2015 LINCOLN MKC navigation system

54
3 Service Engine Soon Light Lights briefly when the ignition is turned
on. If it remains on or is blinking after the engine
is started, the On-Board Diagnostics (OBD-II)
system has detected a malfunction. Drive in a
moderate fashion (avoid heavy acceleration
and deceleration) and contact your authorized
dealer as soon as possible.
4 Right Vehicle Information Display
Displays information about Entertainment,
Climate, Phone and Navigation*. Use the right,
5-way controls located on your steering wheel
to scroll through, highlight and make minor
adjustments within a selected menu. Refer to
the MyLincoln Touch
TM chapter in your Owner’s
Manual for more information.
5 Steering Wheel Controls
Audio
Press VOL +/– to increase/decrease volume
levels. Press SEEK to access the next/previous
radio station preset, CD track or preset satellite
radio channel*

Voice
Press to answer call.
Press
to exit phone mode or end call.
Press
to access voice recognition.
6 Power Tilt/Telescoping Steering Column*
The 4-way rocker control allows you to adjust
the steering wheel to your desired position.

7 Push Button Start
Allows you to start your vehicle by pressing
the ENGINE START STOP button while fully
pressing down on the brake pedal. If your
vehicle has been idling for an extended period
of time, it will automatically shut down. Before
the engine shuts down, a message appears in
the information display, allowing the driver to
override the shutdown feature. Press the button
again to turn the engine off.
Note: Your intelligent access transmitter must
be inside the vehicle for the ignition to start.
Keyless warning alert sounds the horn twice
when you exit the vehicle with the intelligent
access transmitter and the keyless vehicle is
in RUN, indicating the vehicle is still on.
8 Push Button Shift Transmission
Your vehicle is equipped with an electronic
transmission. The shift buttons are located
on the center stack next to the MyLincoln
Touch system.
Putting Your Vehicle in Gear
1. Fully press down the brake pedal.
2. Press and release one of the PRNDS
buttons to select your gear.
3. The gear shift button you select will light
and the information display will show a
telltale of the selected gear.
4. Release the brake pedal and your
transmission will remain in the
selected gear.
Note: When entering an automatic car wash,
always put your vehicle into Stay in Neutral
mode. To put your vehicle in Stay in Neutral
mode, make sure your vehicle is stationary
first and then:
1. Press the neutral (N) button on the shifter
assembly once. The information display
screen will read “Press N to enter Stay in
Neutral mode”.
2. Press N on the shifter assembly again.
The message “Stay in Neutral mode
engaged” will appear in the information
display and the N button will flash
continuously to confirm your selection.
3. To exit Stay in Neutral mode, press
another gear.
Instrument Panel
1 Adaptive Cruise Control* Automatically adjusts your speed to maintain
a set distance between your vehicle and the
vehicle in front of you in the same lane. You can
set the gap distance between your vehicle and
the vehicle in front of you by pressing the

and
buttons on the steering wheel. Note: Driving aids do not replace the need to
watch where the vehicle is moving and brake
where necessary. Refer to the Cruise Control
chapter of your Owner’s Manual for safety
information, more details and limitations.
2 Left Vehicle Information Display
Provides information about various systems on
your vehicle. Use the left, 5-way controls located
on the steering wheel to choose and confirm
settings and messages. Refer to the Information
Displays chapter in your Owner’s Manual for
more information.
Preproduction model shown
*if equipped
2015 MKC
*if equipped

76
SYNC® with MyLincoln TouchTM
Using SYNC with MyLincoln Touch
SYNC is a hands-free, voice recognition system used for entertainment,
information and communication.
Use the four-corner, four-color touchscreen to explore and interact with\
your
vehicle. The touchscreen works the same way traditional controls, knobs \
and
buttons do.
Press the various corners on your touchscreen to personalize the many
features and settings of your vehicle all in one place. The system provi\
des
easy interaction with your cellular phone, multimedia entertainment, cli\
mate
controls and navigation system*.
General Tips
Press the home icon at any time
to return to the home screen.
For additional support, refer to your
Owner’s Manual, visit the website
or call the toll-free number. See the
inside front cover of this guide for
more details.
Before You Get Started
If you have the navigation SD card*,
make sure that it is inserted into the
media port or your navigation will
not work.
The touchscreen is sensitive, so
make sure you press the desired
icon accurately and firmly.
Create Your Owner Account
1. Set up your owner account
at SyncMyRide.com (U.S.) or
SyncMyRide.ca (Canada). Register by
following the on-screen instructions.
After registering, you can see what
complimentary services you are
eligible for.
2. SYNC uses a wireless connection
called
Bluetooth® to communicate
with your phone. Turn Bluetooth
mode on in your phone’s menu
options. This lets your phone
find SYNC. For more details on
setting up your phone with SYNC,
visit SyncMyRide.com (U.S.) or
SyncMyRide.ca (Canada), or your
phone manufacturer’s website.
Why You Need a SYNC
Owner Account
A SYNC owner account gives you
the latest software updates, and if
you have questions, you’ll get free
customer support. Visit the website
or call the toll-free number for more
information. See the inside front cover
of this guide for details.
Pairing Your Phone
with SYNC
1. Make sure that your vehicle is in
park (P) and you switch on your
radio and ignition. Touch Add
Phone in the upper left corner
of the touchscreen. Find SYNC
appears on the screen and
instructs you to begin the pairing
process from your device.
2. Make sure that Bluetooth is set to
ON and that your cellular phone
is in the proper mode. See your
phone’s manual if necessary.
Select SYNC and a six-digit PIN
appears on your device. 3.
If you are prompted to enter a PIN
on your device, it does not support
Secure Simple Pairing. To pair,
enter the PIN displayed on the
touchscreen. Skip the next step.
4. When prompted on your phone’s
display, confirm that the PIN
provided by SYNC matches the PIN
displayed on your cellular phone.
5. The display indicates when the
pairing is successful.
Note: The system may prompt you
to set your phone as the primary/
favorite (the primary phone will receive
messages and voicemail); download
your phone book (this is required to
use the full set of voice commands)
and/or switch on 911 Assist®.
Tips
Make sure you accept the request
from SYNC to access your phone.
To pair subsequent phones, please
refer to Pairing Subsequent
Phones in the MyLincoln Touch
chapter of your Owner’s Manual.
If you are experiencing pairing
problems, try performing a clean
pairing by deleting your services
from SYNC, deleting the SYNC
connection from your phone, and
then repeating the Pairing Your
Phone with SYNC process.
Phone
Voice-control your phone to
connect with many other features:
Connect automatically with a
911 Operator in the event of an
accident (feature must be on
before an event).
Transfer calls seamlessly from
SYNC to phone as you get in or out
of your vehicle.
Refer to the MyLincoln Touch
chapter of your Owner’s Manual
for complete details.
*if equipped*if equipped
2015 MKC

9*if equipped
8
SYNC® with MyLincoln TouchTM
Using Your Phone with SYNC
Note: Enter your phone book contacts
with both first and last names to
increase the ability of SYNC to select
the correct contact. Remember to say
the contact name exactly as it’s listed
in your phone book.
Making a Phone Call
Use SYNC to make a phone call
to anyone in your phone book by
pressing the voice button. When
prompted, give a voice command.
For example, you could say “Call Jake
Smith at home”. SYNC repeats the
command back to you and dials
the number.
Note: You can also make phone
calls by giving the voice command
“Dial”, then verbally saying the
phone number.
Answering Incoming Calls
Whenever you have an incoming
call, you will be able to see the name
and number of the person calling in
your display. Press ACCEPT on the touchscreen or the
phone button
to answer an incoming call.
Ending the Call
Press and hold the phone button.
Do Not Disturb Mode
This feature blocks incoming calls and
text messages, and saves them for
later. You still have access to outgoing
calls when this feature is active. Say
the voice command “Do not disturb
on” to enable, and “Do not disturb
off” to disable.
Navigation*
Get started with your navigation
system by pressing the upper-right,
green corner. The available, voice
activated navigation system includes:
SiriusXM Traffic
SiriusXM Travel Link
GPS (Global Positioning System)
technology
3-D mapping
Turn-by-turn navigation
Note: Some features may require
activation. Refer to the MyLincoln
Touch chapter of your Owner’s
Manual for more details.
Set a Destination
Set a destination on your touchscreen
by using a street address, city center,
a place on the map or a point of
interest (POI). The easiest way,
however, is by voice.
1. Press the voice button. When
prompted, say “Destination
street address”.
2. The system will ask you to say the
full address and will display an
example on-screen.
3. You can then speak the address
naturally, such as: “One two three
Main Street, Anytown”. You can also use the touchscreen to
enter a destination and narrow your
choices by city or street as you type.
You can choose from up to three
different types of routes:

Fastest: Uses the fastest moving
roads possible.
Shortest: Uses the shortest
distance possible.
Eco (EcoRoute): Uses the most fuel
efficient route.
Tips
Save your favorite locations by
touching “Save to Favorites”.
Change your map views from
Heading-up, North-up or 3D.
Climate

Control the temperature, airflow
direction, fan speed and other climate
features for you and your front
passenger. Say “Climate temperature
72 degrees” and MyLincoln Touch
will make the adjustment.
Set Your Temperature
Touch the lower-right, blue Climate
corner on the touchscreen.
Set your exact, desired
temperature by using the
+ or – buttons.
Entertainment
No matter how you store your
music, SYNC makes it yours
to enjoy when you’re behind the
wheel. Just press the lower-left, red
corner of the touchscreen. From here,
you can easily go between AM/FM,
SiriusXM and other media sources.
Set Your Radio Presets
Touch the Entertainment corner on
the touchscreen.
Touch FM.
Touch Direct Tune.
Enter the desired station and
touch Enter.
Touch Presets and then touch and
hold one of the memory preset
buttons to save it. You’ll hear a
brief mute and the sound will return
once the station is saved.
Using SYNC to Access
Digital Media
SYNC has a media hub with multiple
inputs, allowing you to access
personal media from your digital
devices. Plug in your USB media
devices, such as phones and MP3
players, and use SYNC
to play all of your favorite music.
Note: SYNC indexes your music; the
more information that is stored on your
USB device, the longer it takes SYNC
to index.
Using Voice Commands
to Play Music
1. Plug your media player into your
USB port.
2. Press the voice button
.
When prompted, say “USB”,
then follow up by saying a
voice command.
For more information, refer to the
MyLincoln Touch chapter of your
Owner’s Manual. For support, visit the
website or call the toll-free number.
See the inside front cover of this guide
for details.
2015 MKC