Page 87 of 569

86
uuIndicators uMulti-Information Display Warn ing and Information Messages
Instrument Panel
Multi-Information Display Warning and Information MessagesThe following messages appear only on the multi-information display. Pres s the (information) button to see the message again
with the system message indicator on.
Message
Condition
Explanation
●Appears when the fuel fill cap is loose or is not
installed.
2 Tighten Fuel Cap Message P. 535
●Appears when the scheduled maintenance is due
soon.
u Consequently, Maintenance Due Now and
Maintenance Past Due follow.
2Maintenance Minder Messages on the Multi-
Information Display P. 472
●Appears when the engine coolant temperature gets
abnormally high.
2Overheating P. 531
●Appears when the engine coolant temperature is
near its upper limit.
●Drive slowly to prevent overheating.
●Appears if any door or the trunk is not completely
closed.●The beeper sounds and the message comes on if any
door or the trunk is opened while driving.
●Goes off when all doors and the trunk are closed.
Page 94 of 569

93
uuIndicators uMulti-Information Display Warning and Information Messages
Continued
Instrument Panel
Message
Condition
Explanation
●Appears when the power system temperature is
high.
●Your vehicle has less ability to accelerate and may be
harder to start on an incline.●Park in a safe place, and cool the system down.
2 Overheating P. 531
●Appears when the High Voltage battery temperature
is low.
●Your vehicle has less ability to accelerate and may be
harder to start on an incline.●Goes off once you start driving as the High Voltage
battery warms up.
●Appears after the 12-volt battery charging system
indicator comes on.
●Your vehicle has less ability to accelerate and may be
harder to start on an incline.●Contact a dealer immediately.
●Appears when the High Voltage battery temperature
is too low to operate (approx. -22°F [-30°C] or
below).
●You can start the engine and use the climate control
system to warm up the interior, which will also warm
the High Voltage battery enough for you to drive the
vehicle.
●Appears when the High Voltage battery and other
system control temperatures are too low to operate
(approx. -40°F [-40°C] or below).
●You must wait for an increase in the ambient
temperature or move the vehicle to a warmer location.●Consult a dealer.
Page 95 of 569
94
uuIndicators uMulti-Information Display Warn ing and Information Messages
Instrument Panel
Message
Condition
Explanation
●Appears if the power system is in diagnostic mode.
●You may notice a decrease in available power. Have your
vehicle checked by a dealer.●As a result of diagnostics, the POWER SYSTEM
indicator may come on.
2 POWER SYSTEM Indicator P. 75
●Appears when you failed to select EV mode or EV
mode is automatically canceled.●The cause may be shown with the following
message:
-Ambient Temperature Too Low
- Battery Charge Too Low
- Engine Too Cold
- Cabin Being Heated
- Speed Too High
- Hard Acceleration Requested
●EV mode is available once the condition is improved or
the cause that canceled EV mode is cleared.
Page 96 of 569
95
Continued
Instrument Panel
Gauges and Multi-Information DisplayGaugesGauges include the speedometer, fuel gauge, POWER/CHARGE gauge, High
Voltage battery charge level gauge, and related indicators. They are displayed when
the power mode is in ON.
Displays your driving speed in mph or km/h.
Displays the amount of fuel left in the fuel tank.■
Speedometer
■
Fuel Gauge
1 Fuel GaugeNOTICEYou should refuel when the reading approaches .
Running out of fuel can cause the engine to misfire,
damaging the catalytic converter.
The actual amount of remaining fuel may differ from
the fuel gauge reading.
E
Page 98 of 569
97
uuGauges and Multi-Information Display uMulti-Information Display
Continued
Instrument Panel
Multi-Information DisplayThe multi-information display shows the odometer, trip meter, outside temperature
indicator, and other gauges.
It also displays important messages such as warnings and other helpful information.■Main displays
Press the (information) button to change the display.■
Switching the Display
Average Fuel Economy/
Instant Fuel Economy
Range
Elapsed Time
Average Speed
Blank Screen
Vehicle
Settings Engine Oil
Life
Button
Average Fuel
Economy Records
Eco Drive Display
Power Flow
Monitor
Page 101 of 569

uuGauges and Multi- Information Display uMulti-Information Display
100Instrument Panel
Shows the average speed in mph (U.S.) or km/h (Canada) since Trip A or Trip B was
reset.
Shows the instant fuel economy as a bar graph in mpg (U.S.) or l/100 km (Canada).
Shows the remaining oil life and Maintenance Minder
TM.
2 Maintenance Minder
TM P. 471
Shows the outside temperature in Fahrenheit (U.S.) or Celsius (Canada).■Adjusting the outside temperature display
Adjust the temperature reading up to ±5°F or ±3°C if the temperature reading
seems incorrect.
Shows you turn-by-turn driving directions to your destination linked with the
navigation system
*.
2 Refer to the Navigation System Manual■
Average Speed
■
Instant Fuel Economy
■
Engine Oil Life
■
Outside Temperature
■
Turn-by-Turn Directions
*
1Average Speed
You can change when to reset the average speed.
2 Customized Features P. 104, 2971Outside Temperature
The temperature sensor is in the front bumper.
Road heat and exhaust from another vehicle can
affect the temperature reading when your vehicle
speed is less than 19 mph (30 km/h).
It may take several mi nutes for the display to be
updated after the temperature reading has stabilized.
Use the multi-information display's customized
features to corre ct the temperature.
2 Customized Features P. 104, 2971Turn-by-Turn Directions
*
You can select whether the turn-by-turn display
comes on during the route guidance.
2 Customized Features P. 104, 297
* Not available on all models
Page 104 of 569
Continued
103
uuGauges and Multi-Information Display uMulti-Information Display
Instrument Panel
Displays the motor and the engine power flow, indicating what supplies power to
the vehicle, or if the battery is being charged.■
Power Flow Monitor
1 Power Flow Monitor
While the vehicle is stationary with the engine
running, the following may appear on the multi-
information display.
Power is supplied by the
motor and the engine. Power is only supplied by
the motor.
The motor is charging
the High Voltage battery. Power is only supplied by
the engine.
Page 110 of 569

109
uuGauges and Multi-Information Display uMulti-Information Display
Continued
Instrument Panel
*1: Default SettingSetup Group Customizable Features Description Selectable SettingsDoor Setup
Auto Door Lock
Changes the setting for when the doors
automatically lock.
With Vehicle Speed
*1/
Shift
from P /Off
Auto Door Unlock
Changes the setting for when the doors
automatically unlock.
All Doors When Driver’s
Door Opens
*1/All Doors
When Shifted To Park /All
Doors When Ignition
Switched Off/Off
Key And Remote Unlock
Mode
Sets up either the driver's door or all doors to unlock
on the first operation of the remote or built-in key.
Driver Door
*1/ All Doors
Keyless Lock Answer
Back
LOCK/UNLOCK- The exterior lights flash.
LOCK (2nd push)- The beeper sounds.
On
*1/Off
Security Relock Timer
Changes the time it takes for the doors to relock and
the security system to set after you unlock the
vehicle without opening any door.
90sec /60sec /30sec
*1
Maintenance
Reset
—
Resets/Cancels the engine oil life display when you
have performed the maintenance service.
Cancel /Reset
Default All
—
Cancels/Resets all the customized settings as
default.
Cancel /Set