Page 562 of 654

5617-2. Steps to take in an emergency
GS450h_OM_OM30F70U_(U)
7
When trouble arises
■Stopping the hybrid system
Shift the shift lever to P and press the power switch as you normally do when stop-
ping the hybrid system.
■Replacing the key battery
As the above procedure is a temporary measure, it is recommended that the elec-
tronic key battery be replaced immediately when the battery is depleted. (→P. 460)
■Changing power switch modes
Release the brake pedal and press the power switch in step above.
The hybrid system does not start and modes will be changed each time the switch is
pressed.( →P. 1 9 4 )
■When the electronic key does not work properly
●Make sure that the smart access system with push-button start has not been deac-
tivated in the customization setting. If it is off, turn the function on.
(Customizable features: →P. 599)
●Check if battery-saving mode is set. If it is set, cancel the function. ( →P. 129)
CAUTION
■When using the mechanical key and operating the power windows and moon
roof
Operate the power window or moon roof after checking to make sure that there is
no possibility of any passenger having any of their body parts caught in the window
or moon roof.
Also, do not allow children to operate the mechanical key. It is possible for children
and other passengers to get caught in the power window or moon roof.
3
GS450h_OM_OM30F70U_(U).book Page 561 Monday, January 19, 2015 9:34 AM
Page 568 of 654

5677-2. Steps to take in an emergency
GS450h_OM_OM30F70U_(U)
7
When trouble arises
The coolant level is satisfactory if it is between the “FULL” and
“LOW” lines on the reservoir.Reservoir
“FULL”
“LOW”
Coolant inlet cap
Add coolant if necessary.
(→ P. 569)
Water can be used in an emer-
gency if engine coolant is unavail-
able.
Start the hybrid system and turn the air conditioning system on to
check that the radiator cooling fans operate and to check for coolant
leaks from the radiator or hoses.
The fans operate when the air conditioning system is turned on immediately
after a cold start. Confirm that the fans are operating by checking the fan
sound and air flow. If it is difficult to check these, turn the air conditioning sys-
tem on and off repeatedly. (The fans may not operate in freezing tempera-
tures.)
If the fans are not operating:
Stop the hybrid system immediatel y and contact your Lexus dealer.
If the fans are operating:
Have the vehicle inspected at the nearest Lexus dealer.
4
1
2
3
4
5
6
7
GS450h_OM_OM30F70U_(U).book Page 567 Monday, January 19, 2015 9:34 AM
Page 570 of 654
5697-2. Steps to take in an emergency
GS450h_OM_OM30F70U_(U)
7
When trouble arises
Start the hybrid system and check for the multi-information display.
If the message does not disappear:
Stop the hybrid system and contact your Lexus dealer.
If the message is not displayed:
Have the vehicle inspected at the nearest Lexus dealer.
■When adding coolant
Add coolant in accordance with the following procedure.
Remove caps A and B.
Add coolant through the inlet of cap A up to the B-line, and then
install cap A.
Add coolant through the inlet of cap B until it is full, and then install
cap B.
Cap A
Cap B
B-line (Target fill line)
6
1
2
3
1
2
3
GS450h_OM_OM30F70U_(U).book Page 569 Monday, January 19, 2015 9:34 AM
Page 571 of 654

5707-2. Steps to take in an emergency
GS450h_OM_OM30F70U_(U)
CAUTION
■When inspecting under the hood of your vehicle
Observe the following precautions.
Failure to do so may result in serious injury such as burns.
●If steam is seen coming from under the hood, do not open the hood until the
steam has subsided. The engine compartment may be very hot.
●After the hybrid system has been turned off, check that the indicator on the
power switch and the “READY” indicator are off.
When the hybrid system is operating, the gasoline engine may automatically
start, or the cooling fan may suddenly operate even if the gasoline engine stops.
Do not touch or approach rotating parts such as the fan, which may lead to fin-
gers or clothing (especially a tie, a scarf or a muffler) getting caught, resulting in
serious injury.
NOTICE
■When adding engine/power control unit coolant
Add coolant slowly after the hybrid system has cooled down sufficiently. Adding
cool coolant to a hot hybrid system too quickly can cause damage to the hybrid
system.
■To prevent damage to the cooling system
Observe the following precautions:
●Avoid contaminating the coolant with foreign matter (such as sand or dust etc.).
●Do not use any coolant additives.
●Do not loosen the coolant inlet cap or the
coolant reservoir cap while the hybrid sys-
tem and radiator are hot.
High temperature steam or coolant could
spray out.
GS450h_OM_OM30F70U_(U).book Page 570 Monday, January 19, 2015 9:34 AM
Page 572 of 654
571
GS450h_OM_OM30F70U_(U)
7
When trouble arises
7-2. Steps to take in an emergency
If the vehicle becomes stuck
Stop the hybrid system. Set the parking brake and shift the shift lever to
P.
Remove the mud, snow or sand from around the rear wheels.
Place wood, stones or some other material under the rear wheels to
help provide traction.
Restart the hybrid system.
Shift the shift lever to D or R and release the parking brake. Then, while
exercising caution, depress the accelerator pedal.
■When it is difficult to free the vehicle
Carry out the following procedures if the tires spin or the vehicle
becomes stuck in mud, dirt or snow:
Press to turn off TRAC. ( →P. 2 8 5 )
1
2
3
4
5
GS450h_OM_OM30F70U_(U).book Page 571 Monday, January 19, 2015 9:34 AM
Page 609 of 654

608
GS450h_OM_OM30F70U_(U)
8-2. Customization
■Vehicle customization
●When the speed linked door locking function and shift position linked door locking
function are both on, the door lock operates as follows.
• When shifting the shift lever to any position other than P, all the doors will belocked.
• If the vehicle is started with all the doors locked, the speed linked door locking function would not operate.
• If the vehicle is started with any door unlocked, the speed linked door locking function will operate.
●When the smart access system with push-button start is off, the selecting door to
unlock cannot be customized.
●When the doors remain closed after unlocking the doors and the automatic door
lock function (time elapsed before the automatic door lock function is activated if a
door is not opened after being unlocked) activates, the signals will be generated in
accordance with the operation signal (buzzers) and the operation signal (emer-
gency flashers) settings.
■When customizing using the Remote Touch
Stop the vehicle in a safe place, apply the parking brake, and shift the shift lever to P.
Also, to prevent 12-volt battery discharge, leave the hybrid system operating while
customizing the features.
CAUTION
■During customization
As the hybrid system needs to be operating during customization, ensure that the
vehicle is parked in a place with adequate ventilation. In a closed area such as a
garage, exhaust gases including harmful carbon monoxide (CO) may collect and
enter the vehicle. This may lead to death or a serious health hazard.
NOTICE
■During customization
To prevent 12-volt battery discharge, ensure that the hybrid system is operating
while customizing features.
GS450h_OM_OM30F70U_(U).book Page 608 Monday, January 19, 2015 9:34 AM
Page 631 of 654
630What to do if... (Troubleshooting)
GS450h_OM_OM30F70U_(U)
●Did you press the power switch while firmly depressing the
brake pedal? (→P. 193)
●Is the shift lever in P? ( →P. 1 9 6 )
●Is the electronic key anywhere detectable inside the vehicle?
(→ P. 1 2 6 )
●Is the steering wheel unlocked? ( →P. 197)
●Is the electronic key battery weak or depleted?
In this case, the hybrid system can be started in a temporary
way. ( →P. 560)
●Is the 12-volt battery discharged? ( →P. 562)
●Is the power switch in ON mode?
If you cannot release the shift lever by depressing the brake
pedal with the power switch in ON mode ( →P. 5 5 6 )
●It is locked automatically to prevent theft of the vehicle.
(→ P. 1 9 6 )
If you think something is wrong
The hybrid system does not start
The shift lever cannot be shifted from P even if you depress the
brake pedal
The steering wheel cannot be turn ed after the hybrid system is
stopped
GS450h_OM_OM30F70U_(U).book Page 630 Monday, January 19, 2015 9:34 AM
Page 633 of 654
632What to do if... (Troubleshooting)
GS450h_OM_OM30F70U_(U)
●Did anyone inside the vehicle open a door during setting the
alarm?
The sensor detects it and the alarm sounds. (→P. 8 3 )
To stop the alarm, turn the power switch to ON mode or start the
hybrid system.
●Is the message displayed on the multi-information display?
Check the message on the multi-information display.
(→ P. 513)
●When a warning light turns on or a warning message is dis-
played, refer to P. 503, 513.
An alarm is activated
and the horn sounds
A warning buzzer sounds wh en leaving the vehicle
A warning light turns on or a warning message is displayed
GS450h_OM_OM30F70U_(U).book Page 632 Monday, January 19, 2015 9:34 AM