2015 CITROEN DS3 CABRIO key battery

Following disconnection of the vehicle battery, replacement   of   the   remote   control   battery   or  
i

n   the   event   of   a   remote   control   malfunction,  
y

ou   can   no   longer   unlock,   lock   or   locate  
y

our vehicle.
F
 
F
irst   of   all,   use   the   key   in   the   lock   to   unlock  
o

r   lock   your   vehicle.
F
 
T
hen,   reinitialise   the   remote   control.
If
  the   problem   persists,   contact   a   CITROËN  
d

ealer   as   soon   as   possible.
Remote control problem
Reinitialisation
F Switch  off   the   ignition.
F  T urn   the   key   to   position   2 (Ignition).
F
 
P
ress   the   closed   padlock   immediately   for   a  
f

ew   seconds.
F
 
S
witch   off   the   ignition   and   remove   the   key  
f

rom   the   ignition   switch.
The
  remote   control   is   fully   operational   again.
Changing the battery
Battery ref.: CR1620 / 3 volts.F  U nclip   the   casing   by   inserting   a   coin   at   the  
n

otch   and   rotating.
F
 
S
lide   the   flat   battery   out   of   its   location.
F
 
S
lide   the   new   battery   into   its   location  
o

bserving   the   original   direction.
F
 
C
lip   the   casing   in   place,   then   the   chrome  
f

inisher.
F
 
R
einitialise   the   remote   control.
If the battery is flat, you are
informed
  by   lighting   of   this   warning  
l

amp   in   the   instrument   panel,   an   audible   signal  
a

nd   a   message   in   the   multifunction   screen.
F
 
U
nfold   the   key.
F
 
R
elease   the   chrome   finisher   by   pressing  
on
  lug   A.
F
 
M
aintain   pressure   on   lug   A   and   remove   the  
c

hrome   finisher   by   sliding   it   off   at   45°.

Activation
F Press button A  for   more   than   two   seconds.
A   confirmation   message   appears   on   the  
m

ultifunction   screen,   accompanied   by   an  
a

udible
 s
ignal.
deactivation
F Press button A   again   for   more   than  
two   seconds.
A
  confirmation   message   appears   on   the  
m

ultifunction   screen,   accompanied   by   an  
a

udible
 s
ignal. To
  lock   or   unlock   the   doors   mechanically   in   the  
e

vent   of   a   central   locking   system   failure   or   flat  
b

attery.
Emergency control
Locking the driver's door
F Insert
  the   key   in   the   lock,   then   turn   it   to
the   left.
Unlocking the driver's door
F Insert   the   key   in   the   lock,   then   turn   it   to
the   right.
Locking the passenger's door
F Remove   the   black   cap,   on   the   edge   of   the  d
oor,   using   the   key.
F
 
I
nsert   the   key   in   the   cavity,   then   turn   it   fully.
F
 
R
emove   the   key   and   refit   the   cap.
Unlocking the passenger's door
F Pull  the   interior   door   opening   control.
In the event of a fault with the central
locking
 
system,
 
you
 
must
 
disconnect
 
t

he
 
battery
 
to
 
lock
 
the
 
boot
 
and
 
so
 
e

nsure
 
the
 
complete
 
locking
 
of
 
the
 
v

ehicle.
Driving
 
with
 
the
 
doors
 
locked
 
may
 m
ake
 
access
 
more
 
difficult
 
for
 
the
 
em

ergency
 ser

vices
 i

n
 a

n
 em

ergency.

75
boot
Opening
F After  unlocking   the   vehicle   using   the  r
emote   control   or   the   key,   press   the  
o

pening   control   and   raise   the   tailgate.
Closing
F Lower  the   tailgate   using   the   interior   grab  han
dle.
If
  the   tailgate   is   not   closed   correctly:
-
 
when the engine is running , this
warning   lamp   comes   on,   accompanied b

y   a   message   on   the   multifunction
 s

creen   for   a   few   seconds,
- when the vehicle is moving   (speed   above  6
  mph   (10   km/h)),   this   warning   lamp   comes  
o

n,   accompanied   by   an   audible   signal   and  
a

  message   on   the   multifunction   screen   for  
a

  few   seconds. System
  for   mechanical   unlocking   of   the   boot  
i

n   the   event   of   a   battery   or   central   locking  
m

alfunction.
Tailgate release
Unlocking
F Fold  back   the   rear   benchseat   to   gain  a
ccess   to   the   lock   from   inside   the   boot.
F
 
I
nsert   a   small   screwdriver   into   hole   A of the
lock
  to   unlock   the   tailgate.
Access

Stop & StartThe Stop & Start system puts the engine temporarily into standby - STOP mode - during stops in the traffic (red lights, traffic jams, or other...). The engine   restarts   automatically   -   START   mode   -   as   soon   as   you   want   to   move   off.   The   restart   takes   place   instantly,   quickly   and   silently.
Per fect
  for   urban   use,   the   Stop   &   Start   system   reduces   fuel   consumption   and   exhaust   emissions   as   well   as   the   noise   level   when   stationary.
Operation
Going into engine STOP mode
For your comfort, during parking manoeuvres,   STOP   mode   is   not  
a

vailable   for   a   few   seconds   after  
c

oming   out   of   reverse   gear.
STOP
  mode   does   not   affect   the  
f

unctionality of the vehicle, such as for
example,
  braking,   power   steering...
Never
  refuel   with   the   engine   in   STOP  
m

ode;   you   must   switch   off   the   ignition  
w

ith   the   key.
The "ECO" 
warning
 
lamp
 
comes
 o
n
 
in
 
the
 
instrument
 
panel
 
and
 
the
 
e

ngine
 
goes
 
into
 
standby:
-
 
w

ith a manual gearbox ,
 
at
 
speeds
 
below
 
1

2
 
mph
 
(20
 
km/h),
 
when
 
you
 
put
 
the
 
gear
 
l

ever
 
into
 
neutral,
 
and
 
you
 
release
 
the
 
c

lutch
 
pedal.
-
 
w

ith a 5 or 6-speed electronic gearbox ,
when
 
stationary
 
or
 
at
 
speeds
 
below
 
5
 
mph
 
(

8
 
km/h)
 
(depending
 
on
 
version),
 
when
 
you
 
p

ress
 
the
 
brake
 
pedal
 
or
 
put
 
the
 
gear
 
lever
 
i

n position N .
A
 
time
 
counter
 
calculates
 
the
 
sum
 o

f
 
the
 
periods
 
in
 
STOP
 
mode
 d

uring
 
a
 
journey.
 
It
 
rests
 
itself
 t

o
 
zero
 
every
 
time
 
the
 
ignition
 
is
 s

witched
 
on
 
with
 
the
 
key. STOP
  mode   is   not   invoked   when:
-  t he   driver's   door   is   open,
-
 
t
he   driver's   seat   belt   is   not   fastened,
-
 
t
he   vehicle   has   not   exceeded   6   mph  
(10
  km/h)   since   the   last   engine   start   using  
t

he   key,
-
 
t
he   engine   is   needed   to   maintain   a  
c

omfortable   temperature   in   the   passenger  
c

ompartment,
-
 
d
emisting   is   active,
-
 
s
ome   special   conditions   (battery   charge,  
e

ngine   temperature,   braking   assistance,  
a

mbient   temperature...)   where   the   engine   is  
n

eeded   to   assure   control   of   a   system.
Special cases: STOP mode not
available
The "ECO" warning   lamp   flashes   for  a
  few   seconds   then   goes   off.
This operation is perfectly normal.

The system is reactivated automatically at   every   new   start   using   the   key.
Reactivation
This system requires a battery with a special specification   and   technology   (reference  
n

umbers   available   from   a   CITROËN   dealer   or   a  
q

ualified
 w
orkshop).
Fitting
  a   battery   not   listed   by   CITROËN  
i

ntroduces   the   risk   of   malfunction   of   the  
s

ystem.
In
 
the
 
event
 
of
 
a
 
fault
 
with
 
the
 
system,
 
the
 
"

ECO OFF"
 
switch
 
warning
 
lamp
 
flashes
 
then
 
c

omes
 
on
 
continuously.
Have
 
it
 
checked
 
by
 
a
 
CITROËN
 
dealer
 
or
 
a
 
q

ualified
 w

orkshop.
In
 
the
 
event
 
of
 
a
 
fault
 
in
 
STOP
 
mode,
 
the
 
v

ehicle
 
may
 
stall.
 
All
 
of
 
the
 
instrument
 
panel
 
w

arning
 
lamps
 
come
 
on.
 
It
 
is
 
then
 
necessary
 
t

o
 
switch
 
off
 
the
 
ignition
 
and
 
start
 
the
 
engine
 
a

gain
 
using
 
the
 
key.
Operating fault Maintenance
Before doing anything under the b
onnet,   deactivate   the   Stop   &   Start  
s

ystem   to   avoid   any   risk   of   injury  
r

esulting   from   automatic   operation   of  
S

TART   mode.
The
  Stop   &   Start   system   makes   use  
o

f   advanced   technology.   All   work  
o

n   this   type   of   battery   must   be   done  
b

y   a   CITROËN   dealer   or   a   qualified  
w

orkshop.
Press the "ECO OFF"
 
switch
 
again.
The
 
system
 
is
 
active
 
again;
 
this
 
is
 
confirmed
 
b

y
 
the
 
switch
 
warning
 
lamp
 
going
 
off,
 
a

ccompanied
 
by
 
a
 
message
 
in
 
the
 
screen.