2015 HONDA CIVIC COUPE ignition

393
Continued
Handling the Unexpected
If a Tire Goes FlatChanging a Flat TireIf a tire goes flat while driving, grasp the steering wheel firmly, and brake gradually
to reduce speed. Then, stop in a safe place. Replace the flat tire with a compact
spare tire. Go to a dealer as soon as possible to have the full-size tire repaired or
replaced.
1.Park the vehicle on firm, level, and non-slippery surface, and apply the parking
brake.
2. Put the shift lever in
(P
.
2. Put the shift lever in
(R
.
3. Turn on the hazard warning lights and turn the ignition switch to LOCK
(0
*1.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
1 Changing a Flat Tire
Periodically check the tire pressure of the compact
spare. It should be set to the specified pressure.
Specified Pressure: 60 psi (420 kPa, 4.2 kgf/cm
2)
When driving with the compact spare tire, keep the
vehicle speed under 50 mph (80 km/h). Replace with
a full-size tire as soon as possible.
The compact spare tire and wheel in your vehicle are
specifically for this model. Do not use them with
another vehicle. Do not use another type of compact
spare tire or wheel with your vehicle.
Do not mount tire chains on a compact spare tire.
If a chain-mounted front tire goes flat, remove one of
the full-size rear tires and replace it with the compact
spare tire. Remove the flat front tire and replace it
with the full-size tire th at was removed from the rear.
Mount the tire chains on the front tire.
Continuously variable transmission modelsManual transmission modelsAll models

406Handling the Unexpected
Shift Lever Does Not MoveFollow the procedure below if you cannot move the shift lever out of the
(P

position.
1.Set the parking brake.
2. Remove the key from the ignition switch.
2. Remove the built-in key from the smart
entry remote.
3. Wrap a cloth around the tip of a small flat-
tip screwdriver. Put it into the shift lock
release slot as shown in the image, and
remove the cover.
4. Insert the key into the shift lock release slot.
5. While pushing the key in, press the shift
lever release button and place the shift lever
into
(N
.
u The lock is now released. Have the shift
lever checked by a dealer as soon as
possible.
■
Releasing the LockContinuously variable transmission models
SlotCover
Models without smart entry systemModels with smart entry systemAll models
Release
Button
Shift Lock
Release Slot

413
Continued
Handling the Unexpected
FusesFuse LocationsIf any electrical devices are not working,
turn the ignition switch to LOCK
(0
*1 and
check to see if any applicable fuse is blown.
Located near the brake fluid reservoir. Push
the tabs to open the box.
Fuse locations are shown on the fuse box
cover. Locate the fuse in question by the
fuse number and box cover number.
■
Engine Compartmen t Fuse Box
■Circuit protected and fuse rating
Circuit Protected
Amps
1
EPS
70 A
−
(40 A)
ABS/VSA Motor
30 A
ABS/VSA FSR
30 A
Wiper Motor
*2
−*3
30 A
(30 A)
Main Fuse
100 A
2
IG Main
30 A
*2
50 A
*3
Fuse Box Main 60 AFuse Box Main 2
60 A
Headlight Main 30 A
ST MG Switch
*2
−*3
30 A
(30 A)
Rear Defogger 40 A IG Main 2
*2
−*3
30 A
(30 A)
Blower 40 A −(30 A)
Sub Fan Motor 20 A
Main Fan Motor 20 A
3
−
−
4 −
*2
Left Headlight Low Beam
*3
−
15 A
5
START DIAG
*2
ST MG
*3
7.5 A
7.5 A
*1:Models with the smart entry system have
an ENGINE START/STOP button
instead of an ignition switch.
*2:Models with smart entry system
*3:Models without smart entry system 6
−
*2
Right Headlight Low Beam
*3
−
15 A
7
−
−
8− −
9
−
−
10 − −
11
Oil Level
7.5 A
12 Fog Lights
*
(20 A)
13
−
−
14 Hazard 10 A
15
FI Sub
15 A
16 IG Coil 15 A
17
Stop
15 A
18 Horn 10 A
19
Premium Amp
*
(20 A)
20 Right Headlight Low Beam
*2
−*3
15 A
−
21
IGP
15 A
22 DBW 15 A
23
Left Headlight Low Beam
*2
Headlight Low Beam
*3
15 A
20 A
24 − −
Circuit Protected
Amps
* Not available on all models

416
uuFuses uInspecting and Changing Fuses
Handling the Unexpected
Inspecting and Changing Fuses
1. Turn the ignition switch to LOCK
(0
*1. Turn
headlights and all accessories off.
2. Remove the fuse box cover.
3. Check the large fuse in the engine
compartment.
u If the fuse is blown, use a Phillips-head
screwdriver to remove the screw and
replace it with a new one.
4. Inspect the small fuses in the engine
compartment and the vehicle interior.
u If there is a burned out fuse, remove it
with the fuse puller and replace it with a
new one.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
1 Inspecting and Changing FusesNOTICEReplacing a fuse with one that has a higher rating
greatly increases the chances of damaging the
electrical system.
Replace fuse with a spare fuse of the same specified
amperage.
Confirm the specified amperage using the charts on
P. 413 to 414.
There is a fuse puller on the back of the engine
compartment fuse box cover.
Combined
Fuse Blown FuseFuse Puller

427
Continued
Information
Emissions TestingTesting of Readiness CodesYour vehicle has “Readiness Codes,” as part of the onboard self diagnostic system.
Some States use these codes as a test to see if your vehicle's emissions components
are working properly.
The codes may not be read properly if testing is performed just after the battery has
gone dead or been disconnected.
To check if they are set, turn the ignition switch to ON
(w
*1, without starting the
engine. The malfunction indicator lamp will come on for several seconds. If it then
goes off, the readiness codes are set. If it blinks five times, the readiness codes are
not set.
If you are required to have your vehicle tested before the readiness codes are ready,
prepare the vehicle for retesting by doing the following:
1. Fill the gas tank to approximately 3/4 full.
2. Park the vehicle and leave the engine off for six hours or more.
3. Make sure the ambient temperature is between 40 °F and 95 °F (4 °C and 35 °C).
4. Start the engine without touching the accelerator pedal, and let it idle for 20
seconds.
5. Keep the vehicle in
(P
(continuously variable transmission) or
(N
(manual
transmission). Increase the engine speed to 2,000 rpm, and hold it there for about
three minutes.
6. Let the engine idle with your foot off the accelerator for 20 seconds.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
1 Testing of Readiness Codes
The readiness codes are erased when the battery is
disconnected, and set again only after several days of
driving under a variety of conditions.
If a testing facility dete rmines that the readiness
codes are not set, you may be requested to return at
a later date to complete the test.
If the testing faci lity determines the readiness codes
are still not set, see a dealer.

436Index
Locations ......................................... 413, 414GGasoline (Fuel)Economy ................................................. 335
Gauge ....................................................... 81
Information ............................................. 332
Instant Fuel Economy ........................... 81, 86
Low Fuel Indicator ..................................... 69
Refueling ................................................. 332
Gauges ......................................................... 81
Gear Shift Lever Positions
Continuously Variable Transmission .................................. 305, 307
Manual Transmission ............................... 312
Glass (care) ................................................ 388
Glove Box .................................................. 147HHalogen Bulbs ........................................... 364
Handling the Unexpected ........................ 391
HandsFreeLink® (HFL) ....................... 233, 264
Automatic Import of Cellular Phonebook and Call History .................................... 249, 276
Automatic Transferring ............................ 247
Caller’s ID Information ............................. 247
Displaying Messages ........................ 260, 285
HFL Buttons ..................................... 233, 264
HFL Menus ...................................... 235, 266 HFL Status Display ........................... 234, 265
Limitations for Manual Operation ............ 234
Making a Call .................................. 253, 279
Options During a Call ...................... 258, 282
Phone Setup.................................... 240, 270
Receiving a Call ............................... 257, 282
Receiving a Text Message/E-mail...... 259, 283
Ring Tone................................................ 275
Selecting a Mail Account ......................... 284
Speed Dial ....................................... 250, 277
Text Message .................. 245, 259, 274, 283
To Clear the System ................................ 248
To Create a Security PIN .......................... 246
To Set Up a Text Message/E-mail
Options ......................................... 245, 274
Hazard Warning Button .............................. 4
Head Restraints ........................................ 139
Headlights ................................................. 127
Aiming .................................................... 360
Automatic Operation............................... 128
Dimming ......................................... 127, 130
Operating................................................ 127
Heaters (Seat) ........................................... 151
Heating and Cooling System ................... 152
Cooling ................................................... 154
Defrosting the Windshield and Windows ............................................... 154
Dust and Pollen Filter............................... 384
Heating ................................................... 153
HFL (HandsFreeLink® )....................... 233, 264
High Beam Indicator .................................. 73 Hill Start Assist System
..................... 299, 302
IIdentification Numbers ............................ 424
Vehicle Identification............................... 424
Ignition Switch ......................................... 122
Illumination Control ................................ 132
Knob ...................................................... 132
i-MID ........................................................... 83
Immobilizer System .................................. 116
Indicator ................................................... 74
Indicators .................................................... 66
Anti-lock Brake System (ABS) .................... 69
Brake System (Amber) ............................... 66
Charging System............................... 67, 409
CRUISE CONTROL ............................. 75, 316
CRUISE MAIN.................................... 75, 315
Door Open.......................................... 29, 71
ECON Mode ..................................... 75, 314
Electric Power Steering (EPS) System ............................................ 72, 411
Fog Light .................................................. 73
High Beam ................................................ 73
High Temperature ..................................... 70
Immobilizer System ................................... 74
i-VTEC ................................................ 75, 82
Lights On .................................................. 73
Low Fuel ................................................... 69
Low Oil Pressure ............................... 67, 409
Low Temperature...................................... 70