2015 Citroen BERLINGO MULTISPACE ESP

185
Berlingo-2-VP_en_Chap08_aide-rapide_ed01-2015Berlingo-2-VP_en_Chap08_aide-rapide_ed01-2015
CHANGING A FUSE
The fuseboxes are located:
-
in the lower dashboard on the left-
hand side (behind the cover),
-

 
under
  the   bonnet   (near   the   battery).
The
  information   given   concerns   only  
those fuses which can be changed by
the user using the tweezer

, located
behind the dashboard storage
compartment
  on   the   right-hand   side.  
For

  any   other   work,   visit   a   CITROËN  
dealer

  or   a   qualified   workshop.
Removing and fitting a fuse
Always replace a failed fuse with a
fuse of the same rating.
Motor
 
trade
 
technicians:
 
for
 
complete

 
information
 
on
 
the
 
fuses
 
and relays, refer to the "Repair
Manual"

 
diagrams
 
via
 
the
 
dealer
 
network.
CITR

o
Ë
n
will not accept responsibility
for the cost incurred in repairing
your vehicle or for rectifying the
malfunctions
 
resulting
 
from
 
the
 installation of accessories not
supplied
 
and
 
not
 
recommended
 
by
 
the
 
CITROËN

 
network
 
and
 
not
 
installed
 
in accordance with its instructions,
in

 
particular
 
when
 
the
 
combined
 
consumption

 
of
 
all
 
of
 
the
 
additional
 
equipment

 
connected
 
exceeds
 

10
 
milliamperes. Before replacing a fuse, the cause of
the
  incident   must   be   identified   and  
rectified.
●

 
Use
  the   tweezer.
QUICk HELP
8
Changing a fuse

188
Berlingo-2-VP_en_Chap08_aide-rapide_ed01-2015Berlingo-2-VP_en_Chap08_aide-rapide_ed01-2015
Fuses under the bonnet
after opening the bonnet, unclip and tilt
the corresponding box to gain access
to
  the   fuses. Fuses
F Amperes  Aa
llocation
1 20 Engine
  management
2 15 Horn
3 10 Front
  and   rear   wash-wipe   pump
4 20 Headlamp
  wash   pump
5 15 Engine
  components
6 10 Steering wheel angle sensor,
d SC
7 10Brake
  switch,   clutch   switch
8 25 Starter
  motor
9 10Headlamp
  beam   motor,   fleet   management   unit
10 30 Engine
  components
11 40
n

ot used
12 30 Wipers
13 40 Built-in
  systems   interface
14 30 Pump
15 10 Right-hand
  main   beam   headlamp
16 10Left-hand
  main   beam   headlamp
17 15Right-hand
  dipped   beam   headlamp
18 15 Left-hand
  dipped   beam   headlamp
Changing a fuse

196
Berlingo-2-VP_en_Chap09_Caract-technique_ed01-2015Berlingo-2-VP_en_Chap09_Caract-technique_ed01-2015
ENGINE CHARACTERISTICS
The engine characteristics (capacity,
maximum  power,   maximum   power  
speed,

  fuel,   CO2   emissions...)   for   your  
vehicle are given in the registration
certificate.
These characteristics correspond
to the values type-approved
on a test bed, under conditions
defined

  in   European   legislation  
(Directive 1999/99/EC).
For

  more   information,   refer   to   the  
manufacturer's

  website   or   sales  
brochure

  for   the   model.   Contact  
a

  CITROËN   dealer   or   a   qualified  
workshop.
WEIGHTS AND TOWED LOADS
These values, expressed in kg, can be found
  on   the   manufacturer's   VIN   plate  
or

  label.
The
  maximum   weights   and   towed  
loads for your vehicle can be found on
the

  vehicle's   registration   certificate.
The
  kerb   weight   is   equal   to   the   weight  
without

  load   +   driver   (75   kg)   +   fuel   tank  
filled

  to   90%.
The GTW and towed load values
indicated
  are   valid   up   to   a   maximum  
altitude

  of   1000   metres.  
The
  value   of  
the

  towed   load   mentioned   must   be  
reduced by 10 % for each additional
1000

  metres.
With
  load   transfer,   the   braked   trailer  
weight can be increased, on condition
that the equivalent of this load is
removed

  from   the   vehicle   so   that   the  
GTW

  is   not   exceeded. High
  ambient   temperatures  
may

  result   in   a   reduction   in   the  
performance

  of   the   vehicle   in  
order

  to   protect   the   engine.   When   the  
ambient

  temperature   is   higher   than  
37 °C,

  limit   the   towed   weight.
Towing with a lightly loaded
vehicle can adversely affect road
holding.
Towing
  a   trailer   increases   braking  
distances.
When

  towing,   the   maximum   permitted  
speed

  is   reduced   (comply   with   the  
legislation

  in   force   in   the   country).
The
  recommended   nose   weight   is  the downward force on the towball
(removable
  with   or   without   tools).
GVW: gross vehicle weight, the
maximum
  authorised   weight.
GTW:
  gross   train   weight,   the   maximum  
weight

  for   vehicle   plus   trailer.
The
  location   of   the   manufacturer's  
plate

  is   given   in   chapter   9,  
"Identification

  markings"   section.
In
  each   country,   it   is   imperative   that  
the

  maximum   towed   loads   authorised  
by

  local   legislation   are   complied  
with.

 
T
o   find   out   your   vehicle's   towing  
capacities and its gross train weight,
consult

  a   CITROËN   dealer.
Weights

 227
Berlingo-2-VP_en_Chap10a_SMEGplus_ed01-2015
Select a radio station or frequency (refer to the
corresponding section). Press on Radio Media
to display the
primary pag e.
Press
  on   the   secondary   page.
Select " Settings ".
Select " Radio".
Activate/deactivate
 " R

DS
options ".
Press on Radio Media
to display the
primary
 pag

e.
Press
 
on
 
the
 
secondary
 
page. Press on "
Preset".
Select
  a   number   in   the   list   to   preset   the  
p

reviously   chosen   radio   station.
A
  long   press   on   a   number   presets   (memorises)  
t

he   station.
Press on Frequency
.
Enter
 
the
 
frequency
 
in
 
full
 
(e.g.:
 
9

2.10
 
MHz)
 
using
 
the
 
keypad
 
then
 
" Co

nfirm ".
Changing radio station
Pressing
 
the
 
name
 
of
 
the
 
current
 
radio
 
station
 
b

rings
 
up
 
a
 
list.
To
 
change
 
radio
 
station
 
press
 
the
 
name
 
of
 
the
 
de

sired
 s

tation.
o
r Press on Radio Media to display the
primary
 pag

e.
Select " Save".
Preset a station Activate/ Deactivate RDS
OR
THEN
a

press on this button presets all of
the
  stations   one   after   the   other.
Recall pre-set stations
RdS, if activated, allows you to continue
listening  to   the   same   station   by   automatic r

etuning   to   alternative   frequencies.
 H

owever, in certain conditions, coverage
of
  an   RDS   station   may   not   be   assured
 t

hroughout the entire country as radio
stations
  do   not   cover   100   %   of   the   territory.
 T

his explains the loss of reception of the
station
  during   a   journey.
audio and Telematics
TECHnoLoGY on BoaRd
10

 229
Berlingo-2-VP_en_Chap10a_SMEGplus_ed01-2015
Select change of source.
P ress on Radio Media
to display the
primary
 pag
e.
Select " DAB Radio ".
Select " List"
  in   the   primary   page.
Select
 
the   radio   station   from   the   list   offered.Press on Radio Media
to display the
primary
 pag
e.
Press   on   the   secondary   page.
Select " Settings ".
Select " RADIO".
Select " Digital/FM auto
tracking " then "Confirm ".
DAB / FM auto tracking
Digital radio
"daB" does not cover 100% of the
te r r i to r y.
When the digital radio signal is poor,
"DAB / FM
  auto   tracking"   allows   you   to  
c

ontinue   listening   to   the   same   station,  
b

y   automatically   switching   to   the  
c

orresponding "FM" analogue station
(if
  there   is   one). If
  "DAB / FM   auto   tracking"   is   activated,  t
here is a difference of a few seconds
when
  the   system   switches   to   "FM"  
a

nalogue   radio   with   sometimes   a  
v

ariation   in   volume.
When the digital signal is restored, the
system
  automatically   changes   back   to  
"

DA B ".di
gital radio provides higher quality
reception and also the graphical display
of
 
current
 
information
 
on
 
the
 
radio
 
s

tation
 
being
 
listened
 
to.
 
Select
 
"List"
 
in
 
t

he
 
primary
 
page.
The
 
range
 
of
 
multiplexes
 
available
 
is
 
d

isplayed
 
in
 
alphabetical
 
order. If the "
d

a
B
" station being listened to
is not available on "FM" (" DAB/FM"
option
  greyed   out),   or   "DAB   /   FM   auto  
t

racking"   is   not   activated,   the   sound  
w

ill cut out while the digital signal is too
weak.
or
Select " Radio list " in the secondary
page.
audio and Telematics
TECHnoLoGY on BoaRd
10

240
Berlingo-2-VP_en_Chap10a_SMEGplus_ed01-2015
Audio settings
Press Settings to   display   the   primary  pag
e.
Select " Audio settings ".
Select " Ambience "
o

r "Balance "
o

r "Sound effects "
o

r "Ringtones "
o

r "Voice ". On-board
  audio:   Arkamys© Sound
Staging
 
optimises
 
sound
 
distribution   in  
t

he
 t

he
 p

assenger
 c

ompartment.
The distribution (or spatialisation using
the
 
Arkamys® system) of sound is an a
udio process that allows the audio
quality
 
to
 
be
 
adapted   to   the   number   of  
p

assengers
 
in   the   vehicle.
Available
 
only   with   the   6 -speaker  
c

onfiguration.
The audio settings ( Ambience, Bass,
Tr e b l e and Loudness ) are different
and independent for each sound
source.
The settings for F-R balance and L- R
balance
 

are
 
common   to   all   sources.
-

" Ambience "
  (choice   of   6   musical  
am

biences)
-

" Bass "
-

" Tr e b l e "
-

" Loudness "
 (

Activate/Deactivate)
-

" Balance " ("Driver ", "All
passengers ", "Front only ")
-

" Audible response from touch screen "- "Volume linked to vehicle
speed: " (
Activate/Deactivate)
audio and Telematics

274
Berlingo-2-VP_en_Chap10b_Rd45_ed01-2015
Screen menu map(s)
Radio- CD
REG mode
CD repeat
Shuffle play
Vehicle config*
R wiper in rev
Options
Diagnostic
RDS options
View
ab
andon
1
2
3
3
1
2
2
2
2
1
2
Screen A
*  The   settings   vary   according   to   the   trim   level   of  t
he   vehicle.
Guide lighting
2
Units
Temperature: °Celsius / °Fahrenheit
Fuel consumption: KM/L -
L/100 - MPG
1
2
2
Display adjust
Month
Day
Hour
Minutes Ye a r
12 H/24 H mode
Language
Italiano
Nederlands
Portuguès
Português do Brasil Français
Deutsch
Čeština English
Hr vatski Español
Magyar
1
2
2
2
2
2
2
2
1
2
2
2
2
2
2
2
2
2
2
audio and Telematics