2015 CITROEN DS3 CABRIO bonnet

39
On vehicles fitted with an electric oil level indicator,   information   on   the   oil   level   is  
d

isplayed   in   the   instrument   panel   for   a   few  
s

econds   when   the   ignition   is   switched   on,   after  
t

he   service   information.
Engine oil level indicator*
The level shown will only be correct
if  the   vehicle   is   on   level   ground   and  
t

he   engine   has   been   off   for   more   than  
3

0 minutes.
Oil level correct
Oil level low
This is indicated by the flashing of " O I L" ,
a ccompanied   by   illumination   of   the   service  
w

arning   lamp,   an   audible   signal   and   a  
m

essage.
If
  the   low   oil   level   is   confirmed   by   a   check   using  
t

he   dipstick,   the   level   must   be   topped   up   to  
p

revent   damage   to   the   engine.
Refer
  to   the   "Checking   levels"   section.
Oil level indicator fault
This is signaled by the flashing of "OIL- -".
C ontact   a   CITROËN   dealer   or   a   qualified  
w

orkshop.
In the event of a fault with the electric oil level
indicator,
  the   engine   oil   level   is   no   longer  
mon

itored.
While
  the   system   is   faulty,   you   should   check  
t

he   engine   oil   level   using   the   manual   dipstick  
l

ocated   under   the   bonnet.
Refer
  to   the   "Checking   levels"   section.
*
  Depending   on   version.
Monitoring

Travelling abroad
LEd / Xenon front lamps
For motoring in countries that drive on the other s
ide   of   the   road,   it   is   necessary   to   adapt   the  
a

djustment   of   the   dipped   beams   so   as   to   not  
d

azzle   the   drivers   of   approaching   vehicles.
F
 
R
aise   the   bonnet   for   access   to   the   adjuster  
(

one   adjuster   per   headlamp).
F
 
I
nsert   a   suitable   allen   key   (not   supplied)  
i

nto   the   hexagonal   head   of   the   adjuster.
F
 
T
urn   the   allen   key   half   a   turn   clockwise.
Headlamp adjustment
To avoid causing a nuisance to other road u
sers,   the   height   of   the   headlamps   should   be  
a

djusted   in   relation   to   the   load   in   the   vehicle.
0.
 
D
river   only   or   driver   +   front   passenger.
-.
 I

ntermediate
 s
etting.
1.
 5

  people.
-.
 
5
  people   +   load   in   the   boot.
2.
 D

river   only   +   maximum   authorised   load   in  
t

he   boot.
This
  position   is   sufficient   to   avoid   causing  
d

azzle.
Higher
  settings   may   limit   the   spread   of   light  
f

rom   the   headlamps.
The
  initial   setting   is   position   "0". On
  your   return,   don't   forget   to   return  
y

our   headlamps   to   their   initial   setting,  
b

y   carrying   out   these   operations   in  
r

everse
 o
rder.

Operating fault
If an automatic wiping fault occurs, the wipers will   operate   in   intermittent   mode.
Have
  it   checked   by   a   CITROËN   dealer   or   a  
q

ualified
 w
orkshop. To retain the effectiveness of the flat
wiper
  blades,   it   is   advisable   to:
-
 
h
andle   them   with   care,
-
 
c
lean   them   regularly   using   soapy  
w

ater,
-
 
n
ot   use   them   to   hold   a   sheet   of  
c

ardboard   against   the   windscreen,
-
 
r
eplace   them   at   the   first   signs   of  
w

e a r.
Do
  not   cover   the   rain   sensor,   linked  
w

ith   the   sunshine   sensor   and   located   in  
t

he   centre   of   the   windscreen   behind   the  
r

ear   view   mirror.
Switch
  off   the   automatic   wiping   when  
u

sing   an   automatic   car   wash.
In
  winter,   it   is   advisable   to   wait   until   the  
w

indscreen   is   completely   clear   of   ice  
b

efore   activating   the   automatic   wiping.This
  position   allows   the   wiper   blades   to  
b

e   lifted   for   winter   parking,   cleaning   or  
r

eplacement   without   damaging   the   bonnet.
In
  the   minute   following   switching   off   of   the  
i

gnition,   any   action   on   the   wiper   stalk   positions  
t

he   wipers   vertically.
To
  park   the   wipers   after   this   has   been   done,
 s

witch   on   the   ignition   and   operate   the   wiper   stalk.
Vertical windscreen wiper
position

163
Operating limits
The system only detects vehicles that are stationary   or   moving   in   the   same   direction   as  
y

our   vehicle.
It
  does   not   detect   small   vehicles  
(

bicycles,   motorcycles),   pedestrians   or  
a

nimals,   nor   non-reflective   stationary  
ob

jects. In
  difficult   weather   conditions   (very  
h

eavy   rain,   snow,   fog,   hail...),   braking  
d

istances   increase,   which   can   reduce  
t

he   ability   of   the   system   to   avoid   a  
c

ollision.
The
  driver   must   therefore   remain  
par

ticularly
 v
igilant.
Never
  leave   accumulations   of   snow   or  
a

ny   object   projecting   above   the   bonnet  
o

r   in   front   of   the   roof:   this   might   fall   into  
t

he   field   of   vision   of   the   sensor   and  
g

enerate   a   detection.
The
  system   is   not   triggered   or   is   interrupted   if  t
he d river:
-
 
a
ccelerates   strongly
-
 
o
r   turns   the   steering   wheel   suddenly  
(

avoiding
 m
anoeuvre).
Safety

197
Running out of fuel (Diesel)If your vehicle is fitted with an HDI engine, the fuel system must be primed if you run out of fuel.
T his   system   consists   of   a   priming   pump   and   a   transparent   pipe   under   the   bonnet.
F
 
F
ill   the   fuel   tank   with   at   least   five   litres   of  
D

iesel.
F
 
O
pen   the   bonnet.
F
 
D
epending   on   version,   unclip   the   cover   to  
g

ain   access   to   the   priming   pump.
F
 
S
queeze   and   release   the   priming   pump  
u

ntil   resistance   is   felt   (could   be   from   the  
f

irst   application)   and   fuel   appears   in   the  
t

ransparent   pipe   with   the   green   connector.
F
 
O
perate   the   starter   until   the   engine   starts.
F
 
D
epending   on   version,   put   the   cover   back  
i

n   position   and   clip   it   in   place.
F
 
C
lose   the   bonnet.
BlueHdi 100 engines
F Fill  the   fuel   tank   with   at   least   five   litres   of  D
iesel.
F
 
S
witch   on   the   ignition   (without   starting   the  
e

ngine).
F
 
W
ait   around   6   seconds   and   switch   off   the  
ig

nition.
F
 
R
epeat   the   operation   10   times.
F
 
O
perate   the   starter   to   run   the   engine.
If
 
the
 
engine
 
does
 
not
 
start
 
at
 
the
 
first
 
a

ttempt,
 
do
 
not
 
try
 
again.
Operate
 
the
 
priming
 
pump
 
again,
 
then
 
t

he
 
starter.
Practical information

235
batteryProcedure for charging your battery when it is flat or for starting the engine using another battery.T he   battery   is   located   under   the   bonnet.
To
  gain   access   to   it:
F
 
o
pen   the   bonnet   using   the   interior   release  
l

ever,   then   the   exterior   safety   catch,
F

s
ecure the bonnet stay,
F
 
l
ift   the   plastic   cover   on   the   (+)   terminal.
Access to the batteryAfter refitting the battery by a CITROËN   dealer   or   a   qualified  
w

orkshop,   the   Stop   &   Start   system  
w

ill only be active after a continuous
period
  of   immobilisation   of   the   vehicle,  
a

  period   which   depends   on   the   climatic  
c

onditions   and   the   state   of   charge   of  
t

he   battery   (up   to   about   8   hours).
The presence of this label, in particular
with
 
the
 
Stop
 
&
 
Start
 
system,
 
indicates
 
t

he
 
use
 
of
 
a
 
12
 
V
 
lead-acid
 
battery
 
with
 
s

pecial
 t

echnology
 a

nd
 s

pecification;
 t

he
 
involvement
 
of
 
a
 
CITROËN
 
dealer
 
o

r
 
a
 
qualified
 
workshop
 
is
 
essential
 
w

hen
 
replacing
 
or
 
disconnecting
 
the
 
b

attery.
Failure
 
t

o
 
o

bserve
 
t

his
 
r

ecommendation
 
m

ay
 
cause
 
premature
 
wear
 
of
 
the
 
b

attery.
Practical information

239
Changing a front or rear wiper bladeProcedure for replacing a worn wiper blade with a new one without the use of tools.
Before removing a front
wiper blade
F Within  one   minute   after   switching   off   the  i
gnition,   operate   the   wiper   stalk   to   position  
t

he   wiper   blades   in   the   vertical   position.
This
  position   must   be   used   in   order   to   avoid  
d

amaging   the   wiper   blade   and   the   bonnet.
Removal
F Raise  the   corresponding   wiper   arm.
F  U nclip   the   wiper   blade   and   remove   it.
Fitting
F At  the   front,   check   the   size   of   the   wiper  b
lade   as   the   shorter   blade   is   fitted   to   the  
p

assenger   side   of   the   vehicle.
F
 
P
ut   the   corresponding   new   wiper   blade   in  
p

lace   and   clip   it.
F
 
F
old   down   the   wiper   arm   carefully.
After fitting a front wiper
blade
F Switch  on   the   ignition.
F  O perate   the   wiper   stalk   again   to   park   the  
w

iper   blades.
Load reduction modeSystem which manages the use of certain functions   according   to   the   level   of   charge  
r

emaining   in   the   battery.
When
  the   vehicle   is   being   driven,   the   load  
r

eduction   function   temporarily   deactivates  
c

ertain   functions,   such   as   the   air   conditioning,  
t

he   heated   rear   screen...
The
  deactivated   functions   are   reactivated  
a

utomatically   as   soon   as   conditions   permit.
Practical information

251
bonnetProtects the components of the engine and provides access for checking levels.
Opening
F Open  the   front   left   door.
F P ull the interior release lever A ,
  located   at  
t

he   bottom   of   the   door   aperture.F
 P ush   the   exterior   safety   catch   B to the left
and
  raise   the   bonnet.
Before
 
doing
 
anything
 
under
 
the
 
b

onnet, switch off the Stop & Start
system
 
to
 
avoid
 
any
 
risk
 
of
 
injury
 
r

esulting
 
from
 
an
 
automatic
 
change
 
to
 
S

TART
 
mode.
The location of the interior release lever
prevents  opening   of   the   bonnet   while  
t

he   front   left   door   is   closed.
Checks