2015 LEXUS LX570 brake

2992-4. Using other driving systems
2
When driving
LX570_OM_OM60L96U_(U) CAUTION■
When using the Lexus parking assist monitor system
The parking assist monitor system is a supp lemental device intended to assist the
driver when backing up. When backing up, be sure to check visually behind and all
around the vehicle before proceeding.
Observe the following precautions to avoid an accident that could result in death or
serious injuries. ●
Never depend on the parking assist mo nitor entirely when backing up. The
image and the position of the guide lines displayed on the screen may differ from
the actual state.
Use caution, just as you would when backing up any vehicle. ●
Be sure to back up slowly, depressing the brake pedal to control vehicle speed.●
If you seem likely to hit nearby vehicles, obstacles, people or mount the shoulder,
depress the brake pedal to stop the vehi cle, then disable the assist system by
touch
on the screen to cancel the system.●
The instructions given are only guidelines.
When and how much to turn the steering wheel will vary according to traffic con-
ditions, road surface conditions, vehicle co ndition, etc. when parking. It is neces-
sary to be fully aware of this befo re using the parking assist system. ●
When parking, be sure to check that the parking space will accommodate your
vehicle before maneuvering into it. ●
Do not use the Lexus parking assist monitor system in the following cases:
• On icy or slick road surfaces, or in snow
• When using tire chains
• When the back door is not closed completely
• On roads that are not flat or stra ight, such as curves or slopes.

3272-4. Using other driving systems
2
When driving
LX570_OM_OM60L96U_(U) ■
Automatic leveling function
The vehicle is adjusted to a fixed height for each mode, regardless of the number of
occupants and the luggage load. ●
However the vehicle cannot be raised if the vehicle load exceeds the following
limits:
• Up to 4 occupants
* plus approximately 661 lb. (300 kg) in the normal mode
• Up to 4 occupants
* plus approximately 441 lb. (200 kg) in the high mode
* : average weight 150 lb. (68 kg) per person●
If the vehicle height cannot be raised when in the normal mode, and “LO”
appears on the display, the vehicle is loaded too heavily. Take extra care when
driving in this condition.
If the vehicle height cannot be raised ev en after unloading the vehicle, pull the
height select switch to “  ” then push to “  ”. If the vehicle height still cannot be
raised, turn the ignition off then on again, then try once more.■
When the vehicle is st opped during driving
The activation of the automatic leveling function may cause the vehicle height to
change. This is not a malfunction. ■
If the vehicle height does not change
If the vehicle is loaded too heavily, or the undercarriage has come into contact with
the road surface, the vehicle height cannot be raised/lowered. ■
In the following cases the 4-Wheel AHC will not operate ●
The brake pedal has been depressed for a few seconds or longer while the vehi-
cle is stopped. ●
Vehicle height control has not been frequently used. ●
The suspension fluid temperature is lower than -22°F (-30°C). ●
There is ice on the suspension. ●
Driving on bumpy roads which may caus e the suspension to fully elongate.●
If the steering wheel is abruptly turned more than 3/4 of a revolution with the
center differential lock system activated.

3342-4. Using other driving systems
LX570_OM_OM60L96U_(U) ■
Advice for driving on slippery roads ●
If you shift the four-wheel drive control switch to “L4” and the shift lever to the
“2” range of “S” or “D” (vehicles with paddle shift switches) while driving in
steep off-road areas, the output of the brake can be controlled effectively by the
Active TRAC, which assists the driver to control the driving power of 4 wheels. ●
Use the “1” range of “S” or “D” (vehicles with paddle shift switches) of the shift
lever for maximum power and traction wh en your wheels get stuck or when
driving down a steep incline.■
The center differential lock indicator light
The indicator light blinks while lock ing/unlocking the center differential.■
The center differential lock/unlock switch can be operated when ●
The “ENGINE START STOP” switch is in IGNITION ON mode.●
The vehicle speed is less than 60 mph (100 km/h).■
Locking/unlocking the center differential ●
When the four-wheel drive control switch is in L4 with the center differential
locked, VSC is automatically turned off. (The center differential lock and VSC
OFF indicator lights come on.) ●
If the operation is not completed, the center differential lock indicator blinks. If
the indicator light does not turn off when unlocking the center differential, drive
straight ahead while accelerating or decelerating, or drive in reverse. ●
If the center differential lock/unlock is not completed within 5 seconds while
the cruise control system is on, cancel the cruise control system.

3352-4. Using other driving systems
2
When driving
LX570_OM_OM60L96U_(U) ■
If the low speed four-wheel drive indicato r light or the center differential lock
indicator light blinks ●
If the low speed four-wheel drive indicat or light continues to blink when using
the four-wheel drive control switch, stop the vehicle completely, move the shift
lever to “N” and operate the switch again. ●
If the shift lever is moved before the low speed four-wheel drive indicator turns
on/off, the transfer mode may not be shifted comple tely. The transfer mode dis-
engages both the front and rear driveshafts from the powertrain and allows the
vehicle to move regardless of the shift po sition. (At this time, the indicator blinks
and the buzzer sounds.)
Therefore, the vehicle is free to roll even if the automatic transmission is in “P”.
You or someone else could be seriously injured. You must complete the shifting
of the transfer mode.
To complete the shifting, stop the vehicle completely, return the shift lever to “N”,
and confirm that the shift was comp leted (the indicator turns on/off).●
If the engine coolant temperature is t oo low, the four-wheel drive control sys-
tem may not be able to shift. When the engine is warmer operate the switch
again.
If the low speed four-wheel drive indicator li ght or the center diff erential lock indi-
cator light continues to blink even after attempting the above, there may be a mal-
function in the engine, the brake system or the four-wheel drive system. In this case,
you may not be able to shift between “H4” and “L4”, and the center differential lock
may not be operable. Have the vehicle in spected by your Lexus dealer immedi-
ately.

3412-4. Using other driving systems
2
When driving
LX570_OM_OM60L96U_(U) ■
The Crawl Control and Turn Assist function can be operated when
Crawl Control ●
The engine is running. ●
The shift lever is in any gear other than “P” or “N”. ●
The four-wheel drive control switch is in “L4”. ●
The driver’s door is closed.
Turn Assist function ●
Crawl Control is operating. ●
The center differential is not locked. ●
The accelerator and brake are not being operated. ●
The shift lever is in any gear other than “P”, “R” or “N”. ●
The steering wheel is turned very far.■
Automatic system cancelation
Crawl Control
In the following situations, the buzzer will sound intermittently and Crawl Control
will be canceled automatically. In this ev ent, the Crawl Control indicator will flash
and then go off, the Turn Assist indicator will go off (if the Turn Assist function is in
use), and a message stating that Crawl Control has been turned off will be dis-
played on the multi-information display for several seconds. ●
When the shift lever is moved to “P” or “N”. ●
When the four-wheel drive control switch is in “H4”. ●
When the driver’s door is opened.
Turn Assist function
When the center differential is locked, the buzzer will sound intermittently and the
Turn Assist function will be canceled au tomatically. In this event, the Turn Assist
indicator will go off, and a message statin g that the Turn Assi st function has been
turned off will be displayed on the multi-information display for several seconds.

3422-4. Using other driving systems
LX570_OM_OM60L96U_(U) ■
Function limitations
Crawl Control ●
In the following situations, brake control can be used to drive downhill at a con-
stant speed. However, engine control is not available when driving uphill at a
constant speed.
• When switched to second start mode. ●
In the following situation, engine contro l and brake control will stop temporarily.
In this event, the Crawl Control indicator will flash.
• When the vehicle speed exceeds approximately 15 mph (25 km/h).
Turn Assist function
In the following situations, the Turn Assist function will stop temporarily. In this
event, the Turn Assist indicator will flash. ●
When the vehicle speed exceeds approximately 6 mph (10 km/h). ●
When the shift lever is moved to “R”.■
When the Crawl Control system is operated continuously ●
If Crawl Control is used continuously for a long time, the buzzer will sound, a
malfunction notification will be displaye d on the multi-information display, the
Crawl Control indicator will go off, and Crawl Control will be temporarily inop-
erable as a result of the brake system overheating. In this event, stop the vehicle
immediately in a safe place, and allow th e brake system to cool down sufficiently
until the “TRAC OFF” on the multi-information display goes off. (In the mean-
time, normal driving is possible.) ●
If Crawl Control is used continuously for a long time, the buzzer will sound, the
system will be temporarily canceled, and a malfunction notification will be dis-
played on the multi-informat ion display as a result of the automatic transmission
system overheating. Stop the vehicle in a safe place until the display goes off.

3442-4. Using other driving systems
LX570_OM_OM60L96U_(U) Multi-terrain Select Multi-terrain Select is a system that as sists drivability in off-road situations.
Select a mode that most clos ely matches the type of terrain on
which you are driving from among 5 modes.
Brake control can be optimized in accordance with the selected
mode.
Multi-terrain Select mode
select switch
Multi-information display
Displays status information
including operating status
and road type selection.
Multi-terrain Select indicator

3482-4. Using other driving systems
LX570_OM_OM60L96U_(U) ■
When the vehicle is stuck
Switching the transfer and differential
For the operation of the following func tions, refer to the following pages.●
Four-wheel drive system (  P. 332)●
Center differential lock (  P. 332)■
When the brake system operates continuously
The brake system may overheat. In this case, a buzzer will sound, the “TRAC OFF”
will be displayed on the multi-information display, and Multi-terrain Select will be
temporarily inoperable. In this event, stop the vehicle immediately in a safe place,
and allow the brake system to cool down sufficiently. (There is no problem with
continuing normal driving.)
After a short time, the message on the multi-information display will go off, and you
will be able to use Multi-terrain Select. ■
When there is a malfunction in the system
The slip indicator light will come on. Have the vehicle inspected by your Lexus
dealer immediately.
CAUTION■
When using the Multi-terrain Select
Observe the following precautions to avoid an accident that could result in death or
serious injuries: ●
There is a chance that the selected mode may not be the most appropriate in
terms of road conditions such as pi tch, slipperiness, undulation, etc. (  P. 345)●
Multi-terrain Select is not intended to expand the limits of the vehicle. Check the
road conditions thoroughly beforeha nd, and drive safely and carefully.
NOTICE■
Precaution for use
The Multi-terrain Select is intended for use during off-road driving. Do not use the
system at any other time.