2015 Lexus CT200h navigation

295
1. LEXUS PARKING ASSIST MONITOR
CT200h_Navi_OM76146U_(U)14.06.17 09:48
7
PERIPHERAL MONITORING SYSTEM
4. LEXUS PARKING ASSIST MONITOR PRECAUTIONS
zThe image adjustment procedure for the
parking assist monitor screen is the same as
the procedure for adjusting the navigation
screen. ( →P. 4 4 )
AREA DISPLAYED ON
SCREEN
The parking assist monitor displays an
image of the view from the bumper of
the rear area of the vehicle.
Screen Displayed area
Corners of bumper
INFORMATION
●The area displayed on the screen may
vary according to vehicle orientation
conditions.
● Objects which are close to either corner
of the bumper or under the bumper can-
not be displayed.
● The camera uses a special lens. The dis-
tance of the image that appears on the
screen differs from the actual distance.
● Items which are located higher than the
camera may not be displayed on the
monitor.

300
1. LEXUS PARKING ASSIST MONITOR
CT200h_Navi_OM76146U_(U)14.06.17 09:48
5. THINGS YOU SHOULD KNOW
If you notice any of the following symptoms, refer to the likely cause and the solution,
and re-check.
If the symptom is not resolved by the solution, have the vehicle inspected by your Lexus
dealer.
IF YOU NOTICE ANY SYMPTOMS
SymptomLikely causeSolution
The image is difficult to see
•The vehicle is in a dark area
• The temperature around
the lens is either high or low
• The outside temperature is
low
• There are water droplets on
the camera
• It is raining or humid
• Foreign matter (mud etc.) is
adhering to the camera
• Sunlight or headlights are
shining directly into the
camera
• The vehicle is under fluo-
rescent lights, sodium lights,
mercury lights etc.
Back up while visually check-
ing the vehicle’s surroundings.
(Use the monitor again once
conditions have been im-
proved.)
The procedure for adjusting
the picture quality of the park-
ing assist monitor is the same
as the procedure for adjusting
the navigation screen.
(→ P.44)
The image is blurry
Dirt or foreign matter (such as
water droplets, snow, mud
etc.) is adhering to the cam-
era.Rinse the camera lens with
water and wipe it clean with a
soft cloth.
Wash with a mild soap if the
dirt is stubborn.
The image is out of alignmentThe camera or surrounding
area has received a strong im-
pact.Have the vehicle inspected by
your Lexus dealer.
The guide lines are very far
out of alignment
The camera position is out of
alignment.Have the vehicle inspected by
your Lexus dealer.
•The vehicle is tilted (there is
a heavy load on the vehicle,
tire pressure is low due to a
tire puncture, etc.)
• The vehicle is used on an
incline.If this happens due to these
causes, it does not indicate a
malfunction.
Back up while visually check-
ing the vehicle’s surroundings.
The estimated course lines
move even though the steer-
ing wheel is straightThere is a malfunction in the
signals being output by the
steering sensor.Have the vehicle inspected by
your Lexus dealer.

316
1. PHONE OPERATION (HANDS-FREE SYSTEM FOR CELLULAR PHONES)
CT200h_Navi_OM76146U_(U)14.06.17 09:48
4. RECEIVING ON THE Bluetooth® PHONE
1Select or press the switch on
the steering wheel to talk on the phone.
To refuse to receive the call: Select
or press the switch on the steering
wheel.
To adjust the volume of a received call :
Turn the “PWR·VOL” knob, or use the vol-
ume control switch on the steering wheel.
INCOMING CALLS
When a call is received, this screen is
displayed with a sound.
INFORMATION
● During international phone calls, the
other party’s name or number may not be
displayed correctly depending on the
type of cellular phone you have.
● The incoming call display mode can be
set. ( →P. 3 4 3 )
● The ringtone that has been set in the
“Sound Settings” screen sounds when
there is an incoming call. Depending on
the type of Bluetooth
® phone, both the
navigation system and Bluetooth® phone
may sound simultaneously when there is
an incoming call. ( →P. 3 2 8 )

320
1. PHONE OPERATION (HANDS-FREE SYSTEM FOR CELLULAR PHONES)
CT200h_Navi_OM76146U_(U)14.06.17 09:48
6. Bluetooth® PHONE MESSAGE FUNCTION
1Press the “MENU” button on the
Remote Touch.
2Select “Phone” .
3Select .
zThe phone top screen can be displayed by
pressing the
switch on the steering
wheel.
4Check that the message inbox screen is
displayed.
: Select to change to phone mode.
Received messages can be forwarded
from the connected Bluetooth® phone,
enabling checking and replying using
the navigation system.
Depending on the type of Bluetooth
®
phone connected, received messages
may not be transferred to the message
inbox.
If the phone does not support the mes-
sage function, this function cannot be
used.
FunctionPage
Receiving a message321
Checking messages322
Replying to a message (quick reply)323
Calling the message sender325
Message settings341

8
PHONE
321
1. PHONE OPERATION (HANDS-FREE SYSTEM FOR CELLULAR PHONES)
CT200h_Navi_OM76146U_(U)14.06.17 09:48
RECEIVING A MESSAGE
When an e-mail/SMS/MMS is re-
ceived, the incoming message screen
pops up with sound and is ready to be
operated on the screen.
No.Function
Select to check the message.
Select to not open the message.
Select to call the message sender.
INFORMATION
● Depending on the cellular phone used for
receiving messages, or its registration
status with the navigation system, some
information may not be displayed.
● The pop up screen is separately available
for incoming e-mail and SMS/MMS mes-
sages under the following conditions:
E-mail:
• “Incoming E-mail Display” is set to “Full
Screen”. ( →P. 3 4 1 )
• “E-mail Notification Popup” is set to on. (→ P. 3 4 1 )
SMS/MMS:
• “Incoming SMS/MMS Display” is set to “Full screen”. ( →P. 3 4 1 )
• “SMS/MMS Notification Popup” is set to on. ( →P. 3 4 1 )

324
1. PHONE OPERATION (HANDS-FREE SYSTEM FOR CELLULAR PHONES)
CT200h_Navi_OM76146U_(U)14.06.17 09:48
■EDITING QUICK REPLY MESSAG-
ES
1Select “Quick Msg” .
2Select corresponding to the de-
sired message to edit.
3Select “OK” when editing is completed.
This operation cannot be performed
while driving.
INFORMATION
●To reset the edited quick reply messages,
select “Default” .
● “Quick Message 1” (“I am driving and
will arrive in approximately [ETA]
minutes.”) :
This message cannot be edited and will
automatically fill in [ETA] with the
navigation calculated estimated time of
arrival on the confirm message screen.
If there are waypoints set, [ETA] to the
next waypoint will be shown.
If there is no route currently set in the
navigation system, “Quick Message 1”
cannot be selected.

9
351
1
2
3
4
5
6
7
8
9
CT200h_Navi_OM76146U_(U)14.06.17 09:44
1. FUNCTIONAL OVERVIEW............... 352
2. TYPE A: FUNCTION ACHIEVED BY USING A CELLULAR
PHONE.................................................... 353
BEFORE USING THE FUNCTION ............. 355
PREPARATION BEFORE USING
LEXUS App Suite................................................ 356
3. TYPE B: FUNCTION ACHIEVED BY USING DCM AND THE
NAVIGATION SYSTEM ................... 358
BEFORE USING THE FUNCTION ............. 359
4. TYPE C: FUNCTION ACHIEVED BY USING DCM ................................... 361 1. LEXUS App Suite..................................... 362
USING LEXUS App Suite .................................. 362
LINKING LEXUS App Suite AND
NAVIGATION LOCAL FUNCTION ...... 367
App Suite KEYBOARD OPERATION ........ 370
2. Destination Assist..................................... 372
MAKE A CALL WITH Destination Assist .... 372
3. eDestination............................................... 374
DOWNLOADING eDestinations .................. 374
SEARCHING eDestinations .............................. 376
DISPLAYING eDestination ICONS .............. 377
4. Lexus Insider .............................................. 378
NEW MESSAGE NOTIFICATION.............. 378
VIEWING AND PLAYING RECEIVED Lexus Insider MESSAGES ............................... 379
1. LEXUS App Suite SETTINGS .............. 382
SCREEN FOR LEXUS App Suite SETTINGS .............................................................. 383
1
LEXUS ENFORM, SAFETY
CONNECT AND APP
SUITE-OVERVIEW
2
LEXUS ENFORM, SAFETY
CONNECT AND APP SUITE
OPERATION
3SETUP
LEXUS ENFORM, SAFETY CONNECT AND APP SUITE

352
CT200h_Navi_OM76146U_(U)14.06.17 09:48
1. LEXUS ENFORM, SAFETY CONNECT AND APP SUITE-OVERVIEW
1. FUNCTIONAL OVERVIEW
zThe functions included in Lexus Enform are classified into the following three types.
Type A: Function achieved by using a cellular phone
Type B: Function achieved by using an embedded cellular device in the vehicle
(DCM: Data Communication Module) and the navigation system
Type C: Function achieved by using DCM
z Each function is available in the following areas:
• LEXUS App Suite is available in the cont iguous United States, D.C. and Alaska.
• Destination Assist and eDestination are available in the contiguous United States, D.C. and limited areas of Alaska for vehicle that contain map data.
• Lexus Insider is available in the cont iguous United States, D.C. and Alaska.
• Safety Connect includes four features: Automatic Collision Notification, Emergency Assistance, Stolen Vehicle Location and
Enhanced Roadside Assistance are available in the contiguous United States, D.C.
and Alaska.
Lexus Enform is a feature that includes LEXUS App Suite, Destination Assist, eDesti-
nation, Lexus Insider, and Safety Connect.
FunctionType
LEXUS App SuiteType A
Destination AssistType B
eDestinationType B
Lexus InsiderType B
Safety ConnectType C
INFORMATION
●
The actual service availability is depend ent on the cellular network condition.