Stay out of the trajectory (1) as indicated in the illustration.
WARNING:Do not mount tube type tires on tubeless wheels or
tubeless tires on tube type wheels. To do so could result in tire
or wheel failure and cause property damage, personal injury or death.
Preserving proper inflation pressure is a very important maintenance
practice to make sure safe vehicle operation and long life for the tires.
Failure to maintain correct inflation pressure may result in sudden tire
destruction, improper vehicle handling, and may cause rapid and
irregular tire wear. Therefore, inflation pressures should be checked daily
and always before long distance trips.
Follow the tire manufacturer’s recommended cold inflation pressure for
the tire size, type, load range (ply rating) and axle loading typical for
your operation. (Each steer axle tire load equals one-half steer axle
loading; each drive tire load is one-quarter the axle-loading if fitted with
four tires).
Wheels and Tires245
2015 F-650/750(f67)
Owners Guide gf(ownloose), 1st Printing, December 2013
Canadian_French(fr_can)
Rotation may not advisable:
•Front (Steering) Axle:Remove tires when tread wears down to
four–thirty seconds inch (3 millimeters) or less. Retread or rotate
worn tires to drive position. We do not recommend using retreaded
tires on steering axles.
•Rear Axles:Remove tires when tread wears down to two–thirty
seconds inch (2 millimeters).
If using a rib tire on front axle and lug or off-road type on rear axle
positions:
•Front (Steering) Axle:Replace tires at front wheels when tread is
worn to four–thirty seconds inch (3 millimeters) or less.
•Rear Axles:Remove tires when the tread wears down to two–thirty
seconds inch (2 millimeters) or less. Tires identified with the word
re-groovable molded on the sidewall can be re-grooved. There must
be a minimum of three–thirty seconds inch (2.5 millimeters) of
under-tread at the bottom of the grooves.
Wheel and Tire Balancing
Out-of-round or out-of-balance wheels or tires can cause vehicle
vibration, bounce and shimmy. Replace damaged or out-of-round wheels.
You can correct out-of-round tires and wheel assemblies by re-clocking
the tire relative to the wheel.
You should then dynamically balance the tire and wheel assembly.
Tire Wear
Radial tires can exhibit three types of normal wear patterns:
•Even
•Erosion
•Chamfer
Even wear:A sign that the tire is being properly used and maintained.
Erosion wear:Also called rolling wear, channel or river wear, erosion
wear occurs more often on free-rolling tires. This is an indication of
using the tire in a slow wearing operation. What happens is that the belt
plies are held very rigid and the tread is not allowed to distort as it
passes through the contact area. Wear only occurs at the edge of the
tread. No corrective action required. If erosion gets to be one–sixteenth
inch (2 millimeters) or more, you can rotate the tire to a drive axle.
Chamfer or shoulder wear:With tires inflated properly, this is a
normal tendency of most radial tire designs. If both inside and outside
shoulders are wearing evenly around the tire, no further action is
required. Over-inflation is not effective in correcting this effect.
248Wheels and Tires
2015 F-650/750(f67)
Owners Guide gf(ownloose), 1st Printing, December 2013
Canadian_French(fr_can)
