2014 VOLKSWAGEN CC oil level

Length 189 in – 193 in (4802 –
4902 mm)
Width 73 in (1855 mm)
Height (unloaded) 55.7 – 56.1 in (1417 –
1425 mm)
Wheelbase 106.6 in (2708 mm)
Minimum turning circle diameter
(wall to wall)2
37.4 ft (11.4 m)
Track2, front 61.1 – 61.3 in (1552 –
1556 mm)
Track2, rear 61.3 – 61.5 in (1557 –
1562 mm)
Ground clearance (unloaded) 4.9 in (124 mm)

NOTICE
Please be careful when parking your vehicle in areas with
parking barriers or curbs. These vary in height and could dam-
age your bumper and related parts if the front of your vehicle
hits a barrier or curb that is too high while you are getting into or
out of a parking spot.
Always be careful when you enter a driveway or drive up or
down steep ramps or over curbs or other obstacles. Parts of the
vehicle close to the ground may be damaged (such as bumper
covers, spoilers, and parts of the engine, suspension, and ex-
haust systems).

2 Slight differences to these figures are possible, depending on wheel and tire size fitted and the level selected.

Heat buildup in the passenger and luggage compartment of a
parked vehicle can result in temperatures in the vehicle that are
much higher than the outside temperatures, particularly in
summer. Temperatures can quickly reach levels that can cause
unconsciousness and death, particularly to small children.
NOTICE
Always be careful when you park in areas with parking barri-
ers or high curbs. These vary in height and could damage your
bumper and related parts if the front of your vehicle hits a barrier
or curb that is too high while you are getting into or out of a
parking spot. To help prevent damage, stop before the tires of
your vehicle touch a parking barrier or curb.
Always be careful when you enter a driveway or drive up or
down steep ramps or over curbs or other obstacles. Parts of the
vehicle close to the ground may be damaged (such as bumper
covers, spoilers, and parts of the engine, suspension, and ex-
haust systems).
Warning and indicator lights

Adjust the tire pressure
The proper tire pressure helps reduce rolling resistance as well as
fuel consumption.
When purchasing new tires, always make sure that the tires are opti-
mized for lower rolling resistance.
Use low viscosity engine oil
Fully “synthetic,” low viscosity engine oils that expressly comply with
Volkswagen oil quality standards reduce fuel consumption. Low vis-
cosity engine oils reduce the frictional resistance on the engine and
are distributed more evenly and quickly, particularly when cold-
starting the engine. The effect is particularly apparent in vehicles that
frequently travel short distances.
Always ensure the right engine oil level is maintained and keep to the
scheduled service intervals (engine oil changes).
Make sure the engine oil that you purchase expressly complies with
Volkswagen oil quality standards and is the oil approved by
Volkswagen for your vehicle.
Avoid unnecessary weight
The lighter the vehicle, the more economical and eco-friendly it will
be. For example, an extra 220 lbs (100 kg) of weight increases fuel
consumption by up to 1 pint per 60 miles (0.3 l/100 km).
Remove all unnecessary items and unnecessary dead weight from
the vehicle.
Remove unnecessary aftermarket components
The more aerodynamic the vehicle, the less fuel it will consume. Af-
termarket components such as bicycle racks reduce its aerodynamic
performance.
Therefore, remove unnecessary structures and unused rack systems,
particularly if planning to drive at higher speeds.

Checking the engine oil level and adding oil

Fig. 165 Oil dipstick with engine oil level marks.

Fig. 166 In the engine compartment: Engine oil filler cap.

dipstick are located, see your authorized Volkswagen dealer or au-
thorized Volkswagen Service Facility for assistance.
5. Remove the dipstick from the guide tube and wipe the dipstick off
using a clean cloth.
6. Reinsert the dipstick into the guide tube and push it all the way in. If
there is an alignment tab on the engine oil dipstick, make sure it
lines up with the notch in the guide tube, and that the dipstick goes
all the way in.
7. Remove the dipstick again and read the oil level on the dipstick
⇒ fig. 165 as described below:
(A): Do not add any oil ⇒ . Continue with step 15.
(B): Oil may be added (about 1 pint / 0.5 liter). Continue with step 8
or step 15.
(C): You must add oil (about 1 quart / 1.0 liter). Continue with step
8.
8. After reading the oil level, reinsert the dipstick back into the guide
tube and push it all the way in.
9. Remove the cap on the engine oil filler opening ⇒ fig. 166.
10. Only add engine oil that Volkswagen has approved for that
engine. Add the oil gradually in small quantities (no more than
1 pint / 0.5 liter).
11. To help prevent overfilling, you must wait about 1 minute each
time you add oil so that the oil can flow into the oil pan up to the
marking on the dipstick.
12. Read the oil level on the dipstick again before adding another
small amount, if necessary. Never add too much oil ⇒ .
13. After adding oil, the level must at least be in the center of the
⇒ fig. 165 (B) area, but never above (A) ⇒ .
14. After adding oil, securely install the cap on the engine oil filler
opening. Otherwise, oil could leak out while the engine is running.
15. Insert the oil dipstick back in the guide tube and push it all the
way in.
16. Close the hood ⇒ 
Engine oil level ranges

fig. 165 Required action according to the respective en-
gine oil level:
Range (A) Do not refill oil ⇒ .
Range (B) You may add oil (about 1 pint / 0.5 liter). The oil level
may go into the (A) range, but not above the (A)
range.
Range (C) You must add oil (about 1 quart / 1.0 liter). After add-
ing oil, make sure that the oil level is about in the
middle of the (B) range.

WARNING
Engine oil can ignite when it touches hot engine parts. This can
cause fires, burns, and other severe injuries.
Never spill oil on the engine. Oil spilled on a cold engine can
also cause a fire when the engine warms up.
Always make certain that you screw the cap of the engine oil
filler opening back on tightly after adding oil and that the dip-
stick has been pushed all the way back into the in the guide
tube. This helps prevent engine oil from leaking onto the hot
engine when the engine is running.
NOTICE
Do not start the engine if the engine oil level is above range
(A). Contact an authorized Volkswagen dealer or an authorized
Volkswagen Service Facility. Otherwise the catalytic converter
and engine can be damaged!
When changing or topping off fluids, make sure that you pour
the fluids into the correct reservoirs. Adding the wrong type of
operating fluids will cause serious malfunctions and engine
damage.
The engine oil level should never be above range (A). Otherwise
oil can be drawn in by the crankcase ventilation system and enter the
atmosphere via the exhaust system.