Convenience
Intelligent Access Transmitter
Note:
Your intelligent access
transmitter must be within
3 feet (1 meter) of the vehicle
for intelligent access to
function properly.
To unlock and open the driver
door, pull the front exterior door
handle. To lock the doors, touch
the sensor button on the door
handle. To unlock and open
the liftgate, press the exterior
liftgate release button above the
license plate.
The intelligent access transmitter
also contains a mechanical
key blade, which can be used
to unlock the driver door,
if necessary.
Intelligent Access
Remote Entry Icons
Press once to lock all doors.
Press again within three seconds
to confirm all doors are locked.
Press
once to unlock the
driver’s door. Press again within
three seconds to unlock all doors.
Press
to activate the panic
alarm. Press again or turn on the
ignition to deactivate.
Press
twice within three
seconds to open the liftgate.
Car finder: Press
twice within
three seconds to locate your
vehicle. The horn sounds and the
lamps flash.
Remote Start
Allows you to start the engine
from outside your vehicle using
your transmitter. To start, press
and then press twice
within three seconds. Once
inside, apply the brake while
pressing the ENGINE START
STOP button. Shift into drive (D)
and go. If you have an integrated
keyhead transmitter, simply
insert the key into the ignition
and switch on the ignition as you
normally would before driving.
To switch off the engine from
outside the vehicle after using
your remote start, press
once.
SecuriCode™
Keyless Entry System
Allows you to lock or unlock the
doors, recall memory features
and arm or disarm the anti-theft
alarm. To get started, you need
your factory-set, 5-digit entry
code found on your owner’s
wallet card (located in the glove
box). Entering this code unlocks
the driver’s door. To lock all
doors, press and hold 7•8
and 9•0 at the same time. For
complete information, refer to
the SecuriCode Keyless Entry
Keypad section in the Locks
chapter of your Owner’s Manual.
Adaptive Headlamps*
The headlamp beams move in the same direction as the steering
wheel, providing more visibility when driving around curves. To use,
turn the lighting control switch to the autolamp position. The system is\
only active at speeds above 3 mph (5 km/h). See the Lighting chapter
in your Owner's Manual for more details.
Power Liftgate
Your lif tgate has an automatic open and closing feature. To
open remotely, press
twice on your remote control within three
seconds. Press
twice again to close or reverse the movement.
You can also operate the lif tgate by pressing the
button on
the instrument panel.
Lincoln Drive Control*
This suite of electronic vehicle systems continuously monitors both
your inputs and the road conditions to optimize ride comfort, steering, \
handling, powertrain response and sound. Choose your custom
driving experience through the information display under Settings,
Drive Assist and then Drive Control:
Comfort: provides drivers with easier steering and a more
fluid suspension.
Normal: delivers a more engaging drive experience with confident
handling and a powerful, yet quiet powertrain sound.
Sport: adds a sporty feel with a stiffer suspension and an emphasis on
handling and control, along with a more powerful engine tone.
*if equipped14 15
2015 MKT
Lane Keeping System*
This system works to alert drivers
of unintentional lane departures
through the steering system and
instrument cluster display, and
helps drivers steer back into the
appropriate lane.
Turn the feature on and off by
pressing the button on your
center console, in front of
the shifter.
Note: The system is designed to
aid the driver. It is not intended
to replace the driver’s attention
and judgment. The driver is still
responsible to drive with due
care and attention.
Collision Warning System*
This system is designed to alert
the driver of certain collision
risks. Radar sensors detect if
vehicles ahead of you which are
moving in the same direction,
may be a collision risk. The
system alerts you with an audible
tone and red warning light that
appears above the dash. If the
risk of collision increases, the
system increases brake support
to help reduce collision speed.
Function
BLIS® (Blind Spot Information System)
with Cross Traffic Alert (CTA)*
BLIS aids the driver in detecting vehicles that may have entered the
blind spot zone. The cross traffic alert feature is designed to warn
you of vehicles approaching from the sides when the transmission
is in reverse (R). BLIS and cross traffic alert display a yellow indic\
ator
light in your exterior mirrors. The cross traffic alert also sounds tone\
s
and displays messages to warn you from which direction vehicles
are approaching. Refer to the Driving Aids chapter in your Owner’s
Manual for more information.
Note: Visibility aids do not replace the need to watch where
the vehicle is moving. Refer to your Owner’s Manual for safety
information, more details and system limitations.
14
*if equipped
*if equipped
Rear View Camera
This system provides a visual display of the area behind the vehicle. The
display automatically appears in the touchscreen when the vehicle is in reverse
(R) and uses green, yellow and red guides to aler t you of your proximit y
to objects.
Active Park Assist*
The system detects an available parallel parking space and automatically
steers the vehicle into the space (hands-free) while you control the accelerator,
gearshif t and brakes. The system uses visual and audible instructions to help
you park your vehicle.
Reverse Sensing System
This system sounds a warning tone if there is an obstacle near the vehicle’s
rear bumper when the vehicle is in reverse (R) and is traveling less than
3 mph (5 km/h). The warning tone increases in frequency as the object
gets closer.
Note: Visibilit y aids, such as active park assist and reverse sensing system,
do not replace the need to watch where the vehicle is moving. Refer to
your Owner’s Manual for safet y information, more details and
system limitations.
16 16 17
2015 MKT
