Replacement...........................439
Rotation..............................442
Safety...............................418
Sizes................................419
Snow Tires............................434
Spinning.............................438
Tread Wear Indicators....................438
Tire Safety Information.....................418
Tire Service Kit...........................467
To Open Hood...........................144
Towing................................461
Behind a Motorhome.....................461
Recreational...........................461
Towing Vehicle Behind a Motorhome...........461
Traction................................397
Traction Control..........................409
Trailer Towing...........................461
Transmission
Automatic............................374
Fluid................................519
Maintenance...........................519
Shifting..............................374
Transmitter Battery Service (Remote Keyless Entry) . .24
Transmitter Programming (Remote Keyless Entry) . . .24
Transmitter, Remote Keyless Entry (RKE).........21
Transporting Pets..........................94
Tread Wear Indicators......................438
Trip Odometer...........................251
Trunk Lid (Deck Lid).......................42
Trunk Release, Emergency....................44
Trunk Release Remote Control.................42
Turn Signals.............................150
UCI Connector...........................333
Uconnect®
Customer Programmable Features...........297
Operation.............................332
Uconnect® Settings.......................22
10
INDEX 589
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.
The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.
