IN AN EMERGENCY219
4
fig. 27L0E0166m
fig. 26L0E0165m
REPLACING AN INTERIOR BULB
For the type of bulb and power rating, see the “Bulb types”
paragraph.FRONT ROOF LIGHT
Proceed as follows to replace the bulbs:
❍
remove the roof light A - fig. 26 by acting on the points
shown by the arrows;
❍ open the protective flap B - fig. 27;
❍ replace the bulbs C releasing them from the side con-
tacts and making sure that the new bulbs are correct-
ly secured between the contacts;
❍ close flap B - fig. 27 and fasten the roof light A - fig.
26 in its housing, making sure it is locked correctly.
IMPORTANT In some versions, the roof light in fig. 26 is
at the back (electric sun roof version). To replace the rel-
evant bulbs, refer to the procedure described in paragraph
“Rear roof light” in this chapter.
195-232 Delta GB 1ed 03/03/14 09.15 Pagina 219
232IN AN EMERGENCY
When towing, remember that without the help
of the brake servo and electric power steer-
ing, a greater effort is required on the pedal
and steering wheel. Do not use flexible cables when
towing and avoid jerky movements. During towing,
make sure that the trailer hitch does not damage any
components it is touching. When towing the car, it
is compulsory to respect specific highway code reg-
ulations relating to the tow hook and procedures for
towing on the road. Do not start the engine while
towing the car. Before tightening the ring clean the
threaded housing thoroughly. Make sure that the
ring is securely fastened before towing the car.
The front and rear tow hooks must only be
used for emergency situations on the road.
The car may be towed for short distances
when a dedicated device is used in compliance with
the Highway Code (rigid bar), and in order to move
the vehicle on the road in preparation for towing
or transport via a breakdown vehicle. Tow hooks
MUST NOT be used to tow vehicles off the road or
where there are obstacles and/or for towing oper-
ations using cables or other non-rigid devices. Re-
specting the above conditions, towing must take
place with two vehicles (one towing, the other towed)
aligned as much as possible along the same centre
line.Before towing, turn the ignition key to MAR
and then to STOP without removing it. The
steering column will automatically lock when
the key is removed and the wheels cannot be steered.
195-232 Delta GB 1ed 03/03/14 09.15 Pagina 232
