2015 LEXUS LX570 steering

851-3. Adjustable components (s eats, mirrors, steering wheel)
1
Before driving
LX570_OM_OM60L96U_(U) Using the door lock switch
Carry only the key (including the ca rd key) to which you want to link
the driving position. If 2 or more ke ys are in the vehicle, the driving
position cannot be linked properly.
Turn the “ENGINE START STOP ” switch to OFF after closing
the driver’s door.
While pressing the desired button
(“1”, “2” or “3”), press the lock or
unlock side on the door lock
switch (either the driver or passen-
ger side) until the signal beeps. The driving position is recalled
when the driver’s door is unlocked
using the entry function or wireless
remote control and the driver’s
door is opened.STEP 1
STEP 2
■
Canceling the linked door unlock operation
Turn the “ENGINE START STOP” sw itch to OFF after closing the
driver’s door.
Using the wireless remote control: While pressing “SET” button, press
button on the wireless remote control until the signal beeps.
Using the door lock switch: While pre ssing “SET” button, press the lock or
unlock side on the door lock switch until the signal beeps.STEP 1
STEP 2

861-3. Adjustable components (s eats, mirrors, steering wheel)
LX570_OM_OM60L96U_(U) ■
Retained accessory power ●
Each memorized position (except for the steering wheel position) can be acti-
vated within 3 minutes after the driver’s door is opened, even if the “ENGINE
START STOP” switch is turned off. ●
Each memorized position (except for the steering wheel position) can be acti-
vated within 60 seconds after the driver’s door is closed, even if the “ENGINE
START STOP” switch is turned off.■
To cancel seat position recall
Perform any one of the following operations. ●
Press the “SET” button ●
Press button “1”, “2” or “3”. ●
Adjust the seat using the switches (only cancels seat position recall)●
Adjust the steering wheel using the tilt and telescopic steering control switch
(only cancels steering wheel position recall) ■
If the battery is disconnected
The memorized positions must be reset because the computer’s memory is erased
when the battery is disconnected.
CAUTION■
Seat adjustment caution
Take care during seat adjustment that the seat does not strike the rear passenger or
squeeze your body against the steering wheel.

8711-3. Adjustable components (seats, mirrors, steering wheel)
Before driving
LX570_OM_OM60L96U_(U) Head restraints Head restraints are provided for all seats.
Front seats
Vertical adjustment
Up
Down Push the head restraint up or
down while pressing the lock
release button.
Angle adjustment (if equipped)
Second seats
Vertical adjustment
Up Pull the head restraints up.
Down Push the head restraint down
while pressing the lock release
button.Lock release button
Lock release button

881-3. Adjustable components (s eats, mirrors, steering wheel)
LX570_OM_OM60L96U_(U) ■
Adjusting the height of the head restraints
■
Adjusting the second center seat head restraint
Always raise the head restraint one leve l from the stowed po sition when using.Third outboard seats
To fold Pull the head restraint angle
lever to fold the head restraint.
Make sure that the head restraints are
adjusted so that the center of the head
restraint is closest to the top of your ears.

891-3. Adjustable components (s eats, mirrors, steering wheel)
1
Before driving
LX570_OM_OM60L96U_(U) ■
Removing the head restraints
Front seats
While pressing in the flathead screwd river, pull up th e head restraint.
Second seats
Third center seat
Third outboard seats
The head restraint cannot be removed. Push a flathead screwdriver into the slot. The
slot is located on the right side of the right
head restraint anchor.STEP 1
STEP 2
Pull the head restraint up while pressing the
lock release button.
Lock release button
Pull the head restraint up while pressing the
lock release button.Lock
release
button

901-3. Adjustable components (s eats, mirrors, steering wheel)
LX570_OM_OM60L96U_(U) ■
Installing the head restraints (except third outboard seats)
Align the head restraint with the installation holes.
Push down the head restra int to the lock position.■
When not using the third center seat head restraint
CAUTION■
Head restraint precautions
Observe the following precautions regardin g the head restraints . Failure to do so
may result in death or serious injury. ●
Use the head restraints designed for each respective seat. ●
Adjust the head restraints to th e correct position at all times.●
After adjusting the head rest raints, push down on them and make sure they are
locked in position. ●
Do not drive with the head restraints removed. STEP 1
STEP 2
Open the zipper on the back of the third seat
and stow the head restraint inside.

9111-3. Adjustable components (seats, mirrors, steering wheel)
Before driving
LX570_OM_OM60L96U_(U) Seat belts Make sure that all occupants are wear ing their seat belts before driving
the vehicle.
■ Correct use of the seat belts
● Extend the sh oulder belt so
that it comes fully over the
shoulder, but does not come
into contact with the neck or
slide off the shoulder.
● Position the lap belt as low as
possible over the hips.
● Adjust the position of the
seatback. Sit up straight and
well back in the seat.
● Do not twist the seat belt.
■ Fastening and releasing the seat belt
Fastening the belt Push the tab into the buckle until
a clicking sound is heard.
Releasing the belt Press the release button.
Release button

921-3. Adjustable components (s eats, mirrors, steering wheel)
LX570_OM_OM60L96U_(U) ■ Fastening and releasing th e third center seat belt
Pull out the tab
Push tab B into buckle B until a
clicking sound is heard
Push tab A into buckle A until a
clicking sound is heard To release, push the release but-
ton on buckle A.STEP 1
STEP 2
Tab B
Buckle BSTEP 3
Tab A
Release button
Buckle A