2015 AUDI A3 change wheel

-Make sure that passengers wait in a safe
place away from the vehicle and well
away from the road and traffic.
- To help prevent the vehicle from moving
suddenly and possibly slipping off the
jack, always fully set the parking brake
and block the wheel diagonally opposite
the whee l being changed. When one
front whee l is lifted off the gro und, plac­
ing the A utomat ic Transm iss ion in P
(Park) wi ll
not prevent t he vehi cle from
moving .
- Before you change a wheel, be su re the
ground is leve l and fi rm.
If necessary,
use a st urdy board under the jack.
- Always store the vehicle tool ki t, the jack
and the replaced ti re in the l uggage com­
partment¢
page 12 7 .
Changing a wheel
When you change a wheel, follow these­
quence described below step-by-step and in
exactly that order.
1. Remove the d ec orative wheel cov er* . For
more deta ils see also
c:>page 249, Deco ­
rative wheel covers
or ¢ page 2 50,
Wheels with wheel bolt caps.
2. Loosen the wheel bolt s c:> page 250.
3. Locate the proper mount ing point for the
jack and align the jack below that point
<=> page 251.
4. Raise the car w ith the jack c:> page 251.
5. Remove the wheel with the flat tire and
then install
the spare ¢ page 252 .
6. Tighten all wheel bo lts light ly.
7 .
Low er the ve hicle with the jack.
8. Use the wheel bolt wrenc h and
firmly
tighten all whee l bolts c:> page 250.
9. Replace the decorative wheel cov er*.
A WARNING
Always read and follow all WARNINGS and
information
c:> .&. in Raising the vehicle on
page251
and ¢page 253.
What do I d o now ? 249
After changing a wheel
A wheel change is not complete without the
doing the following.
.,. Always store the vehicle tool kit, the jack*
and the replaced tire in the luggage com­
partment
c:> page 127.
.,. Check the tir e pr essure on the spare whee l
immed iate ly afte r mounting i t.
.,. As soon as poss ib le, have the
tight ening
torque s
on all wheel bolts checked w ith a
torque wrench . The correct tighten ing tor­
que is 90 ft lb (120 Nm).
.,. Have the flat tire
replaced as soon as possi­
ble.
@ Tips
- If you notice that the wheel bo lts a re
corroded and difficult to turn while
chang ing a tire, they should be replaced
before you c heck the tightening torque.
- Drive at reduced speed until you have the tightening torques checked.
- After changing a whee l, the ti re press ure
in all four tires must be checked/correct­
ed and the tire pressure monitoring indi­
cator must be stored in the M MI
c:>page245.
Decorative wheel covers
App lies to veh icles: w ith decorat ive w hee l cove rs
The decorative wheel covers must be removed
first to access the wheel bolts.
Fi g. 167 Chang ing a whee l: Removing th e w hee l cover
Removing
.,. Insert the hook (provided with the vehicle
t oo l kit) in the ho le in the whee l hub cover .
i,,.

hold on to the ca r to keep your ba lance
and take care not to slip.
Raising the vehicle
Th e ve hicl e must be li~ed with the jack first
before the wheel can be removed.
F ig. 170 Sill p anels : m arkin gs
Fig. 171 Sill: posi tioning th e vehicle jack
.. Place the vehicle jack (vehicle tool kit) on a
firm surface . Use a flat, stable support if
necessary . On a slippery surface such as tile,
you should use a non -slip pad (such as a rub ­
ber mat) ¢_& .
.. Engage the
p arking brak e to prevent your
vehicle from rol ling u ninten tionally.
.. Move the
se lector leve r to pos ition P.
.. Find the marki ng (imprint) on the si ll that is
nearest the wheel that wi ll be changed
¢ fig . 170 . Behind the marking, there is a
lifting point on the si ll for the vehicle jack.
.. Vehicles with a sill : Note the position of the
s ill when pos ition ing the vehicle jack
¢ fig . 171.
.. Turn the
ve hicle jack located under the lift­
ing poin t on the s ill to raise the jac k until its
arm @
Q fig. 171 is located under the des­
ignated plastic mount c:::>
A, ¢(D .
.. Align the jack so that its arm @c:::> fig. 171
engages in the designated lifting point in
What do I d o now ? 251
the door si ll and the movable base ® lies
flat on the ground. The base @ must be ver­
tical under the lifting point @ .
.. Wind the jack up further until the flat t ire
comes off the ground
c:::> _& .
Position the vehicle jack
onl y under the desig­
nated lifting points on the si ll
c:::> fig. 170.
There is exactly one locat ion for each wheel.
The jack must not be positioned at any other location ¢ 8 ¢(1).
An
uns table surface under the jack can cause
the vehicle to slip off the jack. Always provide a firm base for the jack on the ground . If nec­
essary place a sturdy board or sim ilar support
under the jack . On
hard, slippery surfaces
(such as tiles) use a rubbe r mat or similar to
prevent the jack from slipping
Q & .
_&. WARNING
-You or your passengers co uld be in ju red
while changing a wheel if you do no t fo l­
low these safety preca utions:
- Position the vehicle jack on ly at the
designated lifting points and align the
j ac k. Otherw ise, the vehicle jac k co uld
slip and cause an injury if it doe s not
h ave sufficient hold on the vehicle .
- A soft or unstable su rface unde r the
ja ck may cause the ve hicle to slip off
the jack . A lw ays p rov ide a firm b ase for
the j ack on the ground . If necessary,
u se a st urdy board under the jack .
- On hard, slippery surface (such as t iles)
u se a rubber mat or similar to prevent
the jack from slipping .
- Only raise your vehicle with the vehicle
j ack provided by the factory . If you use
a veh icle jack for another vehicle, you r
vehicle can slide and cause injury .
- Changes in tempe rature or load can af­
fect the height of the veh icle .
- Never sta rt the engine when the vehi­
cle is raised , which cou ld cause an acci-
dent.
~

252 What do I do n ow ?
-Support the vehicle securely with ap ­
propriate stands if work is to be per ­
formed underneath the vehicle;
otherw ise, there is a potential risk for
in Jury .
- To help preven t injury to yourself and
your passengers:
- Do not raise the vehicle u nti l you a re
sure the jack is sec urely e ngaged .
- Passengers mus t not rema in in the ve­
h icle when it is jacked up .
- Ma ke sure that passengers wait in a
safe p lace away from the vehicle and
well away from the road and traffic.
- Make sure jack posi tion is co rrect, ad­
just as necess ary and then contin ue to
raise the jack .
- Changes in temperature or load can af­
fect the height of the vehicle .
0 Note
Do not lift the vehicle by the s ill. Pos ition
the vehicle ja ck only at the designated lift­
ing poi nts on the sill. Othe rwise, your vehi­
cle will be damaged .
Taking the wheel off/installing the spare
Follow these instructions s tep-by-step for
c hanging the wheel.
Fig . 172 Chang ing a w hee l: u sing th e screw driver ha n­
dl e (w it h th e bla de re mov ed) to t urn the bolts
Fig. 173 Ch ang ing a wheel : alignment p in in sid e th e
t op hole
After you have loos ened all wheel bo lts and
raised the vehicle off the ground, remove and
replace the wheel as follows :
Removing the wheel
.,. Use the hexagon al so cket in th e screwdri v­
er handle
to completely remove the top­
most whee l bolt and set it aside on a
clean
surfac e Q fig. 172 .
.,. Screw the threaded end of the al ignme nt
p in
from the tool k it hand-t ight into t he
empty bol t hole
Q fig . 173.
.,. Then remove the other wheel bolts as de ­
scr ibed above .
.,. Take off the whee l leaving the a lignment pin
in the bo lt ho le
Q (J) .
Putting on the comp act sp are wheel
.,. Lift the spare whee l and carefully slide it
over the alignment p in to guide it in place
Q (J) .
.,. Use the hexagonal socket i n the screwdriver
handle to screw in and tighten a ll whee l
bolts
slightly .
.,. Remove the alignment pin and insert and
tighten the rema ining whee l bolt slightly
like the rest .
.,. Turn the jack handle counter -clockwise to
lower the vehicle until the jack is fully re­
leased .
.,. Use the wheel bolt wrench to tighten all
wheel bo lts fi rmly
Q page 250 . Tighten
them
crosswise , from one bolt to the (ap­
proximately) opposite one, to keep the
wheel cente red.

Loading the roof rack . . . . . . . . . . . . . . . . . 60
Lackin g/unlocking
by remote control .................. 33
with the central locking switch .. .. .. .. 35
with the convenience key . . . . . . . . . . . . . 34
with the door lock ............ .. .. .. 35
Long-term memory .................. 27
Low beam Indicator light . . . . . . . . . . . . . . . . . . . . . 24
Low beams . ................... ..... 42
Lower universal anchorages (Canada) .. . 180
Lugg age compartment ............ ... . 60
Cargo net .. ................. .. .... 62
Increasing the size ........ .... .. .. .. 61
Loading .. ... .................. .. .. 60
Pass-through . . . . . . . . . . . . . . . . . . . . . . 63
Reversible mat ..................... 62
Socket ... .. ................. .. .... 56
Stowing luggage .................. 127
Tie-downs . . . . . . . . . . . . . . . . . . . . . . . . . 62
Luggage compartment lid
Central locking . . . . . . . . . . . . . . . . . . . . . 3 7
Emergency release ........ .... .. .. . 246
Lumbar suppo rt . . . . . . . . . . . . . . . . . 53, 54
M
Maintenance ................. ..... . 268
Maintenance intervals
with driver information system ........ 13
Malfunction Indicator Lamp (MIL) . . 23, 29
Mirro r
Digital compass switching on and off . .. 50
dimming . .. ................. .. .... 49
Vanity mirror ............ ...... .... 46
Mirror compass .................. .... SO
Mirrors Adjusting the exte rior mirrors . .. .. .. .. 48
Monitoring the Advanced Airbag System 152
Motor
Index 279
Navigation system CD-ROM player . . . . . . . . . . . . . . . . . . . . . 58
New tires and wheels ................ 236
NHTSA Contacting .. .. .. .. ..... .......... 129
Number of seats ..... ............... 131
Number of vehicle keys ............... 31
0
Occupant seating positions ........... 122
Octane rating ... .... ............... 206
Odometer ...... .................... 11
Oil Ind icator light . . . . . . . . . . . . . . . . . 23, 24
also refer to Engine oil . . . . . . . . 212, 215
Oil change interva l
with driver information system . . . . . . . . 13
On-board computer . . . . . . . . . . . . . . . . . . 26
Operation (multifunction steering
wheel) ..... ..... .................. 27
On-Board Diagnost ic System (OBD)
Electronic speed limiter .............. 30
Malfunction Indicator Lamp (MIL) .. .. . 29
Opening ................. ........... 31
Fuel filler door ... .. . .. ... .... ..... 208
Hood ........ ... .. ............... 211
Luggage compartment lid ............ 37
Panorama sunroof .................. 40
Windows ......................... 38
Opening/closing with the central locking switch ........ 35
with the convenience key ........ .. .. . 34
with the door lock .................. 35
Operate your vehicle economically and
minimize pollution .................. 195
Other equipment (efficiency program) . .. 29
Outside air temperature display ........ 11
Overview illustration (cockpit) . . . . . . . . . . . 8
•
•
stopping (driver messages with mechani-p
cal ignition key) ................ .... 75
Multifunction steering wheel . .. .. .. .. .. 27 Paint damage
203
On-board computer ................. 27 Paint No
........................... 265
•
Panorama sunroof ... . .. .. ... ... .... . 40
N
Convenience opening/closing ......... 39
Emergency closing ................ .. 41
Natural leat her care/cleaning .. .. .. .. . 204