2015 DODGE CHALLENGER SRT warning

[x] Cancel search: warning

Page 478 of 575

DODGE CHALLENGER SRT 2015 3.G Owners Manual Maintenance-Free Battery
Your vehicle is equipped with a maintenance-free battery.
You will never have to add water, nor is periodic main-
tenance required.
NOTE:The battery is stored under an access

Page 479 of 575

DODGE CHALLENGER SRT 2015 3.G Owners Manual WARNING!(Continued)
over a battery when attaching clamps. If acid
splashes in eyes or on skin, flush the area imme-
diately with large amounts of water.
• Battery gas is flammable and explosive. Kee

Page 480 of 575

DODGE CHALLENGER SRT 2015 3.G Owners Manual test. Drive belt tension should also be checked at this
time.
WARNING!
•Use only refrigerants and compressor lubricants
approved by the manufacturer for your air condi-
tioning system. Some unapprov

Page 484 of 575

DODGE CHALLENGER SRT 2015 3.G Owners Manual Adding Washer Fluid
The windshield washer fluid reservoir is located in the
front of the engine compartment. Be sure to check the
fluid level in the reservoir at regular intervals. Fill the
reservoir

Page 485 of 575

DODGE CHALLENGER SRT 2015 3.G Owners Manual have an authorized technician inspect the complete ex-
haust system and adjacent body areas for broken, dam-
aged, deteriorated, or mispositioned parts. Open seams
or loose connections could permit ex

Page 487 of 575

DODGE CHALLENGER SRT 2015 3.G Owners Manual NOTE:Your vehicles exhaust system may be equipped
with an Electronic Exhaust Valve (EEV) system, if the
exhaust system is replaced with aftermarket products a
Malfunction Indicator Lamp (MIL) may be i

Page 491 of 575

DODGE CHALLENGER SRT 2015 3.G Owners Manual Cooling System Pressure Caps
The cap must be fully tightened to prevent loss of engine
coolant (antifreeze), and to ensure that engine coolant
(antifreeze) will return to the radiator from the coolant

Page 493 of 575

DODGE CHALLENGER SRT 2015 3.G Owners Manual •If frequent engine coolant (antifreeze) additions are
required, the cooling system should be pressure tested
for leaks.
• Maintain engine coolant (antifreeze) concentration at a
minimum of 50% OA