Page 165 of 636
TO OPEN AND CLOSE THE HOOD
To open the hood, two latches must be released.
1. Pull the release lever located below the instrument
panel and in front of the driver’s door.2. Reach under the hood, move safety latch to the left
and lift the hood.
Hood Release
Safety Latch Location
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 163
Page 286 of 636
INSTRUMENT PANEL FEATURES
1 — Air Outlet 6 — Lower Switch Bank 11 — Hood Release
2 — Instrument Cluster 7 — Hazard Switch 12 — Fuel Door Release
3 — Radio 8 — Storage Bin (SD Card, AUX, USB Me-
dia Hub)13 — Headlight Switch
4 — Glove Compartment 9 — ESC Button 14 — Dimmer Control
5 — Climate Controls 10 — Ignition Switch 284 UNDERSTANDING YOUR INSTRUMENT PANEL
Page 548 of 636

9. Push the door to the near closed position to reengage
the glove compartment travel stops.
NOTE:Ensure the glove compartment door hinges and
glove compartment travel stops are fully engaged.
Body Lubrication
Locks and all body pivot points, including such items as
seat tracks, door hinge pivot points and rollers, liftgate,
tailgate, decklid, sliding doors and hood hinges, should
be lubricated periodically with a lithium based grease,
such as MOPAR® Spray White Lube to assure quiet, easy
operation and to protect against rust and wear. Prior to
the application of any lubricant, the parts concerned
should be wiped clean to remove dust and grit; after
lubricating excess oil and grease should be removed.
Particular attention should also be given to hood latching
components to ensure proper function. When performing
other underhood services, the hood latch, release mecha-
nism and safety catch should be cleaned and lubricated.The external lock cylinders should be lubricated twice a
year, preferably in the Fall and Spring. Apply a small
amount of a high quality lubricant, such as MOPAR®
Lock Cylinder Lubricant directly into the lock cylinder.
Windshield Wiper Blades
Clean the rubber edges of the wiper blades and the
windshield periodically with a sponge or soft cloth and a
mild nonabrasive cleaner. This will remove accumula-
tions of salt or road film.
Operation of the wipers on dry glass for long periods
may cause deterioration of the wiper blades. Always use
washer fluid when using the wipers to remove salt or dirt
from a dry windshield.
Avoid using the wiper blades to remove frost or ice from
the windshield. Keep the blade rubber out of contact with
petroleum products such as engine oil, gasoline, etc.
546 MAINTAINING YOUR VEHICLE
Page 623 of 636

GVWR.................................479
Hazard
Driving Through Flowing, Rising, Or Shallow Stand-
ing Water.............................420
Hazard Warning Flasher....................500
Headlights..............................585
Bulb Replacement.......................586
On With Wipers........................166
Passing..............................175
Replacing.............................586
Heated Mirrors.......................130, 277
High Beam Indicator.......................286
Hitches
Trailer Towing.........................485
HomeLink® (Garage Door Opener)............242
Hood Release............................163Ignition
Key..................................13
Illuminated Entry..........................22
Immobilizer (Sentry Key)....................17
Inside Rearview Mirror.....................121
Instrument Cluster........................286
Instrument Panel And Controls...............284
Instrument Panel Lens Cleaning...............572
Interior Appearance Care....................571
Intermittent Wipers (Delay Wipers).............176
Introduction..............................4
Inverter, Power...........................263
iPod® Control...........................340
iPod®/USB/MP3 Control...................340
Bluetooth® Streaming Audio...............340
Jacking Instructions........................506
Jack Location.........................503, 505
Jack Operation...........................506
10
INDEX 621