Vauxhall Viva Owner Manual (GMK-Localizing-EU RHD-9231169) - 2016 -
CRC - 5/7/15
Vehicle Care 187
13. The prescribed tyre pressure(approx. 2.4 bar) should be
obtained within 10 minutes.
When the correct pressure is
obtained, switch off the
compressor.
If the prescribed tyre pressure
is not obtained within
10 minutes, remove the tyre
repair kit. Move the vehicle one
tyre rotation.
Reattach the tyre repair kit and
continue the filling procedure
for 10 minutes. If the
prescribed tyre pressure is still
not obtained, the tyre is too
badly damaged. Seek the
assistance of a workshop.
Drain excess tyre pressure with
the button over the pressure
indicator.
Do not run the compressor
longer than 10 minutes. 14. Detach the tyre repair kit. Push
catch on bracket to remove
sealant bottle from bracket.
Screw tyre inflation hose to
free connection of sealant
bottle. This prevents sealant
from escaping.
Stow tyre repair kit in tailgate.
15. Remove any excess sealant using a cloth.
16. Take the label indicating maximum permitted speed
(approx. 50 mph) from the
sealant bottle and affix in the
driver's field of view.17. Continue driving immediatelyso that sealant is evenly
distributed in the tyre. After
driving approx. 6 miles (but no
more than 10 minutes), stop
and check tyre pressure.
Screw compressor air hose
directly onto tyre valve and
compressor when doing this.
If tyre pressure is more than
1.3 bar, set it to the correct
value (approx.2.4 bar).
Repeat the procedure until
there is no more loss of
pressure.
If the tyre pressure has fallen
below 1.3 bar, the vehicle must
not be used. Seek the
assistance of a workshop.
18. Stow away tyre repair kit in tailgate.
Note: The driving characteristics of
the repaired tyre is severely
affected, therefore have this tyre
replaced.
Vauxhall Viva Owner Manual (GMK-Localizing-EU RHD-9231169) - 2016 -
CRC - 5/7/15
192 Vehicle Care
2. Pull up the release knob on topof the rear seat backrest
forward.
3. Place the loop end of the strap
from tool box through the seat
back latch.
4. Place the hook end of the strap through the loop and pull it until
the strap is fastened securely
to the seat back latch.
5. Pull back backrests of the rear
seats.
6. Mount the hook to the tailgate latch.
7. Tighten the strap and secure it using the buckle.
Jump Starting
Do not start with quick charger.
A vehicle with a discharged battery
can be started using jump leads and
the battery of another vehicle.
{Warning
Be extremely careful when
starting with jump leads. Any
deviation from the following
instructions can lead to injuries or
damage caused by battery
explosion or damage to the
electrical systems of both
vehicles.
Avoid contact with eyes, skin,
fabrics and painted surfaces. The
fluid contains sulphuric acid which
can cause injuries and damage in
the event of direct contact.
. Never expose the battery to
naked flames or sparks.