2015 FORD EXPEDITION traction control

INSTRUMENT PANEL (CONTINUED)
12 A. POWER LIFTGATE CONTROL* lets you open or
close your power liftgate from the driver seat. To use,
press the control.
B. HILL START ASSIST keeps your vehicle stationary
long enough to move your foot from the brake pedal to
the accelerator pedal when your vehicle is on a slope.
Press the control to switch this feature off. It turns back
on automatically after you re-start your vehicle.
C. ADVANCETRAC® WITH RSC® (ROLL STABILITY
CONTROL™) automatically activates when you start
your engine and helps you keep control of your vehicle
when on a slippery surface. The electronic stability
control portion of the system helps avoid skids and
lateral slides, while the roll stability control helps avoid a
vehicle rollover. The traction control system helps avoid
drive wheel spin and loss of traction.
TRAILER SWAY CONTROL * applies your vehicle
brakes at individual wheels and, if necessary, reduces
engine power. If the trailer begins to sway, the stability
control light flashes and the message TRAILER SWAY
REDUCE SPEED appears in the information display.
The first thing to do is slow down your vehicle, then
pull safely to the side of the road and check for proper
tongue load and trailer load distribution. For more
information, please refer to the Towing chapter in your
Owner’s Manual.
9 RIGHT VEHICLE INFORMATION DISPLAY* provides
information about Entertainment, Phone, Climate and
Navigation*. Use the right-hand, 5-way controls located on
your steering wheel to scroll through, highlight and make minor
adjustments within a selected menu. For more information,
refer to the MyFord Touch chapter in your
Owner’s Manual.
10 STEERING WHEEL CONTROLS
Press VOL+ or VOL– to increase or decrease your
volume level.
Press
to access the previous or next radio station,
CD track or preset satellite radio channel.
Press OK repeatedly to access all possible media sources.
Press
to access voice recognition*.
Press
to access SYNC® phone features.
Note: Some of your steering wheel media controls may vary.
See the Steering Wheel chapter in your Owner’s Manual for
more details.
11 PUSH BUTTON START* allows you to start your vehicle by
pressing the ENGINE START STOP button while fully pressing
down on the brake pedal. If you leave your vehicle idling for an
extended period of time, it automatically shuts down. Before
the engine shuts down, a message appears in the information
display, allowing the driver to override the shutdown feature.
Press the button again to switch the engine off.
Note: Your intelligent access transmitter must be inside the vehicle for
the ignition to start. Keyless warning alert sounds the horn twice when
you exit the vehicle with the intelligent access transmitter and the
keyless vehicle is on.
page 7page 6
9
11
ABC
13 INTEGRATED TRAILER BRAKE
CONTROLLER* assists in smooth and effective
trailer braking by powering the trailer’s electric or
electric over hydraulic brakes with a proportional
output based on the towing vehicle’s
brake pressure.
Use the GAIN adjustment buttons to increase or
decrease the braking feature’s power output to the
trailer. Adjust the GAIN by:

A. Pressing the GAIN + or GAIN – buttons
to increase or decrease the setting to the
desired starting point. A GAIN setting
of 6.0 is a good starting point for
heavier loads.

B. Testing the adjusted GAIN setting.
1. In a traffic-free environment, tow the
trailer on a dry, level surface at a speed of
20-25 mph (30-40 km/h) and squeeze the
manual control lever completely.
2. If the trailer wheels lock up (the tires will
squeal), reduce the GAIN setting. If the trailer
wheels turn freely, increase the
GAIN setting.
3. The proper GAIN setting will be at the point
just below trailer wheel lock-up. If towing a
heavier trailer, trailer wheel lockup may not
be attainable even with the maximum GAIN
setting of 10.
For more information, please refer to the Towing
chapter in your Owner’s Manual.
12
9
10
13
*if equipped *if equipped

page 9*if equipped
14 FOUR-WHEEL DRIVE (4WD)*
operates in four modes for a variety of
road conditions:
2H (4X2) mode delivers power to the
rear wheels only, that is appropriate
for normal, on-road driving on dry
pavement and provides the best fuel
economy.
4A (4X4 AUTO) mode provides
electronic control four-wheel drive
with power delivered to all four
wheels, as required, for increased
traction. This mode is appropriate for
all on-road driving conditions, such as
dry road surfaces, wet pavement,
snow and gravel.
4H (4X4) mode provides electronically
locked four-wheel drive power to all
four wheels. This position is not
recommended for use on dry
pavement and is only intended for
severe winter or off-road conditions,
such as deep snow, ice or shallow sand.
4L (4X4) mode provides electronically
locked four-wheel drive when extra
power at reduced speeds is needed.
Use this mode for off-road, low-speed
operation, such as climbing steep
grades, pulling a boat out of the water
and more. Refer to the Four-Wheel Drive
(4WD) chapter in your Owner’s Manual.
15 HAZARD CONTROL
16 AUDIO SYSTEM CONTROLS
A. EJECT: Press to eject a CD.
B. CD SLOT: Insert a CD.
C. VOL and SYSTEM POWER: Press
to switch the system on and off.
Rotate the control to adjust
the volume.
D. PRESETS: Store your favorite radio
stations. To store a radio station, tune
to the station, then press and hold a
preset button until sound returns.
E. SEEK: Press
to access the
previous or next radio station, CD track
or preset satellite radio channel.
F. MEDIA: Press to access different
audio modes, such as AM, FM and
A/V Input.
G. TUNE: Turn the control to search
through the radio frequency
band manually.
17 CLIMATE CONTROLLED SEATS*

Press the heated or cooled
button repeatedly to cycle through the
highest setting to the lowest and off.
The left bank of buttons are for the
driver, while the right bank of buttons
are for the front passenger. More
indicator lights mean higher settings.
You can also use the controls in the
MyFord Touch touchscreen.
18 CLIMATE CONTROLS
A. FRONT FAN SPEED CONTROL:
Rotate to increase or decrease air flow.
B. DEFROST: Press to distribute air to
the windshield vents and de-mister.
C. A/C: Press to switch the air
conditioning system on and off.
D. MAX A/C: Press for
maximum cooling.
E. HEATED REAR WINDOW: Press to
switch on the rear defrost.
F. AIR DISTRIBUTION CONTROL:
Press to switch airflow from the
windshield, instrument panel, or
footwell vents on or off. The system
can distribute air through any
combination of these vents.
G. RECIRCULATED AIR CONTROL:
Press to switch between outside air
and recirculated air.
H. FAN SPEED –: Press to decrease
the volume of air circulated in
the vehicle.
I. AUTO: Press to switch on the
automatic temperature control.
J. FAN SPEED +: Press to increase the
volume of air circulated in the vehicle.
K. DUAL: Turn to increase or decrease
the air temperature on the passenger
side of the vehicle.

page 8
14
15
16
17
18
AB
C
D
EFE
G
A
BCD
EFG
HIJ
K
INSTRUMENT PANEL (CONTINUED)