2014 TOYOTA YARIS HYBRID light

3788-2. Steps to take in an emergency
Once(Flashes in
yellow for
15 seconds.)
Smart entry & start system indicator light
Indicates that the electronic key is not pres-
ent when attempting to start the hybrid sys-
tem.
Confirm the location of the electronic
key.
9 times(Flashes in
yellow)
Smart entry & start system indicator light
An attempt was made to drive when the
regular key was not inside the vehicle.
Confirm that the electronic key is inside
the vehicle.
Once(Flashes in
yellow for
15 seconds.)
Smart entry & start system indicator light
Indicates that the electronic key battery is
low.
Replace the battery. (P. 335)
Once(Flashes quickly
in green for
15 seconds.)
Smart entry & start system indicator light
Indicates that the steering lock has not
been released.
Release the steering lock. (P. 183)
Once(Flashes in yellow
for 30 seconds.)
Smart entry & start system indicator light
• When the doors were unlocked with the
mechanical key and then the power
switch was pressed, the electronic key
could not be detected in the vehicle.
• The electronic key could not be detected
in the vehicle even after the power switch
was pressed two consecutive times.
Touch the electronic key to the power
switch while depressing the brake
pedal.
Interior
buzzerExterior
buzzerWarning
lightWarning light/Details/Actions

3848-2. Steps to take in an emergency
Chock the tires.
For vehicles with steel wheels,
remove the wheel ornament
using the wrench.
To protect the wheel ornament,
place a rag between the wrench
and the wheel ornament.
Slightly loosen the wheel nuts
(one turn).
Replacing a flat tire
1
Flat tireWheel chock positions
FrontLeft-hand sideBehind the rear right-hand side tire
Right-hand sideBehind the rear left-hand side tire
RearLeft-hand sideIn front of the front right-hand side tire
Right-hand sideIn front of the front left-hand side tire
2
3

3858-2. Steps to take in an emergency
8
When trouble arises
Turn the tire jack portion by
hand until the notch of the jack
is in contact with the jack point.
The jack point guides are located
under the rocker panel. They indi-
cate the jack point positions.
Raise the vehicle until the tire is
slightly raised off the ground.
Remove all the wheel nuts and
the tire.
When resting the tire on the
ground, place the tire so that the
wheel design faces up to avoid
scratching the wheel surface.
4
5
6

3898-2. Steps to take in an emergency
8
When trouble arises
Vehicles with aluminum wheels
Remove the center wheel orna-
ment by pushing from the
reverse side.
Be careful not to lose the wheel
ornament.
Stow the flat tire, tire jack and all tools.
The compact spare tire
The compact spare tire is identified by the label “TEMPORARY USE ONLY”
on the tire sidewall.
Use the compact spare tire temporarily, and only in an emergency.
Make sure to check the tire inflation pressure of the compact spare tire.
(P. 435)
After completing the tire change (vehicles with a tire pressure warning
system)
The tire pressure warning system must be reset. (P. 316)
When using the spare tire (include compact spare tire) (vehicles with a
tire pressure warning system)
As the spare tire is not equipped with a tire pressure warning valve and trans-
mitter, low inflation pressure of the spare tire will not be indicated by the tire
pressure warning system. Also, if you replace a flat tire with the spare tire
after the tire pressure warning light comes on, the light remains on.
If you have a flat front tire on a road covered with snow or ice
Install the compact spare tire on one of the rear wheels of the vehicle. Per-
form the following steps and fit tire chains to the front tires:
Replace a rear tire with the compact spare tire.
Replace the flat front tire with the tire removed from the rear of the vehi-
cle.
Fit tire chains to the front tires.
5
6
1
2
3

4008-2. Steps to take in an emergency
Pull the hose out from the com-
pressor.
Connect the power plug to the
power outlet socket or cigarette
lighter socket. (P. 281, 282)
Attach the 2 stickers as shown.
Remove any dirt and moisture from
the wheel before attaching the
label. If it is impossible to attach
the label, make sure to tell any
authorized Toyota dealer or
repairer, or another duly qualified
and equipped professional when
you have them repair and replace
the tire that sealant is injected.
7
8
9

4038-2. Steps to take in an emergency
8
When trouble arises
With the compressor switch off, disconnect the nozzle from the
valve on the tire and then pull out the power plug from the power
outlet socket or cigarette lighter.
Some sealant may leak when the hose is removed.
Install the valve cap onto the valve of the emergency repaired tire.
Disconnect the hose from the
bottle and attach the cap to the
bottle.
Place the bottle in the original bag
and zip it.
Temporarily store the bottle and compressor in the luggage com-
partment.
To spread the liquid sealant evenly within the tire, immediately drive
safely for about 5 km (3 miles) below 80 km/h (50 mph).
After driving for about 5 km (3
miles), stop your vehicle in a
safe place on a hard, flat sur-
face and connect the compres-
sor.
15
16
17

4108-2. Steps to take in an emergency
If the hybrid system will not star t
One of the following may be the cause of the problem:
Vehicles with a smart entry & start system: The electronic key may
not be functioning properly. (P. 414)
There may not be sufficient fuel in the vehicle’s tank.
Refuel the vehicle. (P. 206)
There may be a malfunction in the immobilizer system. (P. 8 2 )
There may be a malfunction in the steering lock system.
The hybrid system may be malfunctioning due to an electrical prob-
lem such as electronic key battery depletion or a blown fuse. How-
ever, depending on the type of malfunction, an interim measure is
available to start the hybrid system. (P. 411)
One of the following may be the cause of the problem:
The 12-volt battery may be discharged. (P. 415)
The 12-volt battery terminal connections may be loose or corroded.
(P. 310)
Reasons for the hybrid system not starting vary depending on
the situation. Check the following and perform the appropriate
procedure:
The hybrid system will not start even though the correct starting
procedure is being followed. (P. 176, 180)
The interior lights and headlights are dim, or the horn does not
sound or sounds at a low volume.

4118-2. Steps to take in an emergency
8
When trouble arises
One of the following may be the cause of the problem:
The 12-volt battery may be discharged. (P. 415)
One or both of the 12-volt battery terminals may be disconnected.
(P. 310)
Contact any authorized Toyota dealer or repairer, or another duly qualified
and equipped professional if the problem cannot be repaired, or if repair
procedures are unknown.
When the hybrid system does not start, the following steps can be
used as an interim measure to start the hybrid system if the power
switch is functioning normally:
Do not use this starting procedure except in cases of emergency.
Set the parking brake.
Shift the shift lever to P.
Turn the power switch to ACCESSORY mode.
Press and hold the power switch for about 15 seconds while
depressing the brake pedal firmly.
Even if the hybrid system can be started using the above steps, the
system may be malfunctioning. Have the vehicle inspected by any
authorized Toyota dealer or repairer, or another duly qualified and
equipped professional.
The Interior lights and headlights do not turn on, or the horn
does not sound.
Emergency start function (vehicles with a smart entry & start
system)
1
2
3
4