2015 Lancia Delta height

KNOWING YOUR CAR53
1
Height adjustment
Operate lever C to rai se or lower the rear part of the seat
cus hion to improve comfort.
Lumbar adjustment (driver’s seat)
The pos ition of the back again st the s eat backres t is ad-
jus ted by turning knob D.
FRONT SEATS WITH ELEC TRIC ADJUS TMENT
fig . 21 (for vers ions/markets where provided
The adjus tment is possible with the ignition key to MAR
or for up to 1 minute with the ignition ke y turned to OFF
or extracted.
When the front doors are opened the seat on the side of
the door that has been opened can be moved for about 3
minutes or until the door i s clos ed.
The controls for seat adjustment are:
Multifunction control A:
❍ seat height adjus tment;
❍ lengthwis e seat movement.
Multifunction control B:
❍ backres t angle adju stment;
❍ backres t lumbar adju stment. S
eat heating (for versions/markets , wher
e provided)
With the key turned to MAR, press buttons
Cto switch
the function on/off.
When the function is enabled, the LED on the button turns
on.
fig. 21L0E0009m
001-154 Delta GB 1ed 03/03/14 10.00 Pagina 53

KNOWING YOUR CAR55
1
HEAD RESTRAINTS
Head restraints are height adju stable; operate a s follows .
❍ Upwards adjustment: lift the head res traint until it
locks .
❍ Downward adjus tment, press the button A and lower
the head res traint.
fig. 24L0E0011m
To extract the rear head re straints press button s B and C
at the s ide of the two supports s imultaneous ly and lift them
out upward s.
IMPORTANT When the rear s eats are in us e, the head
re straints must always be in the pos ition of use.
All adjustments must be carried out only with
the vehicle stationary and engine off. Head
restraints must be adjusted so that the head,
rather than the neck, rests on them. Only in this case
can they protect your head correctly. To make the
best use of the head restraint’s protective action, ad-
just the backrest so that your torso is upright and
keep your head as close as possible to the head re-
straint.
REAR HEAD RES TRAINTS fig. 24
(for vers ions/markets , where provided)
Depending on the vers ions, rear head res traints can be
“fixed” or height-adju stable ty pe.
Height-adjustable head restraint:
❍ Upwards adjustment: press button B and lift the head
re straint until it locks .
❍ Downward adjus tment, press button B and lower the
head res traint.
001-154 Delta GB 1ed 03/03/14 10.00 Pagina 55

SAFETY161
2
❍prevent the retractors from getting wet: their correct
operation is only guaranteed if water does not get in-
side;
❍ replace the seat belt when it shows significant wear
or cuts.
❍ replace the seat belt when it demonstrates significant
wear or cuts.CARRYING CHILDREN SAFELY
For optimal protection in the event of an impact, all oc-
cupants must be seated and wearing adequate restraint
systems, including newborn and other children!
This prescription is compulsory in all EC countries ac-
cording to EC Directive 2003/20/EC. Compared with an
adult, a child’s head is larger and heavier in proportion
to his/her body and the child’s muscular and bone struc-
tures are not fully developed. Therefore, correct restraint
systems other than adult seat belts are necessary to reduce
as much as possible the risk of injuries in the event of an
accident, braking or a sudden manoeuvre.
Children must be seated safely and comfortably. As far
as the characteristics of the child restraint systems used
allow, you are advised to keep children in rear facing re-
straint systems for as long as possible (at least until 2 years
old), since this is the most protected position in the event
of an impact. The choice of the most suitable child re-
straint device depends on the weight of the child; there are
various types of child restraint systems and you are ad-
vised always to choose the one that is most suitable for the
child.
When over 1.50 m in height, from the point of view of
restraint systems, children are considered as adults and
wear seat belts normally.
155-182 Delta GB 1ed 26/08/13 11.29 Pagina 161

166SAFETY
GROUP 3 For children between 22 kg and 36 kg, there are dedicated
restraint systems that allow the seat belt to be worn cor-
rectly.
Figure 9 shows correct child seat positioning on the rear
seat. Children over 1.50 m in height can wear seat belts
like adults.
The diagram is indicative and for fitting
purposes only. Refer to the instructions
which must be supplied with the child re-
straint system.
fig. 9L0E0410m
155-182 Delta GB 1ed 26/08/13 11.29 Pagina 166

NOZZLES
Windscreen washer fig. 5
If the jet of fluid is inadequate, firstly check that there is
fluid in the reservoir: (see “Checking levels” paragraph in
this chapter).
Then check that the nozzle holes are not clogged, if nec-
essary clean them using a needle.
The windscreen jets are directed by adjusting the nozzle
angle.
The jets should be directed at about a third of the height
from the top edge of the windscreen.
IMPORTANT In versions with a sun roof, make sure that
the sun roof is closed before operating the front jets.
fig. 5L0E0099m
Rear window washer fig. 6
The rear window washer jets are fixed. The nozzle hold-
er is located above the rear window.
fig. 6L0E0100m
MAINTENANCE AND CARE251
233-256 Delta GB 1ed 03/04/14 13:28 Pagina 251

264TECHNICAL SPECIFICATIONS
WHEELS
RIMS AND TYRES
Pressed steel or alloy rims. Tubeless radial carcass tyres.
All approved tyres are listed in the Vehicle Registration
Document.
IMPORTANT In the event of discrepancies between the
information provided in this “Owner’s handbook” and the
“Registration Document”, consider the specifications
shown in the log book only. For safe driving, the car must
be fitted with tyres of the same make and type on all
wheels.
IMPORTANT Do not use air chambers with Tubeless tyres.
SPACE-SAVER WHEEL
Pressed steel rim. Tubeless tyre.
WHEEL GEOMETRY
Total front toe in: –1
±1 mm
Total rear toe in: 2
± 2 mm
The figures refer to the car in running order. UNDERSTANDING TYRE MARKING fig. 5
Example: 195/55 R 16 91 V
195 = Nominal width (S, distance in mm between
sidewalls).
55 = Height/width ratio (H/S) as a percentage.
R = Radial tyre.
16 = Rim diameter in inches (Ø).
91 = Load index (capacity).
V = Maximum speed index.
fig. 5L0E0120m
257-280 Delta GB 1ed 02/09/13 09.37 Pagina 264

TECHNICAL SPECIFICATIONS269
6
fig. 7
L0E0299m
DIMENSIONS
452010172700
(*) Small variations in size are possible depending on the dimensions of the rims1499 (*)15381531
Luggage compartment capacity
Capacity with vehicle unlade n (VDA standards) ............................... 3 80 dm
3
Maximum capacity ........................................................................\
.... 465 dm3
Dimensions are expressed in mm and refer to the car equipped with its stan-
dard-supplied tyres. Height is measured with the car unladen.
1797
ABCDEFGH
803
257-280 Delta GB 1ed 02/09/13 09.37 Pagina 269