High beams, headlight flasher▷High beams, arrow 1.▷Headlight flasher, arrow 2.
Washer/wiper systemSwitching the wipers on/off and brief
wipe
Hints Do not activate wipers if frozen to wind‐
shield
Do not switch on the wipers if they are frozen
to the windshield; otherwise, the wiper blades
and the wiper motor may be damaged.◀
Do not activate wipers on dry windshield
Do not use the wipers if the windshield is
dry, as this may damage the wiper blades or
cause them to become worn more quickly.◀
Switching on
Push wiper lever up.
The lever automatically returns to its initial po‐
sition when released.▷Normal wiper speed: push up once.
The wipers switch to intermittent operation
when the vehicle is stationary.▷Fast wiper speed: press up twice or press
once beyond the resistance point.
Wipers change to normal speed when ve‐
hicle comes to standstill.
Switch off and brief wipe
Push wiper lever down.
The lever automatically returns to its initial po‐
sition when released.
▷Single wipe: press down once.▷To switch off normal wipe: press down
once.▷To switch off fast wipe: press down twice.
Interval mode or rain sensor
The concept The rain sensor automatically controls the time
between wipes depending on the intensity of the rainfall. The sensor is located on the wind‐
shield, directly behind the interior rearview mir‐
ror.
Seite 81DrivingControls81
Online Edition for Part no. 01 40 2 954 366 - II/15
Activating/deactivating
Press button on the wiper lever.
Wiping is started. If the vehicle is equipped
with a rain sensor: LED in wiper lever lights up.
When wipers are frozen to windshield, wiper
operation is deactivated.
During trip interruption with the rain sensor
switched on: if the trip is resumed within ap‐
prox. 15 minutes, the rain sensor is automati‐
cally activated again.
Deactivate the rain sensor in car washes
Deactivate the rain sensor when passing
through an automatic car wash; otherwise, un‐
intentional wiping can cause damages.◀
Setting the frequency or sensitivity of
the rain sensor
Turn the thumbwheel.
Clean the windshield, headlights
Pull the wiper lever towards you.
The system sprays washer fluid on the wind‐
shield and activates the wipers briefly.
In addition, the headlights are cleaned at regu‐
lar intervals when the vehicle's lights are acti‐
vated.
Do not use the washer system at freezing
temperatures
Do not use the washers if fluid could freeze
onto the windshield which might impede your
viewing field. Therefore use antifreeze fluid.
Avoid using the washer when the reservoir is
empty; operation might damage pump.◀
Windshield washer nozzles The windshield washer nozzles are automati‐
cally heated while the ignition is switched on.
Fold-out position of the wipers Fold wipers back when you want to change the
blades or with pending low temperatures.
1.Switch the ignition on and off again.2.With icy conditions make sure that blades
are not frozen to the windshield.3.Press the wiper lever up beyond the point
of resistance and hold it for approx. 3 sec‐
onds, until the wiper remains in a nearly
vertical position.
After the wipers are folded back down, the
wiper system must be reactivated.
Seite 82ControlsDriving82
Online Edition for Part no. 01 40 2 954 366 - II/15
Replacing componentsVehicle features and optionsThis chapter describes all standard, country-
specific and optional features offered with the
series. It also describes features that are not
necessarily available in your car, e. g., due to
the selected options or country versions. This
also applies to safety-related functions and
systems. The respectively applicable country
provisions must be observed when using the
respective features and systems.
Onboard vehicle tool kit
The onboard vehicle tool kit is located in a
fold-down cover in the trunk lid.
Unscrew the wing nut to open.
Wiper blade replacement
Hints Do not fold down the wipers without
wiper blades
Do not fold down the wipers if wiper blades
have not been installed; this may damage the
windshield.◀
Replacing the wiper blades1.To change the wiper blades, fold up, refer
to page 82, the wiper arms.2.Fold up the wipers.3.Position the wiper blade in a horizontal po‐
sition.4.Remove the wiper blade toward one side.5.Insert the new wiper blade in reverse order
of removal until it locks in place.6.Fold down the wipers.
Lamp and bulb replacement
Hints
Lights and bulbs
Lights and bulbs make an essential contribu‐
tion to vehicle safety.
The manufacturer of the vehicle recommends
that you entrust corresponding procedures to
Seite 220MobilityReplacing components220
Online Edition for Part no. 01 40 2 954 366 - II/15
U
Unintentional alarm 52
Units of measure 102
Universal remote control 170
Unlock button, Steptronic transmission 84
Unlocking/locking via door lock 43
Unlocking/locking with re‐ mote control 41
Unlocking, settings 50
Updates made after the edito‐ rial deadline 7
Upholstery care 235
USB interface 175
V
Vanity mirror 172
Vehicle battery 225
Vehicle battery, replac‐ ing 225
Vehicle, break-in 182
Vehicle care 234
Vehicle features and op‐ tions 6
Vehicle identification num‐ ber 9
Vehicle jack 225
Vehicle paint 234
Vehicle storage 236
Vehicle wash 233
Ventilation 165
Venting, see ventilation 165
Vent, see ventilation 165
VIN, see vehicle identification number 9
Voice activation system 26
W Warning and indicator lamps, see Check Control 90
Warning displays, see Check Control 90 Warning messages, see
Check Control 90
Warning triangle 228
Warranty 7
Washer fluid 83
Washer nozzles, wind‐ shield 82
Washer system 81
Washing, vehicle 233
Water, hybrid system 34
Water on roads 185
Weights 241
Welcome lamps during un‐ locking 41
Welcome lights 104
What to do after an acci‐ dent 231
Wheel base, vehicle 240
Wheel cleaner 235
Wheels, changing 205
Wheels, everything on wheels and tires 200
Wheels, Flat Tire Monitor FTM 116
Wheels, Tire Pressure Moni‐ tor TPM 112
Width, vehicle 240
Window defroster, rear 164
Windows, powered 52
Windshield, climate con‐ trol 184
Windshield washer fluid 83
Windshield washer noz‐ zles 82
Windshield washer sys‐ tem 81
Windshield wiper 81
Winter storage, care 236
Winter tires, suitable tires 206
Winter tires, tread 204
Wiper 81
Wiper blades, replacing 220
Wiper fluid 83
Wiper, fold-out position 82
Wiper system 81 Wood, care 235
Word match concept, naviga‐ tion 24
Working on the hybrid sys‐ tem 34
Wrench, see Onboard vehicle tool kit 220
X
Xenon headlights, bulb re‐ placement 221 Seite 251Everything from A to ZReference251
Online Edition for Part no. 01 40 2 954 366 - II/15
