2015 Citroen C4 PICASSO RHD engine

291
Exiting economy mode
These functions are reactivated automatically next   time   the   vehicle   is   driven.
F

I
n   order   to   restore   the   use   of   these  
f

unctions   immediately,   start   the   engine   and  
l

et   it   run:
-
 
f
or   less   than   ten   minutes,   to   use  
t

he   equipment   for   approximately  
f

ive minutes,
-
 
f
or   more   than   ten   minutes,   to   use   the  
e

quipment   for   up   to   approximately  
t

hirty
 m
inutes.
Let
  the   engine   run   for   the   duration   specified   to  
e

nsure   that   the   battery   charge   is   sufficient.
Do
  not   repeatedly   and   continuously   restart   the  
e

ngine   in   order   to   charge   the   battery.
A
  flat   battery   prevents   the   engine   from   starting  
(

refer   to   the   "Battery"   section).
Load reduction mode
System which manages the use of certain functions   according   to   the   level   of   charge  
r

emaining   in   the   battery.
When
  the   vehicle   is   being   driven,   the   load  
r

eduction   function   temporarily   deactivates  
c

ertain   functions,   such   as   the   air   conditioning,  
t

he   heated   rear   screen...
The
  deactivated   functions   are   reactivated  
a

utomatically   as   soon   as   conditions   permit.
Energy economy mode
Switching to economy mode
A message then appears in the instrument p
anel   screen   indicating   that   the   vehicle   has  
s

witched   to   economy   mode   and   the   active  
f

unctions   are   put   on   standby.
If
  a   telephone   call   is   being   made   at   this   time,  
i

t will   be   maintained   for   around   10   minutes  
w

ith   the   Bluetooth   hands-free   system   of   your  
a

udio system.
System
  which   manages   the   duration   of   use   of  
c

ertain functions to conserve a sufficient level
of   charge   in   the   battery.
After   the   engine   has   stopped,   you   can  
s

till   use   functions   such   as   the   audio   and  
t

elematics   system,   windscreen   wipers,   dipped  
b

eam   headlamps,   courtesy   lamps,   etc.   for  
a

  maximum   combined   duration   of   about  
f

orty
 m
inutes.
7
Practical information

293
Towing the vehicle
The towing eye is installed in the boot under the   floor.
To
  gain   access   to   it:
F

o
pen the boot,
F
 
l
ift   the   floor   and   remove   it,
F
 
r
emove   the   towing   eye   from   its   housing.
General recommendations
Observe the legislation in force in your country.
E nsure   that   the   weight   of   the   towing   vehicle   is   higher   than   that   of   the   towed   vehicle.
The
  driver   must   remain   at   the   wheel   of   the   towed   vehicle   and   must   have   a   valid   driving   licence.
When
  towing   a   vehicle   with   all   four   wheels   on   the   ground,   always   use   an   approved   towing  
a

rm;   rope   and   straps   are   prohibited.
The
  towing   vehicle   must   move   off   gently.
When
  towing   a   vehicle   with   the   engine   off,   there   is   no   longer   any   power   assistance   for  
b

raking   or   steering.
In
  the   following   cases,   you   must   always   call   on   a   professional   recovery   service:
-
 
v
ehicle   broken   down   on   a   motor way   or   fast   road,
-
 
f
our-wheel   drive   vehicle,
-
 
w
hen   it   is   not   possible   to   put   the   gearbox   into   neutral,   unlock   the   steering,   or   release  
t

he   parking   brake,
-
 
t
owing   with   only   two   wheels   on   the   ground,
-
 
w
here   there   is   no   approved   towing   arm   available...
Procedure
 
for
 
having
 
your
 
vehicle
 
towed
 
or
 
for
 
towing
 
another   vehicle   using   the   towing   eye.
Access to the tools
7
Practical information

294
Towing another vehicle
F On  the   rear   bumper,   unclip   the   cover   by  p
ressing   at   the   bottom.
F
 
S
crew   the   towing   eye   in   fully.
F
 
I
nstall   the   towing   bar.
F
 
S
witch   on   the   hazard   warning   lamps   on  
b

oth   vehicles.
F
 
M
ove   off   gently,   drive   slowly   and   for   a   short  
di

stance.
F
 O
n
 
the
 
front
 
bumper,
 
unclip
 
the
 
cover
 
by
 p
ressing
 
on
 
the
 
left.
F
 
S

crew
 
the
 
towing
 
eye
 
in
 
fully.
F
 
I

nstall
 
the
 
towing
 
bar.
F
 
P

lace
 
the
 
gear
 
lever
 
in
 
neutral
 
(position
 
N
on
 
an
 
electronic
 
or
 
automatic
 
gearbox).
Towing your vehicle
Failure to observe this instruction could r esult   in   damage   to   certain   components  
(

braking,   transmission...)   and   the  
a

bsence   of   braking   assistance   the   next  
t

ime   the   engine   is   started.
F
 
U

nlock   the   steering   by   turning   the   key  
i

n
  the   ignition   one   notch   and   release   the  
par

king
 b
rake.
F
 
S

witch   on   the   hazard   warning   lamps   on  
b

oth   vehicles.
F
 
M

ove   off   gently,   drive   slowly   and   for   a   short  
di

stance.
Practical information

298
Driving advice
Distribution of loads
F Distribute  the   load   in   the   trailer   so   that   the h
eaviest   items   are   as   close   as   possible   to t

he   axle   and   the   nose   weight   approaches   the
 m

aximum   permitted   without   exceeding   it.
Air
  density   decreases   with   altitude,   thus  
r

educing   engine   per formance.   Above  
1 0

00 metres,   the   maximum   towed   load   must  
b

e   reduced   by   10 %   for   every   1 000   metres   of  
al

titude.
Side wind
F Take   into   account   the   increased   sensitivity  t
o   side   wind.
Cooling
Towing a trailer on a slope increases the temperature   of   the   coolant.
As
  the   fan   is   electrically   controlled,   its   cooling  
c

apacity   is   not   dependent   on   the   engine   speed.
F
 
T
o   lower   the   engine   speed,   reduce   your  
s

peed.
The
  maximum   towed   load   on   a   long   incline  
d

epends   on   the   gradient   and   the   ambient  
t

emperature.
In
  all   cases,   keep   a   check   on   the   coolant  
t

emperature. F
 
I
f   the   warning   lamp   and   the  
S

TOP
 
warning   lamp   come   on,  
s

top   the   vehicle   and   switch   off  
t

he   engine   as   soon   as   possible.
Braking
Towing a trailer increases the braking distance.
T o   avoid   overheating   of   the   brakes   on   a   long  
m

ountain   type   of   descent,   the   use   of   engine  
b

raking   is   recommended.
Ty r e s
F Check   the   tyre   pressures   of   the   towing  v
ehicle   and   of   the   trailer,   observing   the  
re

commended
 p
ressures.
Lighting
F Check  the   electrical   lighting   and   signalling  o
n   the   trailer.
Refer
 
to
 
the
 
"Technical
 
data"
 
section
 
for
 
details
 
o

f
 
the
 
weights
 
and
 
towed
 
loads
 
which
 
apply
 
to
 
y

our
 
vehicle.
When
 
not
 
towing
 
a
 
trailer,
 
remove
 
the
 
q

uickly-detachable
 
tow
 
ball
 
before
 
d

riving. The
  rear   parking   sensors   will   be  
d

eactivated   automatically   if   a   genuine  
C

ITROËN   towbar   is   used.
Practical information

304
ToTaL & CITRoËn
Partners in performance and
protecting the environment
Innovation in the search for
performance
For over 40 year, the TOTAL Research and Development   departments   have   developed   for  
C

ITROËN,   lubricants   to   match   the   latest   technical  
i

nnovations  
o
n  
C
ITROËN  
v
ehicles,  
b
oth  
f
or  
c
ompetition  
a

nd   for   everyday   motoring.
For you, this is an assurance that you will obtain of the
best
  per formance   for   your   engine.
Optimum protection for
your engine
By having your CITROËN vehicle serviced   with   TOTAL   lubricants,   you   are  
c

ontributing   towards   improving   the   life  
a

nd   per formances   of   your   engine,   while  
a

lso   protecting   the   environment.
prefers
Checks

305
bonnet
F Open  the   left   hand   front   door.
F  
L
ift   the   safety   catch   and   raise   the   bonnet.F
 U nclip   the   stay   from   its   housing   and   place  i
t   in   the   support   slot   to   hold   the   bonnet  
ope

n.
Opening
F Pull  the   release   lever,   located   at   the   bottom  o
f   the   door   aperture,   towards   you.
Closing
F Take  the   stay   out   of   its   support   slot.
F  C lip   the   stay   back   into   its   housing.
F
 
L
ower   the   bonnet   and   release   it   at   the   end  
o

f   its   travel.
F
 
P
ull   on   the   bonnet   to   check   that   it   has  
l

atched   correctly. Before
  doing   anything   under   the  
b

onnet, switch off the Stop & Start
system   to   avoid   any   risk   of   injury  
r

esulting   from   an   automatic   change   to  
S

TART   mode.
The cooling fan may star t after
switching off the engine: take care
with articles and clothing that might
be caught by the fan blades. Do
  not   open   the   bonnet   under   very  
wi

ndy
 c
onditions.
The location of the interior bonnet
release   lever   prevents   opening   of   the  
b

onnet   when   the   left   hand   front   door  
i

s   shut.
When   the   engine   is   hot,   handle   the  
e

xterior   safety   catch   and   the   stay   with  
c

are   (risk   of   burns),   using   the   protected  
a

rea.
When   the   bonnet   is   open,   take   care   not  
t

o   damage   the   safety   catch.
be

cause of the presence of electrical
equipment
  under   the   bonnet,   it   is  
r

ecommended   that   exposure   to   water  
(

rain,   washing,   ...)   be   limited.
8
Checks

306
The various caps and covers allow access for checking   the   levels   of   the   various   fluids   and   for  
r

eplacing   certain   components.
Petrol engines
1. Screenwash  and   headlamp   wash   reservoir.
2. C oolant r eservoir.
3.
 B

rake   fluid   reservoir.
4.
 B

attery   /   Fuses.
5.
 F

usebox.
6.
 A

ir   filter.
7.
 E

ngine   oil   dipstick.
8.
 E

ngine   oil   filler   cap.
Checks

307
The various caps and covers allow access for checking   the   levels   of   the   various   fluids,   for  
r

eplacing   certain   components   and   for   priming  
t

he   fuel   system.
Diesel engines
1. Screenwash   and   headlamp   wash   reservoir.
2. C oolant r eservoir.
3.
 B

rake   fluid   reservoir.
4.
 B

attery   /   Fuses.
5.
 F

usebox.
6.
 A

ir   filter.
7.
 E

ngine   oil   dipstick.
8.
 E

ngine   oil   filler   cap.
9.
 P

riming
 pu
mp*.
*
  According   to   engine.
8
Checks