2015 Citroen C5 ignition

4
C5_en_Chap00b_vue-ensemble_ed01-2014
Exterior (Saloon)
Accessories 228-229
Panoramic sunroof 5 5
Roof bars

2
24
Changing bulbs

1
99 -202, 207
-

rear lamps
-


3rd brake lamp
-
number plate lamps
T
ailgate
5
2
Temporary puncture repair kit
1
88 -191
Changing a wheel
1
92-197
-

tools
-


removing
T

yre under-inflation detection

1

24-125
Braking assistance
1
56
Trajectory control
1
57-159
Tyre pressures

2

56
Snow chains

1

98 Fuel tank

1
83
Misfuel prevention
1
84
Remote control key

3

9 - 43
-

opening / closing
-


batteryIgnition switch / Steering lock / Starting 97- 9 9
Alarm 4 4- 46
Door mirrors

6
3
Very cold climate screen

2
26
Exterior lighting controls

1
42-146
Headlamp adjustment
1

47
Changing bulbs
1

99-202
-

front lamps
-


Xenon headlamps
-


foglamps
-


direction indicator repeaters
L

ane departure warning system

1
34
Stop & Start

1
21-123
D o o r s
4

9 - 51
-

opening / closing
-


central locking
-


emergency control
C

hild lock

1
82
Electric windows

4
7- 48 Front and/or rear visual and
audible
parking sensors
1
37-138
Towbar
2

22-223
Towing
2

20-221
O

19
C5_en_Chap01_controle-de-marche_ed01-2014
Trip computer, a few definitions
Range
(miles or km)
Current fuel consumption
(mpg or l/100 km or km/l)
Average fuel
consumption
(mpg or l/100 km or km/l)
Average speed
(mph or km/h)
Distance travelled
(miles or km)
The distance which can still be travelled
with the fuel remaining in the tank (related to
the average fuel consumption over the last
few

miles (kilometres) travelled).
When the range falls below 20 miles (30 km),
dashes are displayed. After filling with at least
5 litres of fuel, the range is recalculated and is
displayed when it exceeds 60 miles (100 km). Calculated over the last few seconds.
Calculated since the last trip computer reset.
Calculated since the last trip computer reset. Calculated since the last trip computer reset.
Stop & Start time
counter
(minutes / seconds or hours /
m inutes)
If your vehicle is fitted with Stop & Start, a time
counter calculates the time spent in STOP
mode during a journey.
It resets to zero every time the ignition is
switched on with the key.
This function is only displayed from
20

mph (30 km/h).
This value may vary following a change
in the style of driving or the relief,
resulting in a significant change in the
current fuel consumption.
If dashes are displayed continuously
while driving in place of the digits,
contact a CITROËN dealer or a
qualified workshop.
1
Monitoring

21
C5_en_Chap01_controle-de-marche_ed01-2014
Service indicator
More than 2 000 miles (3 000 km)
remain before the next service is
due
When the ignition is switched on, no service
information appears on the instrument panel
central screen.
Between 600 miles (1 000 km)
and 2 000 miles (3 000 km) remain
before the next service is due
For 7 seconds after the ignition is switched on, the
spanner symbolising the service operations comes
on. The instrument panel central screen indicates the
distance remaining before the next service is due.
Example: 1 900 miles remain before the next service
is due.
For 7 seconds after the ignition is switched on, the
central screen indicates:
Less than 600 miles (1 000 km)
remain before the next service is due
Example: 500 miles remain before the next
service is due.
For 7 seconds after the ignition is switched on,
the central screen indicates:
The spanner remains on in the screen to
indicate that a service must be carried out
soon.
Indicators
This information is displayed for a few seconds
when the ignition is switched on. It informs
the driver when the next service is due, in
accordance with the manufacturer's servicing
schedule.
The point at which the service is due is
calculated from the last indicator zero reset. It
is determined by two parameters:
-

t
he distance travelled,
-

t
he time elapsed since the last service.
1
Monitoring

22
C5_en_Chap01_controle-de-marche_ed01-2014
Service indicator zero resetService overdue
For 7 seconds after the ignition is switched
on, the spanner flashes to indicate that
the service must be carried out as soon as
possible.
Example: the service is overdue by 180 miles.
For 7 seconds after the ignition is switched on,
the central screen indicates:
The spanner remains on in the screen to
indicate that a service should have been
carried out. The distance remaining may be
weighted by the time factor, depending
on the driver's driving routine.
Therefore, the spanner may also come
on if you have exceeded the period
since the last service, indicated in the
manufacturer's service schedule.
After each service, the service indicator must
be reset to zero.
The procedure for resetting to zero is as
follows:
F

s
witch off the ignition,
F

p
ress and hold the trip distance recorder
zero reset button,
F

s
witch on the ignition; the distance recorder
display begins a countdown,
F

w
hen the display indicates "=0", release
the button; the spanner disappears.
Following this operation, if you wish to
disconnect the battery, lock the vehicle and
wait at least five minutes for the zero reset to
be taken into account.
Monitoring

24
C5_en_Chap01_controle-de-marche_ed01-2014
Engine oil temperature
gauge
Under normal operating conditions, the bars
should be within section 1.
In severe operating conditions, the bars may
extend into section 2 .
In this event, slow down, and if necessary,
stop the engine and check the levels (see
corresponding section).
Coolant temperature gauge
Under normal operating conditions, the bars
should be within section 1 .
In severe operating conditions, the bars
may extend into section 2 , the engine
coolant temperature warning lamp A and the
STOP


warning lamp come on, stop as soon
as it is safe to do so . Switch off the ignition.
The cooling fan may continue to operate for
a cer tain time .
Contact a CITROËN dealer or a qualified
workshop.
If the SERVICE warning lamp comes on, check
the levels (see corresponding chapter). On horizontal ground, illumination of the fuel
low warning lamp indicates that you are at the
reser ve level.
An alert message is displayed in the instrument
panel.
Fuel gauge
Monitoring

25
C5_en_Chap01_controle-de-marche_ed01-2014
Distance recordersLighting dimmer
F Press button A to decrease the brightness
of the instruments and controls.
F

P
ress button B to increase the brightness
of the instruments and controls.
Deactivation
When the lighting is off, or in day mode on
vehicles fitted with daytime running lamps,
pressing the buttons does not have any effect.
Total distance recorder
When traveling abroad, you may
have to change the units of distance:
the display of road speed must be in
the official units (miles or km) for the
country. The change of units is done via
the screen configuration menu, with the
vehicle stationary.
The total and trip distances are displayed for
thirty seconds when the ignition is switched off,
when the driver's door is opened and when the
vehicle is locked or unlocked.
System for manual adjustment of the
brightness of the instruments and controls in
relation to the exterior brightness.
Trip distance recorder
It measures the distance travelled since it was
reset to zero by the driver.
F

W
ith the ignition on, press the button until
zeros appear.
It measures the total distance travelled by the
vehicle since its first registration.
Operation
1
Monitoring

26
C5_en_Chap01_controle-de-marche_ed01-2014
Warning and indicator lamps
Warning/indicator lampis on Cause Action / Observations
STOP fixed, associated with
another warning lamp. It is associated with a punctured tyre
or the engine coolant temperature. Stop as soon as it is safe to do so.
Park, switch off the ignition and call a CITROËN
dealer or a qualified workshop.
Service temporarily. A minor fault has occurred for which
there is no specific warning lamp. Identify the fault by reading the message shown in the
screen, such as, for example:
-

t
he closing of the doors, boot, rear screen or
bonnet,
-

t
he remote control battery,
-

t
he tyre pressures,
-

s
aturation of the particle emission filter (Diesel).
For any other faults, contact a CITROËN dealer or a
qualified workshop.
fixed. A major fault has occurred for which
there is no specific warning lamp. Identify the fault by reading the message shown in the
screen and contact a CITROËN dealer or a qualified
workshop.
Visual indicators which inform the driver of the occurrence of a malfunction or fault (warning lamp)
or of the operation of a system (operation or deactivation indicator lamp).
When the ignition is switched on
Certain warning lamps come on for a few seconds when the ignition is switched on.
When the engine is started, these warning lamps should go off.
If they remain on, before moving off, refer to the information for the warning lamp concerned.
Associated warnings
The illumination, fixed or flashing, of certain warning lamps may be accompanied by an audible
signal and a message in the screen.
Warning lamps
When the engine is running or the vehicle is
being driven, the illumination of one of the
following warning lamps indicates a malfunction
or fault which requires action on the part of the
driver.
The illumination of a warning lamp is always
accompanied by the display of an additional
message, to assist you in identifying the fault.
If you encounter any problems, contact a
CITROËN dealer or a qualified workshop.
Monitoring

27
C5_en_Chap01_controle-de-marche_ed01-2014
Brakingfixed, associated with
the STOP warning
lamp. The braking system fluid level is too
low.
You must stop as soon as it is safe to do
so.
Top up with brake fluid recommended by CITROËN.
If the problem persists, have the system checked by a
CITROËN dealer or a qualified workshop.
+ fixed, associated with
the STOP and ABS
warning lamp.The electronic brake force distribution
(EBFD) system has a fault.
You must stop as soon as it is safe to do
so.
Have it checked by a CITROËN dealer or a qualified
workshop.
Warning
/indicator lampis on Cause Action / Observations
Anti-lock
Braking System
(ABS) fixed.
The anti-lock braking system has a
fault. The vehicle retains conventional braking.
Drive carefully at reduced speed and contact a
CITROËN dealer or a qualified workshop without
d e l ay.
Electric parking
brake flashing.
The electric parking brake is not
applied automatically.
The application/release is faulty. You must stop as soon as it is safe to do so.
Park on flat level ground, engage a gear (or place the
lever in position P for an automatic gearbox), switch
off the ignition and contact a CITROËN dealer or a
qualified workshop.
Electric parking
brake fault fixed.
The electric parking brake has a fault. Contact a CITROËN dealer or a qualified workshop
without delay.
For more information on the electric parking brake,
refer to the corresponding section.
1
Monitoring