2015 MAZDA MODEL 3 HATCHBACK warning

*Some models.4–41
When Driving
Instrument Cluster and Display
Warning Lights
These lights turn on or fl ash to notify the user of the system operation status or a system
malfunction.
Signal Warning Lights Page
Master Warning Light *1 7-32
Brake System Warning Light *1*2 7-32
ABS Warning Light *1 7-32
Charging System Warning Light *1 7-32
Engine Oil Warning Light *1 7-32
Check Engine Light *1 7-32
(Red) High Engine Coolant Temperature Warning Light
*1 7-32
(Amber) * i-stop Warning Light *1 4-22
(Amber) RVM Warning Light *1 7-32
* Automatic Transaxle Warning Light *1 7-32
Power Steering Malfunction Indicator Light *1 7-32
Air Bag/Front Seat Belt Pretensioner System Warning Light *1 7-32
Low Fuel Warning Light 7-32
Seat Belt Warning Light 7-32
.B[EB@&'&&"@&EJUJPOJOEC







*Some models.4–42
When Driving
Instrument Cluster and Display
Signal Warning Lights Page
Door-Ajar Warning Light 7-32
* 120 km/h Warning Light *1 7-32
* Low Washer Fluid Level Warning Light 7-32
* Tyre Pressure Monitoring System Warning Light *1 7-32
(Red) KEY Warning Light
*1 7-32
(Amber)
* Smart Brake Support/Smart City Brake Support (SBS/SCBS) Warning Light 7-32
(Amber)
* Lane Departure Warning System (LDWS) Warning Light *1*3 7-32
Headlight Auto-Levelling Malfunction Indicator Light *1 7-32
(Amber)
* High Beam Control System (HBC) Warning Light *1 7-32
(Amber)
* Mazda Radar Cruise Control (MRCC) Warning Light *1 7-32
*1 The light turns on when the ignition is switched on for an operation check, and turns off a few seconds later or
when the engine is started. If the light does not turn on or remains turned on, have the vehicle inspected at an
expert repairer, we recommend an Authorised Mazda Repairer.
*2 The light turns on continuously when the parking brake is applied.
*3 The light turns on when the system on stand-by. The light fl ashes when the system has a malfunction.
.B[EB@&'&&"@&EJUJPOJOEC







*Some models.4–43
When Driving
Instrument Cluster and Display
Indicator Lights
These lights turn on or fl ash to notify the user of the system operation status or a system
malfunction.
Signal Indicator Lights Page
(Green) * RVM Indicator Light 4-118
(Green)
* Lane Departure Warning System (LDWS) Indicator Light 4-110
(Green) KEY Indicator Light 3-9
(Green)
* High Beam Control System (HBC) Indicator Light 4-104
* Glow Indicator Light *1 4-46
* Diesel Particulate Filter Indicator Light *1 4-165
* Wrench Indicator Light *1 4-46
* TCS/DSC Indicator Light *1 4-88 ,
4-89
* DSC OFF Indicator Light *1 4-90
* AFS OFF Indicator Light *1 4-103
(Red)
* Smart Brake Support/Smart City Brake Support (SBS/SCBS) Indicator Light *1 4-144 ,
4-147
* Smart Brake Support/Smart City Brake Support (SBS/SCBS) OFF Indicator
Light*1 4-144
.B[EB@&'&&"@&EJUJPOJOEC







*Some models.4–44
When Driving
Instrument Cluster and Display
Signal Indicator Lights Page
(Green) * i-stop Indicator Light 4-22
* i-ELOOP Indicator Light 4-93
(Blue) Low Engine Coolant Temperature Indicator Light 4-46
* Shift Position Indication 4-51
Headlight High-Beam Indicator Light 4-67 ,
4-67
Direction Indicator/Hazard Warning Indicator Lights 4-72 ,
4-80
Security Indicator Light *1 3-45
(Green)
* Mazda Radar Cruise Control (MRCC) Indicator Light 4-127
(Amber)
* Cruise Main Indicator Light 4-157
(Green)
* Cruise Set Indicator Light 4-157
(Amber)
* Adjustable Speed Limiter Main Indicator Light 4-135
(Green)
* Adjustable Speed Limiter Set Indicator Light 4-135
Lights-On Indicator Light 4-62
* Front Fog Light Indicator Light 4-70
.B[EB@&'&&"@&EJUJPOJOEC







*Some models.4–46
When Driving
Instrument Cluster and Display
Wrench Indicator Light *
When the ignition is switched ON, the
warning light is illuminated and then turns
off after a few seconds.
When illuminated
The wrench indicator light is illuminated
when the preset maintenance period
arrives. Verify the content and perform
maintenance.
Refer to Maintenance Monitor on page
6-15 .
When fl ashing (SKYACTIV-D 2.2)
The sedimentor separates water from the
fuel.
If water accumulates in this fi lter, the
warning light will fl ash. When it does,
consult an expert repairer, we recommend
an Authorised Mazda Repairer as soon as
possible.
Low Engine Coolant Temperature
Indicator Light (Blue)
The light illuminates continuously when
the engine coolant temperature is low and
turns off after the engine is warm.
If the low engine coolant temperature
indicator light remains illuminated after
the engine has been suffi ciently warmed
up, the temperature sensor could have a
malfunction. Consult an expert repairer,
we recommend an Authorised Mazda
Repairer.
Glow Indicator Light
(SKYACTIV-D 2.2)
This light may illuminate when the
ignition is switched ON.
It turns off when the glow plugs are warm.
If the ignition is left switched ON for a
long period of time without the engine
running after the glow plugs are warmed
up, the glow plugs may warm up again
which will illuminate the glow indicator
light.
.B[EB@&'&&"@&EJUJPOJOEC







4–47
When Driving
Transaxle
Manual Transaxle
Operation
Manual Transaxle Shift Pattern
5-speed transaxle
6-speed transaxleNeutral position
Neutral position
The vehicle is equipped with either a
5-speed or 6-speed manual transaxle. The
shift pattern for each is shown above.
Depress the clutch pedal all the way down
while shifting; then release it slowly.(5-speed transaxle)
A safety feature prevents accidental
shifting from 5 to R (reverse). The shift
lever must be put in neutral before being
shifted to R.
(6-speed transaxle)
Vehicles with 6-speed transaxle are
equipped with a device to prevent shifting
to R (reverse) by mistake. Push the shift
lever downward and shift to R.
WARNING
Do not use sudden engine braking
on slippery road surfaces or at high
speeds:
Shifting down while driving on wet,
snowy, or frozen roads, or while driving
at high speeds causes sudden engine
braking, which is dangerous. The
sudden change in tyre speed could
cause the tyres to skid. This could
lead to loss of vehicle control and an
accident.
Be sure to leave the shift lever in 1 or
R position and set the parking brake
when leaving the vehicle unattended:
Otherwise the vehicle could move and
cause an accident.
.B[EB@&'&&"@&EJUJPOJOEC







4–51
When Driving
Transaxle
Shift Position Indication
The selector position is indicated when the
ignition is switched ON.
Gear position indication
In manual shift mode, the “M” of the shift
position indication illuminates and the
numeral for the selected gear is displayed.
Warning Light
The warning light turns on when the
system has a malfunction.
Refer to Warning Lights on page 4-41 .
Transaxle Ranges
 












 The shift position indicator light in the
instrument cluster illuminates. Refer to
Warning/Indicator Lights on page 4-40 .
 


 The selector lever must be in P or N to
operate the starter.
P (Park)
P locks the transaxle and prevents the front
wheels from rotating.
WARNING
Always set the selector lever to P and
set the parking brake:
Only setting the selector lever to the
P position without using the parking
brake to hold the vehicle is dangerous.
If P fails to hold, the vehicle could
move and cause an accident.
CAUTION
  Shifting into P, N or R while the
vehicle is moving can damage your
transaxle.
  Shifting into a driving gear or reverse
when the engine is running faster
than idle can damage the transaxle.
R (Reverse)
In position R, the vehicle moves only
backward. You must be at a complete
stop before shifting to or from R, except
under rare circumstances as explained in
Rocking the Vehicle (page 3-56 ).
N (Neutral)
In N, the wheels and transaxle are not
locked. The vehicle will roll freely even
on the slightest incline unless the parking
brake or brakes are on.
WARNING
If the engine is running faster than
idle, do not shift from N or P into a
driving gear:
It's dangerous to shift from N or P
into a driving gear when the engine
is running faster than idle. If this is
done, the vehicle could move suddenly,
causing an accident or serious injury.
Do not shift into N when driving the
vehicle:
Shifting into N while driving is
dangerous. Engine braking cannot be
applied when decelerating which could
lead to an accident or serious injury.
.B[EB@&'&&"@&EJUJPOJOEC







*Some models.4–56
When Driving
Transaxle
Using steering shift switch *
To shift up to a higher gear with the
steering shift switches, pull the UP switch
(
) toward you once with your
fi ngers.
UP switch (+/OFF)
WARNING
Keep your hands on the steering wheel
rim when using fi ngers on the steering
shift switches (6-speed transaxle
model):
Putting your hands inside the rim of
the steering wheel when using the
steering shift switches is dangerous. If
the driver's air bag were to deploy in a
collision, your hands could be impacted
causing injury.
NOTE
  When driving slowly, the gears may
not shift up.
  In manual shift mode, do not run the
engine with the tachometer needle
in the RED ZONE. When the engine
rpm is high, a gear may shift up
automatically to protect the engine.
NOTE
  When depressing the accelerator
fully, the transaxle will shift to a
lower gear, depending on vehicle
speed.
  The steering shift switch can be used
temporarily even if the selector lever
is in the D position while driving. In
addition, it returns to automatic shift
mode when the UP switch (
)
is pulled rearward for a suffi cient
amount of time.
Manually shifting down
You can shift gears down by operating the
shift lever or the steering shift switches
* .
4-speed transaxle model : M4
: M3
:
M2
: M1
6-speed transaxle model : M6
: M5
:
M4
: M3
: M2
: M1
Using selector lever
To shift down to a lower gear, tap the
selector lever forward
once.
.B[EB@&'&&"@&EJUJPOJOEC