2015.75 VAUXHALL VIVA ECU

Vauxhall Viva Owner Manual (GMK-Localizing-EU RHD-9231169) - 2016 -
CRC - 5/7/15
190 Vehicle Care
4. Set the jack to the necessaryheight. Position it directly below
the jacking point in a manner
that prevents it from slipping.
Attach jack handle and with the
jack correctly aligned rotate
handle until wheel is clear of
the ground.
5. Unscrew the wheel bolts.
6. Change the wheel.
7. Screw on the wheel bolts.
8. Lower vehicle.
9. that it locates securely and tighten each bolt in a crosswise
sequence. Tightening torque is
140 Nm. 10. Align the valve hole in the
wheel cover of the steel wheel
with the tyre valve before
installing.
Install wheel bolt caps or
centre cap on alloy wheel.
11. Install vehicle jacking point cover.
12. Stow and secure the replaced wheel, the vehicle tools and the
adapter for the locking wheel
bolts.
13. Check the tyre pressure of the installed tyre and the wheel
bolt torque as soon as
possible.
Have the defective tyre
renewed or repaired as soon
as possible.
Jacking position for lifting
platform
Rear arm position of the lifting
platform located centrally under the
recess of the sill.

Vauxhall Viva Owner Manual (GMK-Localizing-EU RHD-9231169) - 2016 -
CRC - 5/7/15
Vehicle Care 191
Front arm position of the lifting
platform at the underbody.
Compact Spare Tyre
Some vehicles are equipped with a
tyre repair kit instead of a spare
wheel.
If mounting a spare wheel, which is
different from the other wheels, this
wheel might be classified as a
temporary spare wheel and the
corresponding speed limits apply,
even though no label indicates this.
Seek the assistance of a workshop
to check the applicable speed limit.
The spare wheel has a steel rim.
Caution
Use of a spare wheel that is
smaller than the other wheels or
together with winter tyres could
affect drive ability. Have the
defective tyre replaced as soon
as possible.
The spare wheel is located in the
load compartment beneath the floor
covering. It is secured in the recess
with a wing bolt.
The spare wheel well is not
designed for all permitted tyre sizes.
If a wheel wider than the spare mustbe stowed in the spare wheel well
after changing wheels, the floor
cover can be placed on the
projecting wheel.
Temporary spare wheel
Use of the temporary spare wheel
could affect drive ability. Have the
defective tyre renewed or repaired
as soon as possible.
Only mount one temporary spare
wheel. Do not drive faster than
50 mph. Take bends slowly. Do not
use for a long period of time.
Storing a replaced wheel in the
load compartment using a
strap
Use the strap placed in the tool box.
Vehicle tools
0Tools
0177.
1. Remove load compartment cover and lift up load
compartment floor. Position the
Tool box and the damaged
wheel to stand upright into the
tool box spare.

Vauxhall Viva Owner Manual (GMK-Localizing-EU RHD-9231169) - 2016 -
CRC - 5/7/15
192 Vehicle Care
2. Pull up the release knob on topof the rear seat backrest
forward.
3. Place the loop end of the strap
from tool box through the seat
back latch.
4. Place the hook end of the strap through the loop and pull it until
the strap is fastened securely
to the seat back latch.
5. Pull back backrests of the rear
seats.
6. Mount the hook to the tailgate latch.
7. Tighten the strap and secure it using the buckle.
Jump Starting
Do not start with quick charger.
A vehicle with a discharged battery
can be started using jump leads and
the battery of another vehicle.
{Warning
Be extremely careful when
starting with jump leads. Any
deviation from the following
instructions can lead to injuries or
damage caused by battery
explosion or damage to the
electrical systems of both
vehicles.
Avoid contact with eyes, skin,
fabrics and painted surfaces. The
fluid contains sulphuric acid which
can cause injuries and damage in
the event of direct contact.
. Never expose the battery to
naked flames or sparks.

Vauxhall Viva Owner Manual (GMK-Localizing-EU RHD-9231169) - 2016 -
CRC - 5/7/15
194 Vehicle Care
3. Allow both engines to idle forapprox. 3 minutes with the
leads connected.
4. Switch on electrical consumers (e.g. headlights, heated rear
window) of the vehicle
receiving the jump start.
5. Reverse above sequence exactly when removing leads.Towing the Vehicle
If towing service is not available in
an emergency, your vehicle may be
temporarily towed by a rope secured
to the emergency towing eye.
Disengage cap by using the
screwdriver and remove the cap.
The towing eye is stowed with the
vehicle tools.
See Tools 0177.
Screw in the towing eye as far as it
will go until it stops in a horizontal
position. (Should be contact with
tow nut.)
Attach a tow rope or better still a
tow rod to the towing eye.
The towing eye must only be used
for towing and not for recovering the
vehicle.
Switch on ignition to release
steering column lock and to permit
operation of brake lights, horn and
windscreen wipers.
Transmission in neutral.

Vauxhall Viva Owner Manual (GMK-Localizing-EU RHD-9231169) - 2016 -
CRC - 5/7/15
212 Customer Information
Radio Frequency
Identification (RFID)
RFID technology is used in some
vehicles for functions such as tyre
deflation detection and ignition
system security. It is also used in
connection with conveniences such
as radio remote controls for door
locking/unlocking and starting, and
in-vehicle transmitters for garage
door openers. RFID technology in
Opel vehicles does not use or
record personal information or link
with any other Opel system
containing personal information.