2015 LEXUS LX570 child seat

1501-7. Safety information
LX570_OM_OM60L96U_(U) CAUTION■
Child restraint precautions ●
Do not allow the child to lean his/her head or any part of his/her body against the
door or the area of the seat, front and rear pillars or roof side rail from which the
side airbags or curtain shield airbags deploy even if the child is seated in the child
restraint system. It is dangerous if the side airbags and curtain shield airbags
inflate, and the impact could cause de ath or serious injury to the child.●
Make sure you have complied with all installation instructions provided by the
child restraint manufacturer and that the system is properly secured. If it is not
secured properly, it may cause death or seri ous injury to the child in the event of a
sudden stop, sudden swerving or accident.■
When children are in the vehicle
Do not allow children to play with the se at belt. If the seat belt becomes twisted
around a child’s neck, it may lead to choking or other serious injuries that could
result in death.
If this occurs and the buckle cannot be unfastened, scissors should be used to cut
the belt. ■
When the child restraint system is not in use ●
Keep the child restraint system properly se cured on the seat even if it is not in
use. Do not store the restraint unsecured in the passenger compartment. ●
If it is necessary to detach the child restraint system, remove it from the vehicle or
store it securely in the luggage compartment. This will prevent it from injuring
passengers in the event of a sudden stop, sudden swerve or accident.

15111-7. Safety information
Before driving
LX570_OM_OM60L96U_(U) Installing child restraints Follow the child restraint system manufacturer’s instructions. Firmly
secure the child restraints to the ou tboard second seats using the LATCH
anchors or a seat belt. Attach the to p tether strap when installing a child
restraint.
The lap/shoulder belt can be used if your child restraint system is not com-
patible with the LATCH (Lower Anch ors and Tethers for Children) system.
Child restraint LATCH anchors
LATCH anchors are provided
for the outboard second seats.
(Buttons display ing the location
of the anchors are attached to
the seats.)
Seat belts equipped with a child
restraint locking mechanism
(ALR/ELR belts except driver’s
seat belt)
Anchor bracket (for top tether
strap) Anchor brackets are provided
for all second seats.

1541-7. Safety information
LX570_OM_OM60L96U_(U) Installing child restraints using a se at belt (child restraint lock function
belt)
■ Rear-facing  Infant seat/Convertible seat
Fold the seatback while pulling the
seatback angle lever. Return the
seatback and secure it at the first
lock position. (  P. 71)
Place the child restraint system on
the second seat facing the rear of
the vehicle.
Run the seat belt through the child
restraint system and insert the
plate into the buckle. Make sure
that the belt is not twisted.STEP 1
STEP 2
STEP 3

1551-7. Safety information
1
Before driving
LX570_OM_OM60L96U_(U) Fully extend the sh oulder belt and
then allow it to retract slightly in
order to activate the ALR lock
mode. Lock mode allows the seat belt to
retract only.
While pushing the child restraint
system down into th e second seat,
allow the shoulder belt to retract
until the child restraint system is
securely in place. After the shoulder belt has
retracted to a point where there is
no slack in the belt, pull the belt to
check that it cannot be extended. STEP 4
STEP 5

1561-7. Safety information
LX570_OM_OM60L96U_(U) ■ Forward-facing  Convertible seat
Fold the seatback while pulling the
seatback angle lever. Return the
seatback and secure it at the first
lock position. (  P. 71)
Place the child restraint system on
the seat facing the front of the
vehicle.
Run the seat belt through the child
restraint system and insert the
plate into the buckle. Make sure
that the belt is not twisted.STEP 1
STEP 2
STEP 3

1571-7. Safety information
1
Before driving
LX570_OM_OM60L96U_(U) Fully extend the shoulder strap
and then allow it to retract slightly
into the ALR lock mode. Lock mode allows the seat belt to
retract only.
While pushing the child restraint
system into the second seat, allow
the shoulder belt to retract until
the child restraint system is
securely in place. After the shoulder belt has
retracted to a point where there is
no slack in the belt, pull the belt to
check that it cannot be extended.
If the child restraint system has a top tether strap, the top tether
strap should be latched onto the top tether strap anchor.
(  P. 152) STEP 4
STEP 5
STEP 6

1581-7. Safety information
LX570_OM_OM60L96U_(U) ■ Booster seat
Fold the seatback while pulling the
seatback angle lever. Return the
seatback and secure it at the first
lock position.
Place the child restraint system on
the seat facing the front of the
vehicle.
Sit the child in the child restraint
system. Fit the seat belt to the child
restraint system according to the
manufacturer’s instructions and
insert the plate in to the buckle.
Make sure that the belt is not
twisted. Check that the shoulder belt is cor-
rectly positioned over the child’s
shoulder, and that the lap belt is as
low as possible. (  P. 91)STEP 1
STEP 2
STEP 3

1591-7. Safety information
1
Before driving
LX570_OM_OM60L96U_(U) Removing a child restraint system installed with a seat belt
Push the buckle release button
and fully retract the seat belt.
Child restraint systems with a top tether strap
Secure the child restraint system using a seat belt or LATCH
anchors, and do the following.
Outside
Adjust the head restraint to the
upmost position.
Center
Lower the head restraint to the
lowest position.STEP 1