2015 FORD EXPLORER mirror

CLIMATE CONTROLLED
FRONT SEATS*
On touchscreen-equipped vehicles,
press the Climate corner on your
touchscreen. Press the
or
seat icon repeatedly to cycle through
the various modes and off.
For non-touchscreen vehicles, use the
hard button controls (indicated by the
same symbols). Press the controls
repeatedly to cycle through the various
modes and off. More lights indicate
warmer or cooler settings.
MEMORY FUNCTION*
Allows one-touch recall of memory
positions for the driver seat, power
mirrors, steering column* and power-
adjustable pedals. Use the memory
controls on the driver’s door to program and then recall memory positions. To
program position 1, press and hold the
1 button until you hear a tone. Use this
same procedure to set positions 2 and
3 using the respective buttons. You can
now use these controls to recall the set
memory positions.
TILTING HEAD RESTRAINTS*
You can adjust the front-row head
restraints. Pull up to raise the head
restraint. To lower, press the head
restraint down while pressing and
holding the guide sleeve adjust or
release button. Tilt the head restraint for
additional comfort by gently pulling the
top of the head restraint forward. Once
it is in the forward-most position, tilting
it forward once more releases it to the
upright position.
NOTE: Do not attempt to force the
headrest backward after tilting it . Instead,
continue tilting it forward until the
headrest releases to the upright position.
SECOND-ROW HEATED SEATS*To operate, press the button on the rear
of the floor console to cycle through the
various heat settings and off. More lights
indicate warmer settings.
NOTE: The heated seats operate only
when the ignition is on. If activated, they
will turn off automatically when you
switch the engine off.
ADAPTIVE CRUISE CONTROL*
When cruise control is active, this feature
allows you to set and maintain a ‘gap
distance’ between you and the vehicle in
front of you in the same lane. To select a
gap distance, press the GAP control up or
down. See the Cruise Control chapter in
your Owner’s Manual for more details.
NOTE: Driving aids do not replace the
need to watch where the vehicle is
moving and brake where necessary.
Refer to your Owner’s Manual for
more details.
*
if equipped13
DUAL-PANEL MOONROOF AND
POWER SUNSCREEN*
The feature includes a one-touch,
express-opening and -closing feature. To
open, press and release the SLIDE control.
The sunscreen opens automatically and
the moonroof opens to the first position.
To open the moonroof fully, press and
release the SLIDE control again. To close,
pull and release the SLIDE control. Press
and release the TILT control to vent the
moonroof. Pull and release the TILT
control to close the moonroof. To open
the sunscreen, press and release
.
Pull and release to close
the sunscreen.
AUTOWIPERS*
When you switch this feature on, your
wipers turn on automatically when
moisture is on the windshield. The wiper
speed varies based on the amount of
moisture detected and the sensitivity
setting. To deactivate, switch your wiper
controls off.
NOTE:
Make sure that you switch this
feature off before entering a car wash.
110-VOLT AC POWER POINT*
The power point is located on the rear of
the center console and can be used to
power your smaller electrical devices that
do not exceed 150 watts. You can use this
feature after you switch your ignition on
and the battery voltage is above 11 volts.
When the indicator light is on, the power
point is working and ready to use.
POWER-ADJUSTABLE PEDALS*The control is located on the left side of
the steering column. Press the arrow
to move the pedals closer to you or the
arrow to move the pedals further
away from you. The pedals should only
be adjusted when the vehicle is stopped
and in park (P).
AMBIENT LIGHTING*
When activated, ambient lighting
illuminates your vehicle’s footwells and
cupholders with a choice of colors. To
access and make adjustments:
1. Press the Settings icon, then select
Vehicle and Ambient Lighting.
2. Touch the desired color.
3. Use the scroll bar to increase or
decrease the intensity.
To switch the feature on or off, press the
power button.
COMFORT
* if equipped12

16++ +
FUNCTION CONTINUED
BLIND SPOT INFORMATION
SYSTEM (BLIS®) WITH
CROSS TRAFFIC ALERT*
BLIS uses sensors to help you
determine if a vehicle may be in your
blind spot zone. The cross traffic alert
feature alerts you if a car is coming
toward you while you back out of a
parking space. BLIS and cross traffic
alert display a yellow indicator light
in your exterior mirrors. Cross traffic
alert also sounds an audible alarm
and displays messages to warn
you which direction vehicles are
approaching. Refer to the Driving Aids
chapter in your Owner’s Manual for
more information.
SECURICODE™ KEYLESS
ENTRY SYSTEM*
Invisible until touched, the keypad
allows you to lock or unlock the doors.
You will need your five-digit factory
code located on your owner’s wallet
card in the glove box. Refer to the
Locks chapter in your Owner’s Manual
for more information.
DRIVER ALERT*
This system monitors
your driving behavior
and determines when
the driver’s alertness is
reduced or insufficient.
When the system determines that
driving ability is at risk, a tone sounds
and a message appears in the
information display. If you do not make
a correction, then warnings continue
to alert the driver. Press OK on the
steering wheel to clear the warning.
REAR VIEW CAMERA*
This system provides a video image of
the area behind the vehicle. The image
automatically appears in the touchscreen
when the vehicle is in reverse (R) and
uses green, yellow and red guides to
alert you of your proximity to objects.
For non-touchscreen vehicles, the
image appears in the 4.2-inch display.
REVERSE SENSING SYSTEM*
This system sounds a warning tone if
there is an obstacle near the vehicle’s
rear bumper when the vehicle is in reverse
(R) and is traveling less than 3 mph
(5 km/h). The warning tone increases in
frequency as the object gets closer.
NOTE: Visibility aids do not replace the
need to watch where the vehicle is moving.
Refer to your Owner’s Manual for safety
information, more details and limitations.
* if equipped
SELECTSHIFT AUTOMATIC®
TRANSMISSION*
Gives you the ability to manually change
gears, if you’d like. To use, move the
gearshift lever from drive (D) to manual
(M). Depending on your vehicle, use the
toggle switch on the gearshift or the
paddles on the steering wheel to make
shifts manually.
FUEL-EFFICIENT
TRANSMISSION
Your vehicle has been designed to
improve fuel economy by reducing fuel
usage while coasting or decelerating. You
may perceive this as a light to medium
braking sensation when removing your
foot from the accelerator pedal.
LANE KEEPING SYSTEM* This system can notify you to stay in your
lane through the steering system and the
information display when the front view
camera detects an unintentional drifting
out of your lane is likely to happen. Select
system settings as desired by choosing
one of three notification modes from
your information display:
Alert: Provides a steering
wheel vibration.
Aid: Provides an assistance
steering torque input toward
the lane center.
Alert + Aid: Provides an assistance
steering torque input toward
the lane center. If the vehicle
continues drifting out of
the lane, a steering wheel
vibration is also provided.
Switch the feature on
and off by pressing the
control on the headlamp or
direction indicator lever.
NOTE: Driving aids do not replace the
need to watch where the vehicle is moving
and brake where necessary. Make sure
you read your Owner’s Manual for safety
information, details and limitations
before using these systems.
COLLISION WARNING SYSTEM*
This system can alert the driver of certain
collision risks. Sensors detect if vehicles
ahead of you, which are moving in the
same direction, may be a collision risk.
The system alerts you with an audible
tone and red warning light that appears
above the dash. If the risk of collision
increases, the system increases brake
support to help reduce collision speed.
SOS POST-CRASH
ALERT SYSTEM™
Provides audible and visual alarms
when a crash causes the deployment
of airbags or the activation of the
safety belt pretensioners. The direction
indicators flash and the horn sounds.
To deactivate, press the hazard flasher
control or the panic button on your
remote transmitter.
UNIVERSAL GARAGE
DOOR OPENER*
Replaces your traditional garage door
remote with a three-button transmitter
integrated into the driver’s sun visor.
You can program the transmitter to
use with entry gate operators, security
systems, entry door locks, and home or
office lighting.
* if equipped17