2015 Citroen C4 fuel pump

208
C4-2_en_Chap10_verification_ed01-2015
C4-2_en_Chap10_verification_ed01-2015
Fuel tank
Capacity of the tank: approximately 60 litres.When the low fuel level in the
tank
  is   reached,   this   warning   lamp  
c

omes   on   in   the   instrument   panel,  
a

ccompanied   by   an   audible   warning  
a

nd   the   display   of   an   alert   message.  
W

hen   it   first   comes   on,   around
6
litres   of   fuel   remain   in   the   tank.
Low fuel level
Additions of fuel must be of at least 5 litres to be   registered   by   the   fuel   gauge.
Opening
  the   filler   cap   may   result   in   an   inrush   of  
a

ir.   This   vacuum   is   entirely   normal   and   results  
f

rom   the   sealing   of   the   fuel   system.
F

P
ress control A   until   the   automatic   opening  
o

f   the   fuel   flap   is   heard.
 T

his   control   remains   active   for   a   few  
m

inutes   after   switching   off   the   ignition.   If  
n

ecessary,   switch   the   ignition   on   again   to  
r

eactivate   it.
F
 
T
ake   care   to   select   the   pump   that   delivers  
t

he   correct   fuel   for   your   vehicle.If you are filling your tank to the top, do not
persist after the third cut- off; this could
cause your vehicle to malfunction. F

I
ntroduce the nozzle so as to push in the
metal
  non-return   flap   B.
F
 
M
ake   sure   that   the   nozzle   is   pushed   in   as  
f

ar   as   possible   before   starting   to   refuel  
(

risk   of   blowback).
F
 
M
aintain   this   position   while   refuelling.
F
 
P
ush   the   fuel   flap   to   close   it.
With Stop & Start, never refuel with the
system
 
in
 
STOP
 
mode;
 
you
 
must
 
switch
 
o

ff
 
the
 
ignition
 
with
 
the
 
key,
 
or
 
the
 
S

TART/STOP
 
button
 
if
 
your
 
vehicle
 
has
 
K

eyless
 
Entry
 
and
 
Starting.
Until
 
sufficient
 
fuel
 
has
 
been
 
added,
 
every
 
t

ime
 
the
 
ignition
 
is
 
switched
 
on,
 
this
 
warning
 
l

amp
 
appears,
 
accompanied
 
by
 
an
 
audible
 
s

ignal
 
and
 
an
 
alert
 
message.
 
When
 
driving,
 
t

his
 
audible
 
signal
 
and
 
the
 
display
 
of
 
this
 
a

lert
 
message
 
are
 
repeated
 
with
 
increasing
 
f

requency,
 
as
 
the
 
level
 
drops
 
towards
 
0 .
You
 
must
 
refuel
 
as
 
soon
 
as
 
possible
 
to
 
avoid
 
r

unning
 
out.
If
 
you
 
run
 
out
 
of
 
fuel
 
(Diesel),
 
refer
 
to
 
the
 
c

orresponding
 s

ection.
Refuelling
Checks

209
C4-2_en_Chap10_verification_ed01-2015
C4-2_en_Chap10_verification_ed01-2015
Fuel used for petrol
engines
The petrol engines are compatible with E
10   bio-petrol   (containing   10   %   ethanol),  
c

onforming   to   European   standards   EN   228  
and
  EN   15376.
E85
  type   fuels   (containing   up   to   85   %   ethanol)  
a

re   reserved   exclusively   for   vehicles   marketed  
f

or   the   use   of   this   type   of   fuel   (BioFlex  
v

ehicles).   The   quality   of   the   ethanol   must  
c

omply   with   European   standard   EN   15293.
Fuel used for Diesel
engines
The Diesel engines are compatible with biofuels   which   conform   to   current   and   future  
E

uropean   standards   (Diesel   fuel   which  
c

omplies   with   standard   EN   590   mixed   with   a  
b

iofuel   which   complies   with   standard  
EN
  14214)   available   at   the   pumps   (containing  
u

p   to   7   %   Fatty   Acid   Methyl   Ester).
B30
  biofuel   can   be   used   in   certain   Diesel  
e

ngines.   However,   this   use,   even   occasional,  
r

equires   strict   application   of   the   special  
s

ervicing   conditions.   Contact   a   CITROËN  
d

ealer   or   a   qualified   workshop.
The
  use   of   any   other   type   of   (bio)fuel  
(

vegetable   or   animal   oils,   pure   or   diluted,  
d

omestic   fuel...)   is   strictly   prohibited   (risk   of  
d

amage   to   the   engine   and   fuel   system).
The
 
petrol
 
or
 
Diesel
 
engine
 
of
 
your
 
vehicle
 
is
 f
itted with a catalytic converter, a device which
helps
 
to
 
reduce
 
the
 
level
 
of
 
harmful
 
emissions
 
i

n
 
the
 
exhaust
 
gases.
For petrol engines, the use of unleaded fuel
is compulsory.
The
 
filler
 
neck
 
is
 
narrower,
 
admitting
 
unleaded
 
p

etrol
 
nozzles
 
only.
Fuel supply cut-off
Your vehicle is equipped with a safety device w hich cuts off the fuel supply in the event of a
collision. If you have put in the wrong fuel for
your vehicle, you must have the tank
drained and refilled with the correct
fuel before you star t the engine.
10
Checks

210
C4-2_en_Chap10_verification_ed01-2015
C4-2_en_Chap10_verification_ed01-2015
Misfuel prevention (Diesel)*Mechanical device which prevents filling the tank of a Diesel vehicle with petrol. It avoids the risk of engine   damage   that   can   result   from   filling   with   the   wrong   fuel.
Located
  in   the   filler   neck,   the   misfuel   prevention   device   appears   when   the   filler   cap   is   removed.
When a petrol filler nozzle is introduced into the
fuel
  filler   neck   of   your   Diesel   vehicle,   it   comes  
i

nto   contact   with   the   flap.   The   system   remains  
c

losed   and   prevents   filling.
Do not persist but introduce a Diesel type
filler nozzle.
*
  According   to   country   of   sale. It
  remains   possible   to   use   a   fuel   can   to  
f

ill   the   tank.
In
  order   to   ensure   a   good   flow   of   fuel,  
d

o not place the nozzle of the fuel can
in direct contact with the flap of the
misfuel
  prevention   device   and   pour  
s

l ow l y.
Travelling abroad
As Diesel fuel pump nozzles may be different in other countries, the
presence
  of   the   misfuel   prevention  
d

evice   may   make   refuelling   impossible.
Before
  travelling   abroad,   we  
r

ecommend   that   you   check   with   the  
C

ITROËN   dealer   network,   whether   your  
v

ehicle   is   suitable   for   the   fuel   pumps   in  
t

he   country   in   which   you   want   to   travel.
Operation
Checks

211
C4-2_en_Chap10_verification_ed01-2015
C4-2_en_Chap10_verification_ed01-2015
Running out of fuel (Diesel)
1.6 HDi engine2.0 HDi engineOn vehicles fitted with HDi engines, the fuel s
ystem   must   be   primed   if   you   run   out   of   fuel;  
r

efer   to   the   corresponding   engine   compartment  
v

iew.
If
  the   tank   on   your   vehicle   is   fitted   with   a  
m

isfuel   prevention   device,   refer   to   the   "Misfuel  
p

revention
 (
Diesel)"
 s
ection.
BlueHDi 100, 115 and
120

engines
If the engine does not start first time, d
on't   keep   trying   but   start   the   procedure  
a

gain   from   the   beginning. F
 
F
ill   the   fuel   tank   with   at   least   five   litres   of  
d

iesel.
F  
O
pen   the   bonnet.
F  
I
f   necessary,   unclip   the   styling   cover   for  
a

ccess   to   the   priming   pump.
F  
S
queeze   and   release   the   priming   pump  
r

epeatedly   until   resistance   is   felt   (there  m
ay   be   resistance   at   the   first   press).
F  O perate   the   starter   until   the   engine   starts  
(

if   the   engine   does   not   start   at   the   first  
a

ttempt,   wait   around   15   seconds   before  
t

rying
 ag
ain).
F
 
I
f   the   engine   does   not   start   after   a   few  
a

ttempts,   operate   the   priming   pump   again  
t

hen   start   the   engine.
F
 
R
efit   the   styling   cover   and   clip   it   in   place.
F
 
C
lose   the   bonnet.F
 
F
ill   the   fuel   tank   with   at   least   five   litres   of  
D

iesel.
F  
O
pen   the   bonnet.
F
I
f necessary, unclip the style cover for
access   to   the   priming   pump.
F  
S
lacken   the   bleed   screw.
F  
S
queeze   and   release   the   priming   pump  r
epeatedly until fuel appears in the
transparent p ipe.
F
 
T
ighten   the   bleed   screw.
F
 
O
perate   the   starter   until   the   engine   starts  
(

if   the   engine   fails   to   start   at   the   first  
a

ttempt,   wait   around   15 seconds   before  
t

rying
 ag
ain).
F
 
I
f   the   engine   fails   to   start   after   a   few  
a

ttempts,   operate   the   priming   pump   again,  
t

hen   the   starter.
F
 
P
ut   the   style   cover   back   in   position   and  
c

lip   it   in   place,   ensuring   that   it   has   clipped  
c

o r r e c t l y.
F
 
C
lose   the   bonnet.
F
 
F

ill   the   fuel   tank   with   at   least   five   litres   of  
D

iesel.
F
 
S

witch   on   the   ignition   (without   starting   the  
e

ngine).
F
 
W

ait   around   6   seconds   and   switch   off   the  
ig

nition.
F
 
R

epeat   the   operation   10   times.
F
 
O

perate   the   starter   to   run   the   engine.
10
Checks

10
Checks17
C4-2-add_en_Chap10_verifi cation_ed01-2015
Running out of fuel (Diesel)
1.6 HDi engine 2.0 HDi engine
On vehicles fitted with HDi engines, the fuel system must be primed if you run out of fuel; refer to the corresponding engine compartment view.
If the tank on your vehicle is fitted with a misfuel prevention device, refer to the "Misfuel prevention (Diesel)" section.
BlueHDi engines
If the engine does not start first time, don't keep trying but start the procedure again from the beginning.
 Fill the fuel tank with at least five litres of diesel.  Open the bonnet.  If necessary, unclip the styling cover for access to the priming pump.  Squeeze and release the priming pump repeatedly until resistance is felt (there may be resistance at the first press).  Operate the starter until the engine starts (if the engine does not start at the first attempt, wait around 15 seconds before trying again).  If the engine does not start after a few attempts, operate the priming pump again
then start the engine.  Refit the styling cover and clip it in place.  Close the bonnet.
 Fill the fuel tank with at least five litres of Diesel.  Open the bonnet.  If necessary, unclip the style cover for access to the priming pump.  Slacken the bleed screw.  Squeeze and release the priming pump repeatedly until fuel appears in the transparent pipe.  Tighten the bleed screw.  Operate the starter until the engine starts (if the engine fails to start at the first attempt, wait around 15 seconds before trying again).
 If the engine fails to start after a few attempts, operate the priming pump again, then the starter.  Put the style cover back in position and clip it in place, ensuring that it has clipped c o r r e c t l y.  Close the bonnet.
 Fill the fuel tank with at least five litres of Diesel.  Switch on the ignition (without starting the engine).  Wait around 6 seconds and switch off the ignition.  Repeat the operation 10 times.  Operate the starter to run the engine.