Page 5 of 285

.
.
Direction indicators 90
Hazard warning lamps
9
0
Horn
9
0
Under-inflation detection
9
1
Braking assistance systems
9
4
Trajectory control systems
9
5
Front seat belts
9
6
Airbags
9
9
Safety
Child seats 103
Deactivating the passenger's front airbag
1
06
ISOFIX mountings
1
12
Child lock
1
17
Child safety
Fuel tank 118
Misfuel prevention (Diesel)
1
19
Running out of fuel (Diesel)
1
21
Temporary puncture
repair kit
1
22
Changing a wheel
1
28
Snow chains
1
35
Changing a bulb
1
36
Changing a fuse
1
42
Battery
1
47
Electrical energy economy mode
1
50
Changing a wiper blade
1
51
Towing the vehicle
1
52
Towing a trailer
1
54
Very cold climate screen(s)
1
56
Advice on care and maintenance
1
57
Accessories
1
57
Mats
15
9
Roof bars
1
60
Practical information
Petrol engines 1 71
Petrol weights
1
72
Diesel engine
1
73
Diesel weights
1
74
Dimensions
1
75
Identification markings
1
76
Technical data
Audio system / Bluetooth 177
Audio system
2
09
Audio and telematics
Visual search
Alphabetical index
Checks
Bonnet 16
2
Petrol engines
1
63
Diesel engine
1
64
Checking levels
1
65
Checks
16
9
Contents
Page 138 of 285

136
Changing a bulb
Front lamps
In some weather conditions (e.g. low
temperature or humidity), the presence
of misting on the internal sur face of the
glass of the headlamps and rear lamps
is normal; it disappears after the lamps
have been on for a few minutes.
The headlamps are fitted with
polycarbonate glass with a protective
coating:
F
d
o not clean them using a dr y
or abrasive cloth, nor with a
detergent or solvent product,
F
u
se a sponge and soapy water or a
pH neutral product,
F
w
hen using a high pressure washer
on persistent marks, do not keep
the lance directed towards the
lamps or their edges for too long,
so as not to damage their protective
coating and seals.
Changing a bulb should only be done
after the headlamp has been switched
off for several minutes (risk of serious
burns).
F
D
o not touch the bulb directly with
your fingers, use a lint-free cloth.
It is imperative to use only anti-
ultraviolet (UV) type bulbs to avoid
damaging the headlamp.
Always replace a failed bulb with a
new bulb with the same type and
specification. 1.
D
irection indicators (PY21W amber).
2.
M
ain beam headlamps (H1-55W).
3.
D
ipped beam headlamps (H7-55W).
4.
D
aytime running lamps
/ sidelamps
(W21/5W).
or
S
idelamps (W5W).
5.
F
ront foglamps (H11-55W).
Practical information
Page 139 of 285
137
Amber coloured bulbs, such as the
direction indicators, must be replaced
with bulbs of identical specifications
and colour.
When refitting, close the protective
cover carefully to preserve the sealing
of the headlamp.
Rapid flashing of the direction indicator
warning lamp (right or left) indicates the
failure of a bulb on that side.
Changing direction indicator
bulbs
F Turn the bulb holder an eighth of a turn
anti-clockwise and extract it.
F
R
emove the bulb and change it.
To reassemble, carry out these operations in
reverse order.
Changing main beam headlamp
bulbs
F Remove the protective cover by pulling on the tab.
F
D
isconnect the bulb connector.
F
P
ush the spring to one side to release the
bulb.
F
R
emove the bulb and change it.
To refit, carry out these operations in reverse
o r d e r.
9
Practical information
Page 140 of 285
138
Changing dipped beam
headlamp bulbs
F Remove the protective cover by pulling
the tab.
F
D
isconnect the bulb connector by lifting
it
off.
F
P
ull the bulb out and change it.
To refit, carry out these operations in reverse
o r d e r.
Changing daytime running lamp /
s idelamp bulbs
F Pull the bulb holder pressing on the tabs on
both sides.
F
R
emove the bulb and change it.
To refit, carry out these operations in reverse
o r d e r.
Practical information
Page 141 of 285
139
Changing front foglamp bulbs
F Access to the front foglamp is through the aperture below the bumper.
I
f necessary, unscrew and completely
remove the cover.
F
T
urn the bulb holder a quarter turn anti-
clockwise and pull it out.
F
D
isconnect the bulb connector.
F
R
emove the bulb and change it.
To refit, carry out these operations in reverse
o r d e r. If you experience any difficulty in
replacing bulbs, contact your CITROËN
dealer or a qualified workshop.
Changing direction indicator side
repeaters
F Insert a screwdriver towards the centre of
the repeater between the repeater and the
base on the body.
F
T
ilt the screwdriver to extract the repeater
and remove it.
F
D
isconnect the repeater connector.
F
R
eplace the module.
To refit, carry out these operations in reverse
o r d e r.
Contact a CITROËN dealer or
a qualified workshop to obtain a
replacement side repeater module.
9
Practical information
Page 142 of 285
140
Changing bulbs
These bulbs are changed from inside the boot:
F
o
pen the boot,
F
r
emove the access grille from the
corresponding side trim panel,
F
s
lacken and remove the nut,
F
d
isconnect the lamp unit connector,
F
u
nclip the lamp unit by lowering the tongue
and carefully extract it pulling in line
towards the outside, F
r
emove the four screws and lift off the bulb
h o l d e r,
F
t
urn the failed bulb a quarter of a turn and
change it.
To refit, carry out these operations in reverse
o r d e r.
Take care to engage the lamp unit in its guides,
while keeping it in line with the vehicle.
Tighten sufficiently to ensure sealing, but
without damaging the lamp.
1.
D
irection indicators (PY21W amber).
2. R
eversing lamps (R10W).
3. F
oglamp (P21W).
4.
S
idelamps (P21/5W).
5.
B
rake lamps
/ sidelamps (P21/5W).
Rear lamps
Practical information
Page 226 of 285
224
Exterior
Remote control key 30 -33
- o pening / closing
-
a
nti-theft protection
-
s
tarting
-
b
attery
Boot
3
7-38
-
o
pening / closing
-
em
ergency release
Temporary puncture
repair kit
1
22-127
Wipers
87
- 88
Changing a wiper blade
1
51
Changing bulbs
1
40-141
-
r
ear lamps
-
3rd brake lamp
-
n
umber plate lamps
-
fo
glamp
Fuel tank, misfuel prevention
1
18-120
Running out of fuel (Diesel)
1
21
Accessories
1
57-158
ESP/ASR
9
5
Tyre pressures
1
76
Changing a wheel
1
28 -134
-
t
ools
-
r
emoving / refitting
Snow chains
1
35
Under-inflation detection
9
1-93
Lighting controls
8
1- 85
Daytime running lamps
8
5
Headlamp beam adjustment
8
6
Changing bulbs
1
36-139
-
f
ront lamps
-
fo
glamps
-
d
irection indicator repeaters
Towing
15
2-153
Very cold climate screen(s)
1
56
Door mirrors
4
3 - 44
Doors
3
0 -33, 36
-
o
pening / closing
-
c
entral locking
-
s
econdary control
Alarm
3
4-35
Electric windows
3
9 Rear parking sensors
7
9 - 80
To w b a r
1
5 4
Visual search
Page 230 of 285
228
Maintenance - Technical data
Petrol weights 172
Diesel weights 1 74
Changing bulbs
1
36-141
-
f
ront
-
r
ear Running out of fuel, Diesel
1
21
Opening the bonnet
1
62
Under the bonnet, petrol
1
63
Under the bonnet, Diesel
1
64
Petrol engines
1
71
Diesel engines
1
73 Bat ter y
14
7-149
Load reduction, economy mode
1
49, 150
Engine compartment
fuses
14
2-143, 146
Checking levels
1
65 -168
-
o
il
-
b
rake fluid
-
c
oolant
-
s
creenwash fluid
-
a
dditive (Diesel with particle filter)
Checking components
1
69 -170
-
b
attery
-
a
ir / passenger compartment filter
-
o
il filter
-
p
article filter (Diesel)
-
b
rake pads / discs
Identification markings
1
76
Dimensions
1
75
Visual search