4. Wait at least 10 seconds before
removing the fuel pump nozzle to allow
any residual fuel to drain into the fuel
tank.
Note: A fuel spillage concern may occur if
overfilling the fuel tank. Do not overfill the
tank. The fill pipe is equipped with a drain
hole. Excess fuel due to overfill may drain
through the drain hole and drip onto the
ground.
If the fuel fill inlet was not properly closed,
a service engine warning lamp may appear
on the instrument cluster.
At the next opportunity, do the following:
1. Stop your vehicle as soon as safely possible and shift the transmission into
park (P).
2. Open the fuel filler door and remove any visible debris from the fuel fill
opening.
3. Insert either the fuel fill nozzle or the fuel fill funnel provided with the vehicle
several times to allow the inlet to close
properly. This will dislodge any debris
preventing the inlet from sealing. If this action corrects the problem, the
message may not reset immediately. It
may take several driving cycles for the
message to turn off. A driving cycle
consists of an engine start-up (after 4 or
more hours with the engine off) followed
by city or highway driving. Continuing to
drive with the message on may cause the
service engine soon lamp to turn on as
well.
FUEL CONSUMPTION
Note:
The amount of usable fuel in the
empty reserve varies and should not be
relied upon to increase driving range. When
refueling your vehicle after the fuel gauge
indicates empty, you might not be able to
refuel the full amount of the advertised
capacity of the fuel tank due to the empty
reserve still present in the tank.
Empty reserve is the amount of fuel
remaining in the tank after the fuel gauge
indicates empty. Do not rely on this fuel for
driving. The usable capacity of the fuel
tank is the amount of fuel that can be put
into the tank after the gauge indicates
empty. The advertised capacity is the total
fuel tank size – it is the combined usable
capacity plus the empty reserve.
Filling the Tank
For consistent results when filling the fuel
tank:
• Turn the ignition off before fueling; an
inaccurate reading results if the engine
is left running.
• Use the same fill rate
(low-medium-high) each time the tank
is filled.
• Allow no more than two automatic
click-offs when filling.
Results are most accurate when the filling
method is consistent.
135
Escape (TM2), enUSA, First Printing Fuel and RefuelingE154765
Ford part number /
Ford specification
Ford part name or
equivalent
Capacity
Item
XO-5W20-QFS orXO-5W20-QSP (U.S.);
Motorcraft SAE 5W-
20 Full Synthetic Motor Oil or
4.3 qt (4.1 L)
Engine oil
1.6L EcoBoost
5.7 qt (5.4 L)
Engine oil
CXO-5W20-LFS12 or
CXO-5W20-LSP12 (Canada) /
Motorcraft SAE 5W-
20 Premium
Synthetic Blend Motor Oil
2.5L
WSS-M2C945-A
VC-3DIL-B (U.S.);
Motorcraft Orange
Antifreeze / Coolant Prediluted
9.7 qt (9.2 L)
Engine coolant 5
2.0L EcoBoost CVC-3DIL-B
(Canada) /
8.5 qt (8 L)
Engine coolant 5
WSS-M97B44-D2
1.6L EcoBoost
9.2 qt (8.7 L)
Engine coolant 5
2.5L
ZC-32-B2 (U.S.)
Motorcraft Premium
Windshield Washer
Concentrates (U.S.)
Fill as required
Windshield
washer fluid / WSS-M14P19-A
CXC-37-(A, B, D, and F) (Canada)
Premium Quality
Windshield Washer Fluid (Canada) / WSS-M14P19-A
–
–
15.5 gal (58.5 L)
Fuel tank
YN-19 (U.S.); CYN-16-R(Canada) /WSH-M17B19-A
Motorcraft R-134a
Refrigerant
1.5 lb (0.68 kg)
A/C refrigerant
1.6L EcoBoost and 2.5L
269
Escape (TM2), enUSA, First Printing Capacities and Specifications
