Heated Front Seats*
To access, press the Climate corner on the touchscreen. For heated
front seats, press repeatedly to cycle through the various heat
modes and off. If your vehicle is not equipped with a touchscreen,
use the hard button controls (indicated by the same symbol) to
cycle through the various heat modes and off.
Memory Function*
Use the memory controls located on the driver’s door to program
and then recall memory positions. Move the seats and mirrors to
the desired positions. To program up to three positions, press and
hold the desired pre-set button until you hear a single tone. You
can now use these controls to recall the set positions.
Moonroof*
Your moonroof controls are
located on the overhead
console and have a one-touch
open and close feature.
To open the moonroof, press
the up arrow
. It stops short
of the fully opened position to
help reduce wind noise.
To close , press the down
arrow
.
To use the venting feature,
press the vent
button.
Tilting Head Restraints
Your vehicle’s front head restraints have
a tilting feature for extra comfort.
To Tilt the Head Restraint
Adjust the seatback to an upright driving
or riding position. Pivot the head restraint
forward toward your head to the desired
position. Once it is in the forward-most
position, tilting it forward once more
releases it to the upright position.
NOTE Do not attempt to force the head restraint backward after
it has been tilted. Instead, continue tilting it forward until the head
restraint releases to the upright position.
Ambient Lighting*
Lights various places, such as the footwells, with a choice of colors.
Access Using Your Touchscreen and Make Your Adjustments 1. Press the Settings icon > Vehicle > Ambient Lighting.
2. Touch the desired color.
3. Use the scroll bar to increase or decrease the intensity.
To switch off this feature, press the power button.
15
*if equipped
Intelligent Access*
NOTE Your intelligent access transmitter must be within
3 feet (1 meter) of the vehicle for intelligent access to
function properly.
This system operates the power locks. To unlock the driver’s door,
pull the front exterior door handle. To lock the doors, press the
sensor on top of the door handles. To unlock and open the trunk,
press the exterior trunk release button near the license plate. The
intelligent access transmitter also contains a mechanical key blade,
which can be used to unlock the driver’s door, if necessary. You must
have a valid transmitter inside the vehicle to switch on the ignition
and start the engine.
If you are unable to start your vehicle using the push button
start, do the following:
1. Place the transmitter in the backup slot inside the
center console.
2. With the transmitter in this position, press the brake pedal,
then the push button start to switch on the ignition and start
your vehicle. Remote Start*
Remote start allows you to start the engine from outside your
vehicle using your remote transmitter. To start, press and then
press twice within three seconds. Once inside, apply the brake
while pressing the START STOP button. Shift into drive (D) and go.
If you have the integrated keyhead transmitter, insert the key into
the ignition and switch on the ignition as you normally would before
driving. To switch off the engine from outside the vehicle after using
your remote start, press
once.
COMFORT
*if equipped
