Adding Fluid...................... .375, 376
Fluid And Filter Changes ..................376
Fluid Change ......................... .376
Fluid Level Check ...................... .375
Fluid Type ........................... .400
Gear Ranges .......................... .233
Special Additives ...................... .375
Autostick .............................. .238
Battery ................................ .355
Jump Starting ......................... .329
Keyless Transmitter Replacement (RKE) ........18
Belts, Seat ...............................76
Body Mechanism Lubrication .................360
B-Pillar Location ......................... .263
Brake Assist System ...................... .250
Brake Fluid ......................... .398, 400
Brake, Parking .......................... .244
Brakes ................................ .371Brake System
........................ .248, 371
Anti-Lock (ABS) ....................... .248
Master Cylinder ....................... .372
Parking ............................. .244
Warning Light ........................ .143
Brake/Transmission Interlock .................231
Bulb Replacement ..................... .392, 393
Bulbs, Light .......................... .78, 392
Capacities, Antifreeze (Engine Coolant) ..........397
Capacities, Fluid ......................... .397
Caps, Filler Fuel ................................ .297
Oil (Engine) ....................352, 353, 402
Carbon Monoxide Warning ................75, 296
Cargo Area Features ...................... .133
Car Washes ............................ .377
CD (Compact Disc) Player ...................177
Cellular Phone .......................... .206
10
INDEX 421
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENTSpecial design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.
