Trailer and Tongue Weight.................498
Wiring...............................503
Trailer Towing Guide.......................497
Trailer Weight............................497
Transaxle
Autostick.............................424
Transmission
Automatic............................413
Filter................................573
Fluid................................570
Transmitter Battery Service (Remote Keyless Entry) . .23
Transmitter, Garage Door Opener (HomeLink®). . . .253
Transmitter Programming (Remote Keyless Entry) . . .20
Transmitter, Remote Keyless Entry (RKE).........20
Transporting Pets.........................102
Tread Wear Indicators......................465
Trip Odometer...........................300
Turn Signals.............................226
UCI Connector...........................370
Uconnect®
Advanced Phone Connectivity..............140
Operation.............................123
Phone Call Features.....................130
Phone Features.........................135
Screen Activated Features..................21
Things You Should Know About Your Uconnect®
Phone...............................140
Uconnect® Settings.......................22
Uconnect® phone.........................120
Uconnect® Phone.........................146
Uconnect® Settings.........................21
Uconnect® Voice Command..................183
Underhood Fuses.........................585
Uniform Tire Quality Grades.................619
Universal Consumer Interface (UCI) Connector . . . .370
Universal Transmitter......................253
Unleaded Gasoline........................480
642 INDEX
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.
The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.