgas aftertreatment additives, e.g.
AdBlue ®
R Lubricants (e.g. engine oil, transmission oil)
R Coolant
R Brake fluid
R Windscree nwashe rfluid
R Climate contro lsystem refrigerant
Components and service products must be
matched .Onlyu seproducts recommende dby
Mercedes-Benz. Damage which is caused by the us eofp roducts which have not been recom-
mended is not covered by the Mercedes-Benz
warranty or goodwil lgestures. The yare listed in
thi sM ercedes-Benz Owner' sManualint he
appropriate section.
Yo uc an identify service products approved by
Mercedes-Benz by the following inscriptions on
the container:
R MB-Freigab e(e.g. MB-Freigab e229.51)
R MB-Approval (e.g. MB-Approval 229.51)
Othe rdesig nations or recommendations indi-
cate alevel of quality or aspecification in
accordance with an MB Shee tNum ber(e.g. MB
229.5) .The yh aven ot necessaril ybeen
approved by Mercedes-Benz.
Othe ride ntifications, for example:
R 0W -30
R 5W -30
R 5W -40
Yo uc an obtai nfurther informatio natany quali-
fie ds pecialist workshop or on the Interne tat
http://bevo.mercedes-benz.co m. Fuel
Important safety notes G
WARNING
Fuel is highly flammable. If you handle fuel
incorrectly, there is ariskoff irea nd explo-
sion.
You must avoi dfire, naked flames, creating
sparks and smoking. Switc hoff th eengine
and ,ifa pplicable, th eauxiliary heating before
refuelling. Service products and capacities
371Technical data Z

components in the exhaus
tsystem may over-
hea tunnoticed. There is ariskoff ire.
Neve rrefuel with petrol. Neve radd petro lto
diese lfuel.
! Whe
nrefuelling, only us ediese lfue lthat
conform stothe Europea nstandard EN 590 or
is of equivalent quality .Fuelthat doe snot
conform to EN 590 can lead to increase dwear
as well as damag etothe engine and exhaust
system.
! Do not us
ethe following:
R marine diesel
R heating oil
R bio-diesel
R vegetable oil
R petrol
R paraffin
R kerosene
Do not mix such fuels with diese lfue land do
not us eany specia laddit ives. Otherwise,
engine damag emay occur.
Usually yo uwillf ind information abou tthe fuel
grade on the pump. If yo ucannot find the label
on the petro lpum p, ask the filling station staff.
Information on refuelling (Y page 167).
Lo wo utside temperatures
In winter months, diese lfue lw ithani mproved
cold flo wquality is available .InEurope, the
EN 590 standard defines variou sclimate-
dependent temperature categories. Malfunc-
tions can be avoided by refuelling with diesel
fue lthat corresponds to the climati cspecifica-
tions outlined in EN 590. At unusually low out-
sid etemperatures, it is possible that the flow
characteristics of the diese lfue lcould be insuf-
ficient. Accordingly ,diese lfue lfrom warmer
areas may not be suitabl efor operation in colder
climati cconditions.
i Further information on country-specific fuel
properties and fue ltypes with low-tempera-
ture resistance can be obtained from oil com- panies ,e.g. at filling stations. AdBlue
®
Important safety notes AdBlue
®
is aw ater-solubl efluid for the exhaust
ga sa ftertreatment of diese lengines. It is:
R non-toxic
R colourless and odourless
R non-flammable
If yo uopent he AdBlue ®
tank, small amounts of
ammonia vapou rmay be released.
Ammoni avapours have apungent odour and are
particularly irritating to the skin, to mucous
membrane sand to the eyes. You may experi-
ence aburning sensation in your eyes, nose and
throat. You may also experience coughing and
watery eyes.
Do not inhale any ammonia vapours that may be
released .Only fil lthe AdBlue ®
tank in well-ven-
tilated areas.
Lo wo utside temperatures AdBlue
®
freezes at atemperature of approx-
imately -11 †. The vehicle is delivered from the
factory equipped with an AdBlue ®
preheating
system. Winte roperation can thus be guaran-
teed eve nattemperatures below -11 †.
Additives !
Only us
eAdBlue ®
in accordance with ISO
22241. Do not us eaddit ivesw ithA dBlue ®
and do not dilute AdBlue ®
with water. This
may destroy the BlueTEC exhaus tgas after-
treatment system.
Purity !
Impurities in AdBlue ®
(e.g .due to othe rser-
vice products, cleaning agents or dust) lead
to:
R increase demission values
R damag etothe catalytic converter
R engine damage
R malfunctions in the BlueTEC ®
exhaus tgas
aftertreatment system
Assuring the purity of AdBlue ®
is particularly
important with respect to avoiding malfunctions
in the BlueTEC exhaus tgas aftertreatment sys-
tem. 374
Servic
eproducts and capacitiesTechnical data

Additives
!
Do no
tuse any additive switht he engin eoil.
This could damag ethe engine. Brak
efluid G
WARNING
The brak efluid continuously absorbs mois-
tur efromt heair. This result sintheboiling
poin toft hebrak efluid lowering .Iftheboiling
poin toft hebrak efluid is to olow, vapour
pockets may for mwhen th ebrakes are sub-
jected to aheav yload. This would impair brak-
ing efficiency. There is ariskofana ccident.
Hav ethe brak efluid renewed at th eprescri-
bed intervals.
When handlin gbrak efluid ,observ ethe impor-
tan tsafet ynotes on servic eproducts
(Y page 371).
The brak efluid chang eintervals can be foun din
th eS ervic eBooklet.
Only use brak efluid approve dbyMercedes-
Benz in accordanc ewithM B-Freig abe or MB-
Approval 331.0.
Information about approve dbrak efluid can be
obtained at any qualified specialis tworkshop or
on th eInterne tat
http://bevo.mercedes-benz.co m.
i Have the brake fluid regularly replaced at a
qualified specialist workshop in accordance
with the replacement intervals and the
replacement confirmed in the Service Book-
let. Coolant
Importan tsafety notes G
WARNING
If antifreeze comes into contact with hot com- ponents in the engine compartment, it may
ignite. There is arisk of fire and injury.
Let the engine cool dow nbefore yo utop up
the antifreeze .Make sur ethat antifreeze is
not spilled next to the filler neck. Thoroughly clea
nthe antifreeze from components before
starting the engine.
! Only ad
dcoolant that has bee npremixed
with the desire dantifreeze protection. You
coul dotherwise damag ethe engine.
Furthe rinformatio noncoolants can be found
in the Mercedes-Benz Specifications for Ser-
vice Products, MB Specifications for Service
Products 310.1, e.g. on the Internet at
http://bevo.mercedes-benz.com .Orcontact
aq ualifie dspecialist workshop.
! Always use
asuitabl ecoolant mixture, even
in countries where hig htemperatures prevail.
Otherwise ,the engine cooling system is not
sufficiently protected from corrosion and
overheating.
i Have the coolant regularly replaced at a
qualified specialist workshop and the replace- ment confirmed in the Service Booklet.
Comply with the important safety precautions
for service products whe nhandling coolant
(Y page 371).
The coolant is amixture of water and anti-
freeze/corrosion inhibitor. It is responsible for
the following:
R anti-corrosion protection
R antifreeze protection
R raising the boiling point
If antifreeze/corrosion inhibito rispresent in the
correct concentration, the boiling point of the
coolant during operation will be approximately
130 †.
The antifreeze concentrate/corrosion inhibitor
concentration in the engine cooling system
should:
R be at least 50%. Thi swillp rotect the engine
cooling system against freezing dow nto
approximatel y-37 †.
R not excee d55% (antifreeze protection down
to -45 †). Hea twillo therwise not be dissipa-
ted as effectively.
Mercedes-Benz recommends an antifreeze/
corrosion inhibito rconcentrate in accordance
with MB Specifications for Service Products
310.1.
i Whe
nthe vehicle is first delivered, it is filled
with acoolant mixtur ethat ensures adequate
antifreeze and corrosion protection. 376
Service products and capacitiesTechnical data