Seats, restraints33
Head restraint removal
To remove the head restraints, pull
lock tab and pull the restraint
upwards.
Stow head restraints securely in load
compartment. Do not drive with head
restraints removed if the seat is
occupied.
Front seats
Seat position9 Warning
Only drive with the seat correctly
adjusted.
■ Sit with buttocks as far back against
the backrest as possible. Adjust the distance between the seat and the
pedals so that legs are slightly
angled when pressing the pedals.
Slide the front passenger seat as
far back as possible.
■ Sit with shoulders as far back against the backrest as possible.
Set the backrest rake so that it is possible to reach the steering
wheel with arms slightly bent.
Maintain contact between
shoulders and the backrest when
turning the steering wheel. Do not
angle the backrest too far back. We recommend a maximum rake of
approx. 25°.
■ Adjust the steering wheel 3 60.
■ Set seat height high enough to have a clear field of vision on allsides and of all display instruments.
There should be at least one hand
of clearance between head and the
roof frame. Thighs should rest
lightly on the seat without pressing
into it.
■ Adjust the head restraint 3 32.
■ Adjust the height of the seat belt 3 40.
■ Adjust the lumbar support so that it
supports the natural shape of the
spine 3 34.
Seats, restraints37
Rear seat access
To facilitate access to the rear seats,
fold the seat backrest forwards. If necessary release the two-latch seatbelt from its buckles.
9 Warning
Ensure that the backrest returns to
its correct position and the seat
belt buckles engage securely.
Fitting seat belt 3 40.
Folding seats
On some variants, the cargo area can
be increased by folding up the rear
seats.
Remove the head restraints 3 32.
Push the seat backrest rearwards 1,
then pull the side handle to release 2.
Fold the backrest forward onto the
seat base 3, if necessary release the
two-latch seat belts from their
buckles.
Release both locking bars at the rear
base of the seat by pulling rearwards
4 .
Lift and fold the seat assembly, until
the seat frame rests in place.9 Warning
When folding the seat use caution
- beware of moving parts. Ensure
the seat is secure when
completely folded.
To return the folding seat to the
upright position, support the seat
assembly and release the bar by
pulling the bar directly towards you.
Driving and operating113
If the trailer starts snaking, drive moreslowly, do not attempt to correct the
steering and brake sharply if
necessary.
When driving downhill, drive in the
same gear as if driving uphill and
drive at a similar speed.
Adjust tyre pressure to the value
specified for full load 3 163.
Trailer towing Trailer loads
The permissible trailer loads are
vehicle and engine-dependent
maximum values which must not be exceeded. The actual trailer load is
the difference between the actual
gross weight of the trailer and the
actual coupling socket load with the
trailer coupled.
The permissible trailer loads are
specified in the vehicle documents. In general, they are valid for gradients
up to max. 12 %.The permitted trailer load applies up
to the specified incline and up to an
altitude of 1000 metres above sea
level. Since engine power decreases
as altitude increases due to the air
becoming thinner, therefore reducing
climbing ability, the permissible gross
train weight also decreases by 10 %
for every 1000 metres of additional
altitude. The gross train weight does
not have to be reduced when driving
on roads with slight inclines (less than 8 %, e.g. motorways).
The permissible gross train weight
must not be exceeded. This weight is
specified on the identification plate
3 150.
Vertical coupling load
The vertical coupling load is the load
exerted by the trailer on the coupling
ball. It can be varied by changing the
weight distribution when loading the
trailer.
The maximum permissible vertical
coupling load is specified on the
towing equipment identification plate
and in the vehicle documents. Always aim for the maximum load, especiallyin the case of heavy trailers. The
vertical coupling load should never
fall below 25 kg.
In the case of trailer loads of
1200 kg or more, the vertical coupling load should not be less than 50 kg.
Rear axle load When the trailer is coupled and the
towing vehicle fully loaded (including
all occupants), the permissible rear
axle load (see identification plate or
vehicle documents) must not be
exceeded.
Towing equipmentCaution
When operating without a trailer,
remove the coupling ball bar.
114Driving and operating9Warning
Towing a trailer is permitted only
when a coupling ball bar is fitted correctly. If the coupling ball bardoes not engage correctly, seekthe assistance of a workshop.
Towing equipment audible
warning For vehicles fitted with towingequipment, when connected to a
trailer the pitch of the audible warning
changes upon operation of the turn
signals.
The pitch of the audible warning will
also change if a turn signal light on the trailer or the towing vehicle fails.
Vehicle care135
9. Set the rocker switch on thecompressor to I. The tyre is filled
with sealant.
10. The compressor pressure gauge briefly indicates up to 6 bar(600 kPa/87 psi). Then the
pressure starts to drop.
11. All of the sealant is pumped into the tyre. Then the tyre is inflated.12. The prescribed tyre pressure should be obtained within
10 minutes. Tyre pressure
3 163 . When the correct pressure
is obtained, switch off the
compressor.
If the prescribed tyre pressure is
not obtained within 10 minutes,
remove the tyre repair kit. Move
the vehicle one tyre rotation
(approx. 2 metres). Reattach the
tyre repair kit and continue the
filling procedure for 10 minutes. If
the prescribed tyre pressure is still not obtained, the tyre is too badly
damaged. Seek the assistance of
a workshop.
Drain excess tyre pressure with
the button above the pressure
indicator.
Do not run the compressor for
longer than 10 minutes.
13. Detach the tyre repair kit. Screw the tyre inflation hose to the free
connection on the sealant bottle.
This prevents sealant from
escaping. Stow tyre repair kit
under the front seat.
14. Remove any excess sealant using a cloth.
15. Take the label indicating maximum permitted speed from
the tyre repair kit and affix in the driver's field of view.
136Vehicle care
16. Continue driving immediately sothat the sealant is evenlydistributed throughout the tyre.
After driving approx. 6 miles, but
no more than 10 minutes, stop
and check tyre pressure using the
compressor. Screw compressor
air hose directly onto tyre valve
and compressor when doing this.
17. If the tyre pressure is more than 3.1 bar (310 kPa/45 psi), set it to
the correct value. Repeat the
procedure until there is no more
loss of pressure.
If the tyre pressure has fallen
below 3.1 bar (310 kPa/45 psi),
the vehicle must not be driven.
Seek the assistance of a
workshop.
18. Stow tyre repair kit under the front
seat.9 Warning
Do not allow the sealant to contact
skin, eyes or clothing. If swallowed seek medical assistance
immediately.
Notice
The driving characteristics of the
repaired tyre is severely affected,
therefore have this tyre replaced.
If unusual noise is heard or the
compressor becomes hot, turn
compressor off for at least 30
minutes.
The built-in safety valve opens at a
pressure of 7 bar.
Note the expiry date of the kit. After
this date its sealing capability is no
longer guaranteed. Pay attention to
storage information on sealant
bottle.
Replace the used sealant bottle. Dispose of the bottle as prescribed
by applicable laws.
The compressor and sealant can be used from approx. -30 °C.
The adapters supplied can be used
to pump up other items e.g.
footballs, air mattresses, inflatable
dinghies etc. They are located on the underside of the compressor. To
remove, screw on compressor air hose and withdraw adapter.
Wheel changing Some vehicles are equipped with a
tyre repair kit instead of a spare wheel 3 133.
Make the following preparations and
observe the following information:
■ Park the vehicle on a level, firm and
non-slippery surface. The frontwheels must be in the straight-ahead position.
■ Apply the parking brake and engage first gear or reverse gear.
■ Remove the spare wheel 3 138.
144Vehicle care
Windows and windscreen wiperblades
Use a soft lint-free cloth or chamois leather together with window cleanerand insect remover.
When cleaning the rear window from
inside, always wipe in parallel to the
heating element to prevent damage.
For mechanical removal of ice, use a
sharp-edged ice scraper. Press the
scraper firmly against the glass so
that no dirt can get under it and
scratch the glass.
Clean smearing wiper blades with a
soft cloth and window cleaner.
Wheels and tyres
Do not use high-pressure jet
cleaners.
Clean rims with a pH-neutral wheel
cleaner.
Rims are painted and can be treated
with the same agents as the body.Paintwork damage
Rectify minor paintwork damage with
a touch-up pen before rust forms.
Have more extensive damage or rust
areas repaired by a workshop.
Underbody
Some areas of the vehicle underbody
have a PVC undercoating while other critical areas have a durable
protective wax coating.
After the underbody is washed, check
the underbody and have it waxed if
necessary.
Bitumen/rubber materials could
damage the PVC coating. Have
underbody work carried out by a
workshop.
Before and after winter, wash the
underbody and have the protective
wax coating checked.
Engine compartment
It is advisable to wash the engine compartment before and after winter
and preserve it with wax. Protect thealternator and brake fluid reservoir
with plastic sheets before washing
the engine.
When washing the engine with a
steam-jet cleaner, do not direct the
steam jet towards components of the
antilock brake system, air
conditioning system or the belt drive and its components.
After an engine wash, have all engine
compartment components preserved
thoroughly by a workshop using
protective wax.
Do not use high-pressure jet
cleaners.
Towing equipment
Do not clean the coupling ball bar with a steam-jet or high-pressure jet
cleaner.
Interior care Interior and upholstery
Only clean the vehicle interior,
including the instrument panel fascia
and panelling, with a dry cloth or
interior cleaner.
167
Coolant and antifreeze...............147
Coolant heater .............................. 87
Coupling ball bar ........................113
Cruise control ...................... 73, 104
Cupholders .................................. 56
Curtain airbag system .................. 46
D Danger, Warnings and Cautions ...3
Dashboard .................................... 10
Daytime running light ....................79
Declaration of conformity ............164
Diesel fuel filter .......................... 122
Diesel fuel system bleeding .......123
Diesel particle filter ......................95
Doors ............................................ 24
Driver Information Centre .............74
Driving characteristics and towing tips .............................. 112
Driving hints .................................. 93
E Electric adjustment ......................28
Electrical system......................... 128
Electronic driving programmes ....99
Electronic Stability Program 72, 103
End-of-life vehicle recovery .......116
Engine air filter ........................... 119
Engine air flow indicator .............119
Engine coolant ........................... 119Engine coolant temperature ........72
Engine data ............................... 154
Engine exhaust ............................ 95
Engine identification ...................150
Engine oil ................... 117, 147, 152
Engine oil level ............................ 76
Engine oil level monitor ................67
Engine oil pressure ......................73
Event data recorders ..................164
Exhaust gases .............................. 95
Exit lighting .................................. 83
Exterior care .............................. 143
Exterior light ................................. 73
Exterior lighting ......................12, 79
Exterior mirrors ............................. 28
F
Fault ........................................... 100
First aid kit ................................... 58
Fixed air vents ............................. 91
Fog light ....................................... 73
Fog lights .............................. 81, 124
Fog tail light ............................... 127
Folding mirrors ............................. 28
Front airbag system .....................45
Front fog lights ............................. 81
Front seats.................................... 33
Front storage ............................... 56
Front turn signal lights ...............125
Fuel............................................. 109Fuel consumption - CO 2-
Emissions ............................... 111
Fuel for diesel engines ..............110
Fuel for petrol engines ...............109
Fuel gauge ................................... 66
Fuse box ..................................... 129
Fuses ......................................... 128
G Gauges ......................................... 65
General information ...................112
Glovebox ..................................... 55
H Hand brake - see Parking brake. 102
Hazard warning flashers ..............81
Headlight flash ............................. 80
Headlight range adjustment ........80
Headlights ...................... 79, 80, 124
Headlights when driving abroad ..81
Head restraint adjustment .............8
Head restraints ............................ 32
Heated mirrors ............................. 29
Heated rear window ..................... 31
Heating ........................................ 35
Heating and ventilation system ...84
High beam ............................. 73, 80
Horn ....................................... 14, 61