2015 LEXUS LX570 ECU

1561-7. Safety information
LX570_OM_OM60L96U_(U) ■ Forward-facing  Convertible seat
Fold the seatback while pulling the
seatback angle lever. Return the
seatback and secure it at the first
lock position. (  P. 71)
Place the child restraint system on
the seat facing the front of the
vehicle.
Run the seat belt through the child
restraint system and insert the
plate into the buckle. Make sure
that the belt is not twisted.STEP 1
STEP 2
STEP 3

1571-7. Safety information
1
Before driving
LX570_OM_OM60L96U_(U) Fully extend the shoulder strap
and then allow it to retract slightly
into the ALR lock mode. Lock mode allows the seat belt to
retract only.
While pushing the child restraint
system into the second seat, allow
the shoulder belt to retract until
the child restraint system is
securely in place. After the shoulder belt has
retracted to a point where there is
no slack in the belt, pull the belt to
check that it cannot be extended.
If the child restraint system has a top tether strap, the top tether
strap should be latched onto the top tether strap anchor.
(  P. 152) STEP 4
STEP 5
STEP 6

1581-7. Safety information
LX570_OM_OM60L96U_(U) ■ Booster seat
Fold the seatback while pulling the
seatback angle lever. Return the
seatback and secure it at the first
lock position.
Place the child restraint system on
the seat facing the front of the
vehicle.
Sit the child in the child restraint
system. Fit the seat belt to the child
restraint system according to the
manufacturer’s instructions and
insert the plate in to the buckle.
Make sure that the belt is not
twisted. Check that the shoulder belt is cor-
rectly positioned over the child’s
shoulder, and that the lap belt is as
low as possible. (  P. 91)STEP 1
STEP 2
STEP 3

1591-7. Safety information
1
Before driving
LX570_OM_OM60L96U_(U) Removing a child restraint system installed with a seat belt
Push the buckle release button
and fully retract the seat belt.
Child restraint systems with a top tether strap
Secure the child restraint system using a seat belt or LATCH
anchors, and do the following.
Outside
Adjust the head restraint to the
upmost position.
Center
Lower the head restraint to the
lowest position.STEP 1

1601-7. Safety information
LX570_OM_OM60L96U_(U) Open the anchor bracket cover, latch the hook onto the anchor
bracket and tighten the top tether strap.
Outside
Make sure the top tether strap is
securely latched.
Center
Outside only: Adjust the head
restraint to the downmost position.STEP 2
STEP 3

1611-7. Safety information
1
Before driving
LX570_OM_OM60L96U_(U) ■
Laws and regulations pertaining to Anchors
The LATCH system conforms to FMVSS225 or CMVSS210.2.
Child restraint systems conforming to FMVSS213 or CMVSS213 specifications
can be used.
This vehicle is designed to conform to the SAE J1819.
CAUTION■
When installing a booster seat
Do not fully extend the shoulder belt to prevent the belt from going to ALR lock
mode: (  P. 95)
ALR mode causes the belt to tighten only which could cause injury or discomfort to
the child. ■
When installing a child restraint system
Follow the directions given in the child restraint system installation manual and fix
the child restraint syst em securely in place.
If the child restraint system is not correctly fixed in place, the child or other passen-
gers may be seriously injured or even kill ed in the event of sudden braking, sudden
swerving or an accident. ●
If the driver’s seat interferes with the child
restraint system and prevents it from being
attached correctly, attach the child
restraint system to the right-hand second
seat. ●
Child restraint system installed on the third
seat should not contact the second seat-

1621-7. Safety information
LX570_OM_OM60L96U_(U) CAUTION■
When installing a child restraint system
●
When using the LATCH anchors for a child restraint system, move the seat as far
back as possible, with the seatback close to the child restraint system. ●
When a booster seat is installed, always ensure that the shoulder belt is posi-
tioned across the center of the child’s shoulder. The belt should be kept away
from the child’s neck, but not so that it could fall off the child’s shoulder. Failing to
do so may result in death or serious inju ry in the event of su dden braking, sudden
swerving or an accident. ●
Ensure that the belt and tab are securely locked and the seat belt is not twisted.●
Shake the child restraint sy stem left and right, and forward and backward to
ensure that it has be en securely installed.●
After securing a child restraint system, never adjust the seat.●
Follow all installation instructions provid ed by the child rest raint system manufac-
turer. ●
Only put a forward-facing child restraint
system on the front seat when unavoidable.
When installing a forward-facing or
booster child restrain t on the front passen-
ger seat, move the seat as far back as pos-
sible even if the AIR BAG OFF indicator
light illuminates. Failing to do so may result
in death or serious injury if the airbags
deploy (inflate).

1631-7. Safety information
1
Before driving
LX570_OM_OM60L96U_(U) CAUTION■
Do not use a seat belt extender
If a seat belt extender is used when inst alling a child restraint system, the seat belt
will not securely hold the child restraint system, which could cause death or serious
injury to the child or other passengers in the event of sudden braking, sudden
swerving or an accident. ■
To correctly attach a child restraint system to the anchors
When using the LATCH anchors, be sure that there are no foreign objects around
the anchors and that the seat belt is no t caught behind the child restraint system.
Make sure the child restraint system is se curely attached, or it may cause death or
serious injury to the child or other passe ngers in the event of a sudden stop, sudden
swerve or accident.