2015 LEXUS LX570 seats

771-3. Adjustable components (s eats, mirrors, steering wheel)
1
Before driving
LX570_OM_OM60L96U_(U) ■ Folding up the third seats
Perform following steps in “Before folding the third seats”.
(  P. 75)
If the switch is pressed and held,
the seat will automatically fold and
lift sideward. (The buzzer sounds
twice when the seat is about to lift.) If the switch is released while the
seat is lifting sideward, operation
will stop and a buzzer will sound
continuously.
Before operating, make sure that
the handle on the rear of the seat-
back is secure.
Remove the seat hook covers
from the underside of the seat
cushion, and install them on the
seat hooks.STEP 1
STEP 2
STEP 3

781-3. Adjustable components (s eats, mirrors, steering wheel)
LX570_OM_OM60L96U_(U) ■ Returning the third seats
Remove the seat hook covers
from the floor and install them into
the underside of the seat cushion.
If the switch is held down the seat
will automatically return to the
folding position. (Buzzer sounds
twice) If the switch is released while
returning to the folding position,
operation will stop and a buzzer
will sound continuously.
Pull the handle and raise the seat-
backs. Fix the handle securely in its origi-
nal position after use.
Raise the head restraints.STEP 1
STEP 2
STEP 3
STEP 4

821-3. Adjustable components (s eats, mirrors, steering wheel)
LX570_OM_OM60L96U_(U) CAUTION■
Seat adjustment
Do not recline the seat mo re than necessary when the vehicle is in motion to
reduce the risk of slid ing under the lap belt.
If the seat is too reclined, during an accide nt the lap belt may slide past the hips and
apply restraint forces directly to the a bdomen or your neck may contact the shoul-
der belt, increasing the risk of death or serious injury.■
When the seatback is folded ●
Do not sit on or place anything on the seatback while driving.●
Be sure to install the seat hook covers on the seat hooks, or you may get burned
when they become hot.■
When returning the seatbacks to their original position
Observe the following precauti ons. Failure to do so may result in death or serious
injury. ●
Be careful not to get your hand s or feet pinched in the seat.●
Make sure the seats are secu rely locked. Failure to do so will prevent the seat
belt from operating properly. ●
Check that the seat belts are not twisted or caught under the seat. ●
Arrange the seat belts in the proper positions for ready use.■
Avoiding damage to seat components
Do not hang or attach anything on the seatback striker.
NOTICE■
Before tumbling, folding up the seats
The seat belts and buckles must be stowed. ■
After returning the third seat
Make sure that the handle on the rear of the seatback has been secured.

8311-3. Adjustable components (seats, mirrors, steering wheel)
Before driving
LX570_OM_OM60L96U_(U) Driving position memory system Your preferred driving position (the po sition of the driver’s seat, steering
wheel and outside rear view mirrors) can be entered into the computer’s
memory and recalled with the touch of a button. It is also possible to set this
function to activate automatica lly when the doors are unlocked.
Three different driving positions can be entered into memory.
■ Entering a position to memory
Turn the “ENGINE START STOP” switch to IGNITION ON
mode.
Adjust the driver’s seat, steering wheel, and outside rear view
mirrors to the desired positions.
While pressing the “SET” but-
ton, or within 3 seconds after
the “SET” button is pressed,
press and hold button “1”, “2” or
“3” until the signal beeps. If the selected button has
already been preset, the previ-
ously recorded position will be
overwritten.
■ Recalling the memorized position
Check that the shift lever is set in “P”.
Turn the “ENGINE START STOP” switch to IGNITION ON
mode.
Press button “1”, “2” or “3” to
recall the desired position.STEP 1
STEP 2
STEP 3
STEP 1
STEP 2

8711-3. Adjustable components (seats, mirrors, steering wheel)
Before driving
LX570_OM_OM60L96U_(U) Head restraints Head restraints are provided for all seats.
Front seats
Vertical adjustment
Up
Down Push the head restraint up or
down while pressing the lock
release button.
Angle adjustment (if equipped)
Second seats
Vertical adjustment
Up Pull the head restraints up.
Down Push the head restraint down
while pressing the lock release
button.Lock release button
Lock release button

881-3. Adjustable components (s eats, mirrors, steering wheel)
LX570_OM_OM60L96U_(U) ■
Adjusting the height of the head restraints
■
Adjusting the second center seat head restraint
Always raise the head restraint one leve l from the stowed po sition when using.Third outboard seats
To fold Pull the head restraint angle
lever to fold the head restraint.
Make sure that the head restraints are
adjusted so that the center of the head
restraint is closest to the top of your ears.

891-3. Adjustable components (s eats, mirrors, steering wheel)
1
Before driving
LX570_OM_OM60L96U_(U) ■
Removing the head restraints
Front seats
While pressing in the flathead screwd river, pull up th e head restraint.
Second seats
Third center seat
Third outboard seats
The head restraint cannot be removed. Push a flathead screwdriver into the slot. The
slot is located on the right side of the right
head restraint anchor.STEP 1
STEP 2
Pull the head restraint up while pressing the
lock release button.
Lock release button
Pull the head restraint up while pressing the
lock release button.Lock
release
button

901-3. Adjustable components (s eats, mirrors, steering wheel)
LX570_OM_OM60L96U_(U) ■
Installing the head restraints (except third outboard seats)
Align the head restraint with the installation holes.
Push down the head restra int to the lock position.■
When not using the third center seat head restraint
CAUTION■
Head restraint precautions
Observe the following precautions regardin g the head restraints . Failure to do so
may result in death or serious injury. ●
Use the head restraints designed for each respective seat. ●
Adjust the head restraints to th e correct position at all times.●
After adjusting the head rest raints, push down on them and make sure they are
locked in position. ●
Do not drive with the head restraints removed. STEP 1
STEP 2
Open the zipper on the back of the third seat
and stow the head restraint inside.