2015 FIAT BRAVO cooling

FAN SPEED ADJUSTMENT
To ventilate the passenger compartment properly,
proceed as follows:
❒fully open the central and side air diffusers;
❒ turn knob A to the blue section;
❒ turn knob C to the required speed;
❒ turn knob E to
;
❒ turn off internal air recirculation (LED on button
off ).
INTERNAL AIR RECIRCULATION
ACTIVATION
Press button
: when the function is on, the
button LED lights up. It is advisable to switch the
internal air recirculation on while standing in queues
or in tunnels to prevent the introduction of polluted
air. However, it is better not to use the function
for long periods, particularly if there are many people
on board, to prevent the windows from misting.
IMPORTANT Internal air recirculation makes it
possible to reach the required heating or cooling
conditions more quickly depending on the mode
selected. Do not use the internal air recirculation
function on rainy/cold days as it would considerably
increase the possibility of the windows misting. ADDITIONAL HEATER
(for versions/markets, where provided)
This device warms up the passenger compartment
more quickly when it is very cold and the engine
coolant temperature is low.
The additional heater comes on automatically when
the engine is started, if knob A is turned to the
last red sector and the fan (knob C) is at least at the
first speed level.
The heater switches off automatically when the
required comfort conditions are achieved.
IMPORTANT The heater will not turn on if the
battery voltage is too low.
41GETTING TO
KNOW YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

HEATED REAR WINDOW AND DOOR
MIRRORS DEMISTING/DEFROSTING
Press button
to activate this function: when this
function is activated, the button LED
lights up.
This function is timed and will deactivate
automatically after 20 minutes. Press the button
again to switch the function off in advance.
IMPORTANT Do not apply stickers on the inside of
the rear window over the heating filaments to avoid
damage.
FAN SPEED ADJUSTMENT
To ventilate the passenger compartment properly,
proceed as follows:
❒ fully open the central and side air diffusers;
❒ turn knob A to the blue section;
❒ turn knob C to the required speed;
❒ turn knob E to
;
❒ turn off internal air recirculation (LED on button
off ).
INTERNAL AIR RECIRCULATION
ACTIVATION
Press button
: when the function is on, the
button LED lights up. It is advisable to switch the internal air recirculation
on while standing in queues or in tunnels to prevent
the introduction of polluted air. However, it is better
not to use the function for long periods, particularly
if there are many people on board, to prevent the
windows from misting.
IMPORTANT Internal air recirculation makes it
possible to reach the required heating or cooling
conditions more quickly depending on the mode
selected. It is not advisable to switch the internal air
recirculation on when it is rainy/cold or the windows
might steam up, especially if the climate control
system is not turned on.
CLIMATE CONTROL SYSTEM (cooling)
Proceed as follows:
❒
turn knob A to the blue section;
❒ turn knob C to the required speed;
❒ turn knob F to
;
❒ press
and
buttons (button LEDs on).
Cooling adjustment
Proceed as follows:
❒ deactivate thebutton (LED on button off );
❒ turn knob A rightwards to increase the
temperature;
❒ turn knob C leftwards to reduce the fan speed.
44GETTING TO
KNOW YOUR CAR
SAFETY
STARTING AND DRIVING
WARNING LIGHTS AND MESSAGES
IN AN EMERGENCY SERVICING ANDMAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

IMPORTANT Press
to introduce air from the
outside (in this case the LED on the button should be off ). ACTIVATION OF INTERNAL AIR RECIRCULATION AND ENABLEMENT OFAQS FUNCTION (Air Quality System) Press button
. Internal air recirculation is carried
out according to three possible operating modes: ❒
automatic control, signalled by the AQS sign on the display and the LED on button
being
off;
❒
forced deactivation (internal air recirculationalways off with introduction of outside air),indicated by the LED on button
being off;
❒
forced activation (internal air recirculation alwayson), signalled by the LED on button
being lit.
When OFF button is pressed, the climate controlsystem automatically activates internal airrecirculation (the LED on button T should be on). Itis still possible to activate outside air recirculation(LED on the button off ) and vice versa, by pressingbutton T. With the OFF button pressed (LED on the button is lit up), it is not possible to enable the AQS (AirQuality System) function.
IMPORTANT Internal air recirculation makes itpossible to reach the required heating or coolingconditions more quickly depending on the modeselected. It is not advisable to switch the internal airrecirculation on when it is rainy/cold to preventthe windows from misting, especially if the climatecontrol system has not been activated. It is advisableto switch the internal air recirculation on whilstqueuing or in tunnels to prevent the introduction ofpolluted air. Do not use the function for a longtime, particularly if there are several passengers onboard, to prevent the windows from misting. AQS (Air Quality System) function activation The AQS function (AQS sign on the display) automatically activates internal air recirculation whenthe outside air is polluted (e.g. in traffic queues andtunnels). IMPORTANT With the AQS function active, after approx. 15 consecutive minutes of the internalair recirculation system functioning, the climatecontrol system enables the intake of outside air forapproximately 1 minute to freshen the air in thepassenger compartment. This takes place regardlessof the pollution level of the outside air.
49GETTING TOKNOW YOUR CAR SAFETYSTARTING AND DRIVING WARNING LIGHTS AND MESSAGES IN AN EMERGENCYSERVICING AND MAINTENANCE TECHNICAL SPECIFICATIONS INDEX
(for versions/markets, where provided)(for versions/markets, where provided)

CAR INACTIVITYIf the car is to be left inactive for longer than a
month, the following precautions should be
observed:
❒park the car in covered, dry and if possible
well-ventilated premises and slightly open
the windows;
❒ engage a gear and disengage the handbrake;
❒ disconnect the negative battery terminal and check
charge (see paragraph “Battery - Charge and
electrolyte level check” in chapter “Maintenance
and care”);
❒ clean and protect the painted parts using
protective wax;
❒ clean and protect the shiny metal parts using
special compounds available commercially;
❒ sprinkle talcum powder on the rubber windscreen
and rear window wiper blades and lift them off the
glass; ❒
cover the car with a cloth or perforated plastic
sheet. Do not use sheets of non-perforated plastic
as they do not allow moisture on the car body
to evaporate;
❒ inflate tyres to +0.5 bar above the standard
specified pressure and check it at intervals;
❒ do not drain the engine cooling system.
IMPORTANT Where relevant, switch off the car
alarm with the remote control.
145GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

Dashboard fuse boxFUSEAMPS
Radio and radio navigator /Radio setup//Blue&Me
TM
system/Alarm siren (CSA)/Alarm system on roof light/
Internal cooling unit/Tyre pressure monitoring system
control unit (CPP)/Diagnosis socket connector/Rear
roof lights F39
10
Heated rear window F4030
Electric door mirror demisters/Demisters on
windscreen jets F41
7,5
Windscreen wiper/Bi-directional windscreen/rear
window washer electric pump system on steering
column stalk F43
30
Current sockets/Cigar lighter F4415
Electric sun roof motor F4620
Front electric window (driver side) F4720
Front electric window (passenger side) F4820
Emergency control panel (lighting)/Right branch central
control panel (lighting, ASR switch) and left branch/
Steering wheel controls (lighting)/Control panel on
front roof light (lighting)/Volume sensing alarm system
control unit (deactivation)/Electric sun roof system
(control unit, control lighting)/Rain sensor/Dusk sensor
on rear view mirror/Heating pad activation controls on
front seats F49
5
194GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND DRIVING
WARNING LIGHTS AND MESSAGES
IN AN
EMERGENCY
SERVICING AND MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

Dashboard fuse boxFUSEAMPS
Internal cooling unit/Radio setup/Cruise Control lever/
Blue&Me
TM
system control unit/Parking sensor control
unit (NSP)/Air pollution sensor (AQS)/Automatic
climate control system/Electric door mirrors
(adjustment, folding)/Tyre pressure monitoring system
control unit (CPP) F51
5
Rear window wiper F5215
Instrument Panel (NQS) F537,5
195GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

WASHER FLUID FOR WINDSCREEN/
REAR WINDOW/HEADLIGHTS
If the level is too low, raise reservoir cap E (see
previous pages) and add the fluid described in the
chapter "Technical Specifications".
WARNING
Do not travel with the windscreen
washer reservoir empty: the windscreen
washer is essential for improving visibility. Some
commercial windscreen washer additives are
flammable.The engine compartment contains
hot components which may set it on fire. ENGINE COOLANT
The coolant level must be checked when the engine
is cold and must range between the MIN and MAX
marks on the reservoir.
If the level is too low, undo reservoir cap F (see
previous pages) and add the fluid described in the
chapter "Technical Specifications".
PARAFLU
UP
antifreeze is used in the
engine cooling system. Use the same fluid
as in the cooling system when topping
up. PARAFLU
UP
cannot be mixed with any other
type of fluid. If this happens, do not start the
engine; contact a Fiat Dealership.
WARNING
The cooling system is pressurised. If
necessary, replace the cap with another
of equivalent quality and the same
specifications as the original, otherwise the
efficiency of the system may be adversely
affected. Do not remove the reservoir cap when
the engine is hot : you risk scalding yourself.
211GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

REFUELLING
1.6 MultiJet2.0 MultiJet (*)Prescribed fuels and
original lubricants
Fuel tank (litres): 5858
Diesel for motor vehicles
(EN 590 Specification)
including a reserve of
(litres): 8÷10
8÷10
Engine cooling system
(litres): 7,1
7,1Mixture of demineralised
water and
50% PARAFLU
UP
(**)
Engine sump (litres):
4,34,3
SELENIA WR FORWARD
Engine sump and filter
(litres): 4,6
4,9
Gearbox/differential casing
(litres): 1,87
1,87TUTELA TRANSMISSION
GEARFORCE
Hydraulic brake circuit with
ABS: 0,56
0,56TUTELA TOP 4
Windscreen and rear
window washer fluid
reservoir (litres): 3 (6)
3 (6)Mixture of water and
TUTELA PROFESSIONAL
SC35(**) For particularly harsh climate conditions, a mixture of 60% PARAFLU
UP
and 40% demineralised water is recommended.
(*) For versions/markets, where provided
242GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND DRIVING
WARNING LIGHTS AND MESSAGES
IN AN EMERGENCY SERVICING ANDMAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX