2014 VAUXHALL VIVARO ignition

124Vehicle careBulb replacement
Switch off the ignition and turn off the relevant switch or close the doors.
Only hold a new bulb at the base. Do
not touch the bulb glass with bare
hands.
Use only the same bulb type for
replacement.
Headlights
Low beam and high beam1. Remove harness connector.
2. Remove rubber seal.
3. Release retaining clip and remove
bulb.
4. Renew bulb and install retaining clip ensuring that bulb is in correctorientation.
5. Install rubber seal and harness connector.
Sidelights1. Remove bulb holder from reflector
housing by rotating through 90°.
2. Renew bulb.
3. Install bulb holder in reflector housing.
Fog lights
Have bulbs replaced by a workshop.

128Vehicle careInstrument panel
illumination Have bulbs replaced by a workshop.Electrical system
Fuses
Data on the replacement fuse must match the data on the defective fuse.
The fuse box is located on the left-
hand side of the instrument panel,
below the cupholder.
Before replacing a fuse, turn off the
respective switch and the ignition.
A blown fuse can be recognised by its melted wire. Do not replace the fuse
until the cause of the fault has been
remedied.
It is advisable to carry a full set of
fuses. Provision is made in the fuse
box for the storing of spare fuses.
Some functions are protected by
several fuses.
Fuses may also be inserted without
existence of a function.

Vehicle care141
far away from the discharged
vehicle battery as possible,
however at least 60 cm.
Route the leads so that they cannot
catch on rotating parts in the engine
compartment.
To start the engine: 1. Start the engine of the vehicle providing the jump start.
2. After 5 minutes, start the other engine. Start attempts should be
made for no longer than
15 seconds at an interval of
1 minute.
3. Allow both engines to idle for approx. 3 minutes with the leads
connected.
4. Switch on electrical consumers (e.g. headlights, heated rear
window) of the vehicle receiving
the jump start.
5. Reverse above sequence exactly when removing leads.Towing
Towing the vehicle
The towing eye is stowed with the
vehicle tools 3 131.
Screw the towing eye fully into the
front towing point.
Attach a tow rope - or better still a tow
rod - to the towing eye, never to the
bumper or front suspension units.
Caution
Do not tow the vehicle from the
rear. The front towing eye must
only be used for towing and not
recovering a vehicle.
Caution
Activate the child locks in the rear
doors if the rear seats are
occupied. Child locks 3 23.
Switch on ignition to release steering
wheel lock and to permit operation of
brake lights, horn and windscreen
wipers.
Transmission in neutral.
If neutral cannot be selected on
vehicles with manual transmission automated, the vehicle must only betowed with the drive wheels raised off the ground.

Customer information165
■ Vehicle reactions in particulardriving situations (e.g. inflation of
an airbag, activation of the stability
regulation system)
■ Environmental conditions (e.g. temperature)
These data are exclusively technical
and help identifying and correcting
errors as well as optimizing vehicle
functions.
Motion profiles indicating travelled
routes cannot be created with these
data.
If services are used (e.g. repair
works, service processes, warranty cases, quality assurance),
employees of the service network
(manufacturer included) are able to
read out this technical information
from the event and error data storage
modules applying special diagnostic
devices. If required, you will receive
further information at these
workshops. After an error has been
corrected, the data are deleted from
the error storage module or they are
constantly overwritten.When using the vehicle, situations
may occur in which these technical
data related to other information
(accident report, damages on the
vehicle, witness statements etc.) may be associated with a specific person -
possibly, with the assistance of an
expert.
Additional functions contractually
agreed upon with the client (e.g.
vehicle location in emergency cases)
allow the transmission of particular vehicle data from the vehicle.Radio Frequency
Identification (RFID) RFID technology is used in somevehicles for functions such as tyre
pressure monitoring and ignition
system security. It is also used in
connection with conveniences such
as radio remote controls for door
locking/unlocking and starting, and in-
vehicle transmitters for garage door
openers. RFID technology in
Vauxhall vehicles does not use or
record personal information or link with any other Vauxhall system
containing personal information.

168
I
Identification plate .....................150
Ignition switch positions ...............94
Immobiliser .................................. 27
Indicators ...................................... 65
Information displays...................... 74
Instrument panel fuse box .........129
Instrument panel illumination .....128
Instrument panel overview ........... 10
Instrument panel storage ..............55
Interior care ............................... 144
Interior lights ........................ 82, 127
Interior mirrors .............................. 29
Interruption of power supply ......100
Introduction .................................... 3
Isofix child restraint systems ........ 54
J Jump starting ............................. 139
K Keys ............................................. 18
Keys, locks ................................... 18
L
Lashing eyes ............................... 57
Light covers, misted...................... 82
Lighting ......................................... 79
Light switch .................................. 79
Load compartment ....................... 25Load compartment cover .............56
Load compartment lighting ..........82
Loading information .....................58
Load rails and hooks ...................57
Low fuel ....................................... 73
M Malfunction indicator light ............71
Manual adjustment ......................28
Manual anti-dazzle ......................29
Manual mode ............................... 99
Manual transmission .................... 96
Manual transmission automated . 97
Manual windows ..........................30
Messages ..................................... 75
Mirror adjustment ........................... 8
Mirrors .................................... 28, 29
Misted light covers .......................82
N
New vehicle running-in ................94
Number plate light .....................126
O Object detection systems ...........108
Octane rating .............................. 154
Odometer ..................................... 65
Oil ............................................... 117
Oil, engine .......................... 147, 152
Oil level ......................................... 67Oil pressure.................................. 73
Outside temperature ....................63
Overcab storage ..........................56
Overrun cut-off ............................. 95
P Parking .................................. 17, 95
Parking assist ............................ 108
Parking brake ............................ 102
Particulate filter ............................. 95
Performing work ........................116
Pollen filter ................................... 91
Power outlets ............................... 64
Power steering fluid ...................120
Power windows ............................ 30
Preheating ................................... 72
Puncture ..................................... 136
R Radio Frequency Identification (RFID) ..................................... 165
Radio remote control ...................18
Reading lights .............................. 83
Rear air conditioning system .......86
Rear doors ................................... 24
Rear fog light ............................... 73
Rear fog lights ............................. 82
Rear heating system .................... 86
Rear seats .................................... 36
Rear windows .............................. 30