2015 FIAT 500 bulb

Indicator Light (MIL)” is functioning and is not on when
the engine is running, and that the OBD II system is
ready for testing.
Normally, the OBD II system will be ready. The OBD II
system maynotbe ready if your vehicle was recently
serviced, recently had a dead battery or a battery replace-
ment. If the OBD II system should be determined not
ready for the I/M test, your vehicle may fail the test.
Your vehicle has a simple ignition actuated test, which
you can use prior to going to the test station. To check if
your vehicle’s OBD II system is ready, you must do the
following:
1. Cycle the ignition switch to the ON position, but do not crank or start the engine.
NOTE: If you crank or start the engine, you will have to
start this test over. 2. As soon as you cycle the ignition switch to the ON
position, you will see the Malfunction Indicator Light
(MIL) symbol come on as part of a normal bulb check.
3. Approximately 15 seconds later, one of two things will happen:
• The MIL will flash for about 10 seconds and then
return to being fully illuminated until you turn OFF
the ignition or start the engine. This means that your
vehicle’s OBD II system is not readyand you should
not proceed to the I/M station.
• The MIL will not flash at all and will remain fully
illuminated until you place the ignition in the off
position or start the engine. This means that your
vehicle’s OBD II system is readyand you can proceed
to the I/M station.
If your OBD II system is not ready,you should see your
authorized dealer or repair facility. If your vehicle was
348 MAINTAINING YOUR VEHICLE

REPLACEMENT BULBS
Interior Bulbs
Bulb Number
Overhead Lamp C5W
Courtesy Lamp W5W
Exterior Bulbs
Bulb Number
Front Low and High Beam Headlamp HIR2LL
Front Parking/Daytime Running Lamps W21/5W
Front Fog Lamps H11LL
Front Side Marker Lamps W3W
Front Turn Signal Lamps WY21W
Side Direction Lamps WY5W
Rear Turn Signal Lamps PY21W
Rear Side Marker Lamps W3W
392 MAINTAINING YOUR VEHICLE

Bulb Number
Rear Tail and Stop Lamps P21/5W
Rear Backup Lamps W16W
Center High Mounted Stop Lamp W5W
License Plate Lamps LED (See Authorized dealer)
NOTE: Numbers refer to commercial bulb types that can be purchased from your authorized dealer.
If a bulb needs to be replaced, visit your authorized dealer or refer to the applicable Service Manual.
BULB REPLACEMENT
NOTE: Lens fogging can occur under certain atmo-
spheric conditions. This will usually clear as atmospheric
conditions change to allow the condensation to change
back into a vapor. Turning the lamps on will usually
accelerate the clearing process.
Headlamps Low Beam and High Beam
1. Remove the plastic cap from the back of the headlamp housing.
2. Rotate the bulb counter-clockwise.
3. Remove the bulb and replace as needed.
4. Install the bulb and rotate clockwise to lock in place.
5. Reinstall the plastic cap.7
MAINTAINING YOUR VEHICLE 393

Front Turn Signal, Parking And Daytime Running
Lamps
1. Turn the steering wheel completely to the left or right.
2. Open the wheel housing access door.3. Remove the plastic cap from the back of the lamp
housing.
4. Rotate bulb/socket counter-clockwise.
5. Remove the bulb and replace as needed.
6. Install the bulb into socket, and rotate bulb/socket clockwise into lamp locking it in place.
7. Reinstall the plastic cap.
Front Fog Lamps
To replace the front fog lights, see your authorized dealer.
Wheel Housing Access Door
394 MAINTAINING YOUR VEHICLE

Front/Rear Side Marker Lamps
1. Remove portion of the wheel liner to allow handaccess to side marker lamp.
2. Rotate the bulb socket counterclockwise, and remove the bulb and socket assembly from the housing.
3. Pull the bulb from the socket and insert the replace- ment bulb.
4. Install the bulb and socket assembly into the housing, and rotate the socket clockwise to lock it in place.
5. Reinstall the wheel liner.
Rear Tail, Stop, Backup And Turn Signal Lamps
1. Open the liftgate.
2. Remove the two screws and remove the tail lamp assembly.
Tail Lamp Assembly Screws
7
MAINTAINING YOUR VEHICLE 395

3. Remove four screws and separate the backplate fromthe lamp housing.
4. Remove the tail, stop, or turn signal bulbs by pushing them slightly and turning counter-clockwise.
5. Remove the backup lamp bulb by pulling straight out.
6. Replace lamps as required and reinstall lamp.
Center High Mounted Stop Lamp (CHMSL)
1. Remove the two guard caps and the two fastening screws.
2. Remove the center high mounted stop lamp assembly. 3. Disconnect the electric connector.
4. Press the retaining device and open the bulb holder.
5. Remove the snap-fitted bulb to be replaced and re-
place it.
6. Close the back cap locking it properly.
7. Reinstall the two fastening screws and reinstall the guard caps.
396 MAINTAINING YOUR VEHICLE

Adding Fluid...................... .375, 376
Fluid And Filter Changes ..................376
Fluid Change ......................... .376
Fluid Level Check ...................... .375
Fluid Type ........................... .400
Gear Ranges .......................... .233
Special Additives ...................... .375
Autostick .............................. .238
Battery ................................ .355
Jump Starting ......................... .329
Keyless Transmitter Replacement (RKE) ........18
Belts, Seat ...............................76
Body Mechanism Lubrication .................360
B-Pillar Location ......................... .263
Brake Assist System ...................... .250
Brake Fluid ......................... .398, 400
Brake, Parking .......................... .244
Brakes ................................ .371Brake System
........................ .248, 371
Anti-Lock (ABS) ....................... .248
Master Cylinder ....................... .372
Parking ............................. .244
Warning Light ........................ .143
Brake/Transmission Interlock .................231
Bulb Replacement ..................... .392, 393
Bulbs, Light .......................... .78, 392
Capacities, Antifreeze (Engine Coolant) ..........397
Capacities, Fluid ......................... .397
Caps, Filler Fuel ................................ .297
Oil (Engine) ....................352, 353, 402
Carbon Monoxide Warning ................75, 296
Cargo Area Features ...................... .133
Car Washes ............................ .377
CD (Compact Disc) Player ...................177
Cellular Phone .......................... .206
10
INDEX 421

Keys...................................11
Key, Sentry (Immobilizer) ....................13
Lane Change Assist ....................... .109
Lap/Shoulder Belts .........................29
Latches .................................78
Hood ............................... .104
Lead Free Gasoline .....................292, 293
Leaks, Fluid ..............................78
Life Of Tires ............................ .278
Liftgate (Sedan) ...........................25
Light Bulbs .......................... .78, 392
Lights .............................. .78, 106
AirBag .........................51, 76, 143
Anti-Lock ............................ .143
Brake Assist Warning ....................255
Brake Warning ........................ .143
Bulb Replacement ...................... .393
Check Engine (Malfunction Indicator) .........143Engine Temperature Warning
...............143
Exterior ...............................78
Fog ................................ .143
High Beam ....................... .107, 143
High Beam Indicator .....................143
Low Fuel ............................ .143
Oil Pressure .......................... .143
Park ............................... .107
Passing ............................. .107
Seat Belt Reminder ..................... .143
Service .............................. .393
Tire Pressure Monitoring (TPMS) ............143
Traction Control ....................... .255
Turn Signal ........................ .78, 108
Voltage ............................. .143
Warning (Instrument Cluster Description) ......143
Loading Vehicle Tires ............................... .263
10
INDEX 427