2015 Citroen NEMO RHD height

65
Seat cushion height
To adjust the height of the driver's seat
cushion, pull the control upwards as many
times as necessary to raise.
To lower, push the control downwards as
many times as necessary.
Forwards-backwards adjustmentHeated seat control
Press the control.
The temperature is controlled automatically.
Pressing a second time stops operation.
Lift the control bar and slide the seat
forwards or backwards to the required
position.
Lumbar support
Seat back angle
Turn the control to adjust the angle of the
seat back. Turn the control.
Armrest
The driver's seat may be fitted with an
armrest on the centre console side.
Raise or lower completely the armrest to
obtain the most comfortable driving position.
4
EASE OF USE and COMFORT
Seats

78
LOAD SPACE FITTINGS
Stowing rings
There are 6 stowing rings on the rear floor to
secure your loads.
a
s a safety precaution in case of sharp
braking, you are advised to place
heavy objects as far forwards towards the
driver's seat as possible.
Storage pocket
A storage pocket is provided at the rear left
of the load space.
Torch
A magnetic torch is provided at the rear right
of the load space.
Remove the torch from its base by
pressing the button then pivoting the torch
downwards by 90 degrees.
To switch on the torch, slide the switch
forwards.
To change the 4 rechargeable batteries
(
n iMH type), remove the protective cover
from the torch.
To put the torch back in place, engage
it in the notches on the base and pivot it
upwards.
Ladder type vertical partition
behind the driver's seat, a ladder type
vertical partition protects the driver against
the risk of load movement.
Partitions
Panel, glazed, mid-height panel with grille
and modular vertical grille type partitions are
available for your light van.
Carrying passengers in the load space
is not permitted.
It is advisable to immobilise the load
by securing it firmly using the stowing
rings on the floor. The torch's storage batteries recharge
automatically while driving.
a

n additional lamp is fitted in the middle
of the torch housing (refer to the "Interior
lighting" section).
Practical information

135
RÖMER BabySafe Plus ISOFIX
(size category E )
Group 0+: up to 13 kg
It is installed in the rearward facing position using an ISOFIX base which attaches
to the rings A .
The support leg for the ISOFIX base must be adjusted in height so that it is contact with the floor of the vehicle.
RÖMER Duo Plus ISOFIX
(size category B1)
Group 1: from 9 to 18 kg
It is installed in the forward facing position.
It is fitted with an upper strap that is attached to the
ISOFIX upper ring,
called the T
o

P TETHER.
Three angles for the shell: sitting, inclined and lying positions.
This child seat can also be used on seats which are not fitted with ISOFIX mountings.
In this case, it must be attached to the vehicle seat using the three-point seat belt.
Follow the instructions for fitting the child seat given in the seat man\
ufacturer's installation guide.
ISOFIX CHILD SEAT RECOMMENDED BY CITROËN AND APPROVED FOR YOUR VEHICLE (C OMBI )
6
SAFETY
Child safety

168
Table of dashboard fuses, driver's sideMarking RatingFunctions
F12 7.5
a
Right-hand dipped beam headlamp supply
F13 7.5

a
Left-hand dipped beam headlamp supply - headlamp height

adjuster
F31 5
a
Engine control unit supply switch
F32 7.5

a
Front lamp - front courtesy lamp - rear courtesy light lamp
F36 10

AAudio system - mobile telephone pre-equipment - air
conditioning control panel - EODB diagnostic socket
F37 5
a
Brake lamp - instrument panel
F38 20

a
Door locking
F43 15

AScreenwash pump
F47 20
ad
river's electric window motor supply
F48 20
a
Passenger's electric window motor supply
F49 5

a
Parking sensors control unit - rear lighting switch - electric

door mirrors - volumetric alarm control unit
F50 7.5
a
Airbags control unit
F51 7.5

a
Switch on brake pedal - switch on clutch pedal - door mirror

controls - central Bluetooth system
F53 5
a
Instrument panel - rear foglamps
Changing a fuse

175
DIMENSIONS
The light van "L1" is the standard model, the "L2 - Worksite Pack" version is a model sold according to country:Light van (in mm)
L1 L2 (Worksite Pack)
L Overall length 3 8643 881
H Overall height 1 7211 742
Height with roof bars 1 7821 803
aWheelbase 2 513
bFront overhang760777
C Rear overhang 591
do

verall width 2 019
Width (with mirrors folded) 1 816
E Width of front track 1 4691 464
F Width of rear track 1 465
G Height of load sill 527544
I Length of interior floor 1 523
J Maximum interior load height 1 205
kMaximum interior width (10 cm from the floor)1 473
M Interior width between wheel arches 1 046
V

olume (m
3) 2.5
10
Dimensions
TECHNICAL DATA

177Combi (in mm)
Standard Raised
L Overall length 3 9593 970
H Overall height 1 7211 742
Height with roof bars 1 7821 803
aWheelbase 2 513
bFront overhang855866
C Rear overhang 591
do

verall width 2 019
Width (with mirrors folded) 1 816
E Width of front track 1 464
F Width of rear track 1 465
G Height of load sill 527544
I Length of interior floor (rear bench seat in place) 743
Length of interior floor (rear bench seat fully folded) 1 130
J Maximum interior load height (under rear shelf) 592
kMaximum interior width (10 cm from the floor)1 473
M Interior width between wheel arches 1 046
10
Dimensions
TECHNICAL DATA

179Combi (in mm)
Standard Raised
L Overall length 3 9593 970
H Overall height 1 7211 742
Height with roof bars 1 7941 803
aWheelbase 2 513
bFront overhang855866
C Rear overhang 591
do

verall width 2 019
Width (with mirrors folded) 1 816
E Width of front track 1 464
F Width of rear track 1 465
G Height of load sill 527544
I Length of interior floor (rear bench seat in place) 743
Length of interior floor (rear bench seat fully folded) 1 130
J Maximum interior load height (under rear shelf) 592
kMaximum interior width (10 cm from the floor)1 473
M Interior width between wheel arches 1 046
10
Dimensions
TECHNICAL DATA