123
C4-cactus_en_Chap06_visibilite_ed02-2014
This comes on automatically when the boot is opened and switches off automatically when
t
he boot is closed.
Different
lighting times are provided:
-
w
hen the ignition is off, approximately
t
en minutes,
-
i
n energy economy mode, approximately
t
hirty seconds,
-
w
hen the engine is running, no limit.
Boot lamp
Brightness
of
instruments
and
controls
Lighting dimmer control
Allows the manual adjustment of the brightness o
f the instrument and controls illumination, to
s
uit the ambient light level.
F
Sel
ect the "Configuration"
menu.
F
A
djust the brightness by pressing on
t
he "+ " or " -"
buttons or by moving the
c
u r s o r.Operates
only when the sidelamps are
o
n.
Black screen
(Touch screen tablet)
This function is accessible in the touch screen
tablet. F
Sel
ect the "Configuration "
menu.
F
P
ress "Turn off screen ".
This function is accessible in the touch screen
tablet.
The
screen in the the touch screen tablet goes
o
f f.
Press
the screen again (anywhere on its
s
ur face) to switch it on again.
6
Visibility
161
C4-cactus_en_Chap09_info-pratiques_ed02-2014
adblue® additive and SCR system
f
or
BlueHDi Diesel engines
To assure respect for the environment and c
onformity with the new Euro 6 emissions
s
tandard, without adversely affecting the
p
er formance or fuel consumption of Diesel
e
ngines, CITROËN has taken the decision to
e
quip its vehicles with an effective system that
a
ssociates SCR (Selective Catalytic Reduction)
w
ith a particle filter (FAP) for the treatment of
e
xhaust gases.
Presentation of the SCR system
Using an additive called AdBlue® containing urea, a
catalytic
converter
turns
up
to
85% of nitrous o
xides
(NOx)
into
nitrogen
and
water, which are
h
armless
to
health
and
the
environment.
on
ce the a
dbl
ue
® tank is empty, a s
ystem
required
by regulations
p
revents
starting
of the engine.
If the SCR is faulty, the level of
emissions
from
your vehicle will no
l
onger
meet
the
Euro 6 standard: you
v
ehicle
becomes
polluting.
In
the
event
of
a
confirmed fault
w
ith
the
SCR
system, you must go
t
o
a
CITROËN
dealer or a qualified
w
orkshop
as
soon as possible: after
a
running
distance of 650 miles
(
1 100
km),
a
system will be triggered
a
utomatically
to
prevent engine starting.
The
a
dblu
e® additive is held in a special
tank
located
under the boot at the rear of
t
he
vehicle.
It has a capacity of 17 litres: this
p
rovides
a
driving range of about 12 500 miles
(
20
000
km),
after which an alert is triggered
w
arning
you
when the reserve remaining is
e
nough
for
just 1 500 miles (2 400 km).
During
each
scheduled service of your vehicle
b
y
a
CITROËN dealer or a qualified workshop,
t
he
a
d
blu
e
® additive tank is refilled in order to a
llow
normal operation of the SCR system.
If
the
estimated mileage between two services
i
s
greater
than 12 500 miles (20 000 km), we
r
ecommend
that you go to a CITROËN dealer
o
r
a
qualified workshop to have the necessary
t
op-up
carried out.
9
Practical information
168
C4-cactus_en_Chap09_info-pratiques_ed02-2014
F obtain a bottle of adbl ue®. After first c
hecking
the
use-by
date,
read carefully
t
he instructions on use on the label before
pouring
the
contents
of
the bottle into your
v
ehicle's
Ad
Blue
® tank.
I
mportant :
if
your vehicle's AdBlue
®
tank
is
completely
empty
-
which
is
c
onfirmed
by
the
alert
messages
a
nd
the
impossibility
of
starting
the
e
ngine,
you
must
add
at
least
3.8
litres
(
so two 1.89
litre
bottles). If any additive is split or splashed, wash
immediately
w
ith
c
old
w
ater
o
r
w
ipe
w
ith
a
damp cloth.
If the additive has crystallised, clean it
off using a sponge and hot water.Important:
i
n the event of a top-up after
a breakdown because of a lack of
additive , signalled by the message "Top
u
p emissions additive: Starting prevented",
y
ou must wait around 5 minutes before
s
witching
o
n
t
he
i
gnition,
w
ithout opening
the driver's door, locking the vehicle
or introducing the key into the ignition
switch .
Switch on the ignition, then, after
1
0 seconds, start the engine.
ne
ver dispose of a
dbl
ue
® additive
bottles
in
the
household
waste. Place
t
hem
in
a
special
container provided
t
his
p
urpose
o
r
t
ake
t
hem
t
o
y
our
d
ealer.
F
A
fter
emptying
the
bottle,
wipe
away
any
s
pillage
around
the
tank
filler
using
a
damp
c
loth.
F
R
efit
the
blue
cap
to
the
tank
and
turn
it
a
6
th of a turn clockwise, to its stop.
F
R
efit
the black cap and turn it a quarter of
a
turn
clockwise without pressing. Ensure
t
hat the indicator on the cap lines up with
the
indicator on the support.
F
D
epending on equipment, return the spare
w
heel
and/or the storage box to the bottom
o
f
the
boot.
F
R
efit
the boot carpet and close the tailgate.
Practical information
176
C4-cactus_en_Chap09_info-pratiques_ed02-2014
Changing a wheel
The tools are installed in the boot under the
floor, or may be located, depending on version,
u
nder
t
he
f
ront
p
assenger
sea
t.
Access to the tools
List of tools
all of these tools are specific to your
vehicle and can vary according to the level
o
f equipment. Do not use them for other
p
urposes.
1.
W
heelbrace.
F
or removing the wheel trim and the wheel
bol
ts.
2.
J
ack with integral handle.
F
or raising the vehicle.
3.
B
olt cover removal tool.
F
or removing the bolt covers on alloy
w
heels
o
r
t
he
c
entral
w
heel
c
ap
(
depending
o
n version).
4.
R
emovable towing eye.
Refer
to the "Towing" section.
Procedure
for
changing
a
wheel
for
the
spare
wheel
using
the
tools
provided
with
the
vehicle.
Wheel with trim
When refitting the wheel
, refit the trim s
tarting by placing its notch facing the valve
a
nd press around its edge with the palm of your
han
d.
Practical information
177
C4-cactus_en_Chap09_info-pratiques_ed02-2014
F Unclip the tool storage box by pulling on it.
The spare wheel is installed in the boot under
the
floor.
Spare wheel (depending on version)
Taking out the wheel
F Unscrew
the yellow central bolt.
F R aise the spare wheel towards you from
t
he rear.
F
T
ake the wheel out of the boot.
Putting the wheel back in place
F Put the wheel back in its housing.
F U nscrew the yellow central bolt by a few
turns then put it in place in the centre of the
wheel.
F
T
ighten fully until the central bolt clicks to
r
etain the wheel correctly.
F
C
lip the tool storage box back into place.
9
Practical information
188
C4-cactus_en_Chap09_info-pratiques_ed02-2014
1. Sidelamps (W5W).
2. Brake lamps (P21W).
3.
D
irection indicators (PY21W).
4.
F
oglamp or reversing lamp (P21W).
Rear lamps
Changing bulbs
To reassemble, carry out these operations in reverse o rder.
F
S
pread the bulb holder retainers and
remove the bulb holder.
F
R
eplace the failed bulb:
-
f
or the sidelamp, pull the bulb
(
the upper one) out,
-
f
or the other lamps, turn the
c
orresponding bulb (lower) a quarter turn.
These
bulbs
are
changed
from
inside
the
boot.
F
O
pen
the
boot.
F
R
emove
the
corresponding
access
cover
in
t
he
trim
panel.
F
D
isconnect
the
lamp
unit
connector
by
p
ressing
the
locking
button
(located
under
t
he
connector
for
the
right
hand
lamp
and
a
bove the connector for the left
hand lam
p),
F
S
lacken
and
remove
the
nut
( take care not
to drop it inside the wing ).
F
P
ress
down
on
the
retaining
clip
for
lamp
u
nit,
then
carefully
remove
it
towards
the
o
utside. Take
care to engage the lamp unit in its
g
uides, while keeping it in line with the
v
ehicle.
Tighten
sufficiently to ensure sealing,
b
ut without damaging the lamp.
Practical information
190
C4-cactus_en_Chap09_info-pratiques_ed02-2014
F Using a small flat blade screwdriver, unclip t
he console assembly surrounding the
c
ourtesy lamp.
F
R
emove the failed bulb and change it.
F
R
efit the console around the courtesy
lamp,
ensuring that it is clipped in correctly.
Courtesy lamp
with bulbs (W5W) Courtesy lamp
with LEDs
For the replacement of the light-emitting d
iodes (LEDs), contact a CITROËN dealer or a
q
ualified
w
orkshop.
Boot (W5W)
F Unclip the lamp by pushing the body from b
ehind.
F
R
emove the bulb and change.
F
R
efit the lamp.
Interior lighting
Practical information
204
C4-cactus_en_Chap09_info-pratiques_ed02-2014
To w i n g
General recommendations
Observe the legislation in force in your country.
E nsure that the weight of the towing vehicle is higher than that of the towed vehicle.
The
driver must remain at the wheel of the towed vehicle and must have a valid driving licence.
When
towing a vehicle with all four wheels on the ground, always use an approved towing arm;
r
ope and straps are prohibited.
The
towing vehicle must move off gently.
When
towing a vehicle with the engine off, there is no longer any power assistance for braking
o
r steering.
In
the following cases, you must always call on a professional recovery service:
-
v
ehicle broken down on a motor way or fast road,
-
f
our-wheel drive vehicle,
-
w
hen it is not possible to put the gearbox into neutral, unlock the steering, or release the
par
king
b
rake,
-
t
owing with only two wheels on the ground,
-
w
here there is no approved towing arm available...
Procedure
for
having
your
vehicle
towed
or
for
towing
another vehicle using a removable towing eye.
The towing eye is stowed under the boot floor,
or
may
be
located
under
the
front
passenger
sea
t, d
epending o
n v
ersion.
Practical information