2015 AUDI S3 length

....,
N
0 > co
rl I.O
"' ....,
"' rl
restraint so that it is as close to this position
as possible
q page 59 . Move the head re­
stra int so that it is as close to the back of
the head as possible .
A WARNING
Never place any objects in the driver's foot­
well. An object could get into the pedal
area and interfere with pedal function. I n
case of sudden braking or an accident, you
would not be ab le to brake or acce lerate.
Front passenger's seat
Always move the front passenger seat into
the rearmost position.
To avoid contact with the airbag while it is de­
ploying, do not sit any closer to the instru­
ment panel than necessary and always wear
the three -point safety belt provided adjusted
correctly . We recommend that you adjust the
passenger's seat in the following manner :
• Bring the backrest up to an (almost) upright
pos ition.
D o not ride w ith the seat reclined.
• For adjustable head restraints : adjust the
head restraint so the upper edge is as even
as possib le with the top of your head. If that
is not possible, try to adjust the head re­
straint so that it is as close to this position
as possible
q page 59 . Move the head re­
straint so that it is as close to the back of
the head as possible.
• Place your feet on the floor in front of the
passenger's seat .
Sea ts a nd s to rage 57
Front seats
Manual seat adjustment
App lies to vehicles: with manually adjustab le seats
Fig . 46 Fro nt seat: man ual seat adjustment
(D-Moving the seat forward/back : pull the
lever and slide the seat.
@-Lengthening/shortening the upper thigh
support*:
lift the handle.
@ -Adjust ing the a ngle of the seat surface*:
pull/press the lever.
@ -Adjusting the lumbar support*: press the
button in the des ired direction.
® -Moving the seat up/down: pull/press the
lever .
®-Adjust ing the backrest angle : turn the ad­
justing wheel.
A WARNING
-Only adjust the front seat with whe n the
veh icle is stationary. Otherwise, this in­
creases the risk of an accident
- Exerc ise caution when adjusting the seat
he ight. Ad justing the seat care lessly or
without check ing can p inch hands and
fingers .
- The front seat backrests must be not tilt­
ed too far bac k when driving, because
this affects the effective ness of the safe­
ty belts and airbag system, which in­
creases the risk of injury.
- To reduce the risk of injury dur ing sudden
braking or in a co llision, the driver and
front passenger shou ld not have their
backrests in the reclined position while ..,.

58 Seats and storage
dr iving or rid ing . The safety belts and air­
bag system can prov ide the greatest pro­
tection possible when the backrests are
in the upright posit ion a nd the safety
belts are worn correct ly. The more a
backrest is reclined, the greater the risk
of injury due to an incorre ct seating posi­
t ion an d safety be lt position .
Power seat adjustment
Applies to vehicles: with power adjustable seats
Fig. 47 Fr ont se at: power se at adju stm en t
@ -Adju sting the lumbar suppor t: press the
button in the desired d irect ion .
@-Moving the seat up/down : press the but ­
ton up/down. To adju st the front seat cushion ,
press the front button up/down . To adjust the
rear seat cushion, press the rear button up/
down .
@-Moving the sea t forward/back: press the
bu tton forward/back.
© -Adjusting the backrest angle : press the
button forward/back.
@ -Lengthening/shortening the upper thigh
support *: lift the handle.
A WARNING
- Only adjust the front seat w ith when t he
vehicle is stationary. Otherwise, th is in­
creases the risk of an accident
- The power adjustment for the front seats
also works with the ignition switched off
or with the ignition key removed. For this
reason, c hildren should never be left un­
attended in t he veh icle -they could be in­
jured! -
Exerc ise caution when adjusting the seat
he ight. Unsupervised or careless seat ad­
justment can pinch fingers or hands
causing injuries .
- W hile the vehicle is mov ing, the seat
backs of the front seats must not be in­
clined too far to the rear because the ef ­
fectiveness of the safety be lts and the
airbag sys tem is seve rely comp romised -
there is a risk of injury.
- To r educe the risk of injury dur ing s udden
b ra ki ng or in a co llision, the drive r and
front p assenge r sh ould not have the ir
backrests in the recline d posi tion while
driving or r iding. The safety be lts and a ir ­
bag system can provide the greatest pro­
tect ion possible when the backrests are
in the upr ight position and the safety
be lts are worn correctly. The more a
backrest is reclined, the greater the r isk
of injury due to an inco rrect seating posi­
tion and saf ety belt pos it ion.
Front center armrest
Applies to vehicles: wit h front center armrest
The cen ter armrest can be adjusted to several
levels .
Fig. 48 Armrest betwee n the drive r's /fro nt pa ssenger' s
seats .
.,. To adjust the ang le, raise the armres t
¢ fig. 48 notch by notch.
.,. To bring the armrest back down, ra ise it out
of the top notch and fold it back down . Then
lift the a rmrest to the desired position, if
necessary .
Please note that the dr iver's ab ility to move
his or a rm may be restricted when the armrest
Iii>

not used then is being generated in o rder to
maintain an optimal battery charge level.
@ Tips
- Energy management cannot overcome
the laws of physics. Note that the charge l evel and length of the battery life are
limited .
- When the start ing ability is endangered,
the (•) indicator light turns on
c!:>page20.
What you should know
Maintaining the starting ability is the highest
priority.
A lot of stress is p laced on the battery when
driving short distances, in traffic , and at co ld
times of the year. A lot of energy is used but litt le is generated. It is also critical when the
engine is not running but electrical equip­ ment is switched on . In this case, energy is
used but none is generated .
In situations like this, energy management
will actively regulated the distribution of en­ ergy.
Long periods without use
I f you do not drive your vehicle for several
days or weeks, e lectrica l equipment is gradu­
ally sca led back or switched off . This reduces
energy use and ensures the vehicle will be
able to start after long periods of time. Some
conven ience functions such as opening with
the remote contro l key may not be ava ilab le.
These convenience functions will be available
again once you switch the ign ition on and
start the engine.
With the engine switched off For example, if you listen to the radio when
the engine is switched off, the batte ry w ill
drain .
~ A warning text will appear if energy consump-
~ tion could impair starting ab ility . co ,....,
~ The message shows that you need to start the
~ engine in order to charge the battery. ,....,
Smart Technolog y 195
With the engine running
Although electrical energy is generated while driving, the battery can drain. This can happen
when litt le energy is generated, and much is
used and the charge leve l of the battery is not
optimal.
To restore the ba lance of energy, components
that require large amounts of energy are tem­
porari ly scaled back or switched off. Heating
systems in particular require a great deal of energy. If you notice, for example, that the
seat heating* or rear window defroster is not
working, then it has been temporar ily reduced
or switched off . These systems are availab le
again as soon as the energy balance has been
restored.
In add ition, you may notice that the idle
speed has slight ly increased . That is normal
and no cause for concern. Due to the in­
creased idling speed, the additional required
energy w ill be gene rated and the battery will
be charged.
Notice about data
recorded by the Event
Data Recorder and
vehicle control
modules
Event Data Recorder
This vehicle is equipped with an Event Data Recorder ( EDR). The main purpose of an EDR
is to record, in certain crash or near crash-like
situations, such as an airbag deployment or hitting a road obstacle, data that w ill assist in
understanding how a vehicle's systems per­
formed . Th e EDR is designed to record data
related to vehicle dynam ics and safety sys­
tems for a short pe riod of time, typically
30 seconds or less . The EDR in this vehicle is
designed to record such data as:
- How various systems in your veh icle were
operating;
- Whether or not the driver and passenger
safety belts were buckled/fastened;
•
•

M N
0 > co ,...., \!) ..,.,
M ..,., ,....,
Te chn ic a l da ta 28 7
designated seating position) and luggage
weight ~&. .
Gros s Axle W eight Rating
The G ross Axle Weight Rating is the maximum
l oad that can be applied at each axle of the
vehicle ~.&. .
Vehicle capacit y weight
The vehicle capac ity we ight (max. load) is list­
ed either on the dr iver's side B-pillar or inside
the fuel filler flap.
_& WARNING
- T he actual Gross Axle Weight Rat ing at
the front and rear axles shou ld not ex­
ceed the permissible weights, and their
combination must not exceed the Gross
Vehicle Weight Rating .
Dimensions
The dimensions can vary depend ing on the
model and equipment.
-
When driving on poor roads, by curbs and on
steep ramps, make sure that low-ly ing compo-
A3 Sed an
Length
Width
Width (across mir rors)
He ight (unloaded)a) -
Exceeding perm iss ible weight ratings can
result in vehicle damage, acc idents and
personal injury.
([) Note
-The vehicle capacity weight figures apply
when the load is d istr ibuted evenly in the
vehicle (passengers and luggage). When
transport ing a heavy load in the luggage
compartment, carry the load as near to
the rear axle as poss ible so that the vehi­
cle's handling is not impaired.
- Do not exceed the maximum permissible axle loads or the maximum gross veh icle
we ight. Always remember that the vehi­
cle's handling w ill be affected by the ex­
tra load. Therefore, ad just yo ur speed ac­
co rdingly.
- Always observe local regulat ions.
nents such as the spoiler and exhaust system
do not come i nto contact with these or they
could be damaged. This applies espec ially
when the vehicle is fu lly loaded.
in (mm)
175.3 (4456)
in (mm) 70.7 (1796)
in (mm) 77.1 (1960)
in (mm) 55.7 (1416)
al The height of the vehicle depends on the tires and suspension.
53 Sed an
Length in (mm) 175.8 (4469)
Width in (mm) 70
.7 (1796)
Width (across mirrors) in (mm) 77.1 (1960)
Height (unloaded)a) in (mm) 54.8 (1392)
a l The height of the vehicle depends on the tires and suspension.
•
•