2014 TOYOTA URBAN CRUISER maintenance

366
4-3. Do-it-yourself maintenance
URBAN CRUISER_OM_OM52F47E_(EE)
Hood
Release the lock from the inside of the vehicle to open the hood.
Pull the hood release lever.
The hood will pop up slightly.
Lift the hood catch and lift the
hood.
Hold the hood open by insert-
ing the supporting rod into the
slot.
STEP1
STEP2
STEP3

367
4-3. Do-it-yourself maintenance
4
Maintenance and care
URBAN CRUISER_OM_OM52F47E_(EE)
CAUTION
■
Pre-driving check
Check that the hood is fully closed and locked.
If the hood is not locked properly, it may open while the vehicle is in motion
and cause an accident, which may result in death or serious injury.
■ After installing the support rod into the slot
Make sure the rod supports the hood securely from falling down on to your
head or body.
NOTICE
■When closing the hood
Be sure to return the support rod to its clip before closing the hood. Closing
the hood without returning the support rod properly could cause the hood to
bend.

368
4-3. Do-it-yourself maintenance
URBAN CRUISER_OM_OM52F47E_(EE)
Positioning a floor jack
When raising your vehicle with a floor jack, position the jack cor-
rectly. Improper placement may damage your vehicle or cause injury.
Front
Rear (2WD models)
Rear (4WD models)

369
4-3. Do-it-yourself maintenance
4
Maintenance and care
URBAN CRUISER_OM_OM52F47E_(EE)
CAUTION
■
When raising your vehicle
Make sure to observe the following to reduce the possibility of death or seri-
ous injury.
●When using a floor jack, follow the instructions of the manual provided with
the jack.
● Do not use the jack that was supplied with your vehicle.
● Do not put any part of your body underneath the vehicle when it is sup-
ported only by the floor jack.
● Always use floor jack and/or automotive jack stands on a solid, flat, level
surface.
● Do not start the engine while the vehicle is supported by the floor jack.
● Stop the vehicle on level firm ground, firmly set the parking brake and shift
the shift lever in “R”.
● Make sure to set the floor jack properly at the jack point.
Raising the vehicle with an improperly positioned floor jack will damage
the vehicle and may cause the vehicle to fall off the floor jack.
● Do not raise the vehicle while someone is in the vehicle.
● When raising the vehicle, do not place any objects on top of or underneath
the floor jack.
●Lift up the vehicle using a floor jack
such as the one shown in the illustra-
tion.

370
4-3. Do-it-yourself maintenance
URBAN CRUISER_OM_OM52F47E_(EE)
Engine compar tment
Gasoline engine
Washer fluid tank (→P. 386)
Engine oil filler cap (→ P. 373)
Battery ( →P. 380)
Fuse box ( →P. 402)Engine coolant reservoir
(→ P. 377)
Radiator ( →P. 379)
Condenser ( →P. 379)
Electric cooling fan
Engine oil level dipstick (→ P. 372)

371
4-3. Do-it-yourself maintenance
4
Maintenance and care
URBAN CRUISER_OM_OM52F47E_(EE)
Diesel engine
Engine oil filler cap
(→ P. 373)
Fuel filter ( →P. 497)
Battery ( →P. 380)
Fuse box ( →P. 402)
Intercooler ( →P. 379)
Electric cooling fan
Condenser ( →P. 379)Radiator ( →P. 379)
Engine oil level dipstick (→ P. 372)
Engine coolant reservoir (→ P. 377)
Washer fluid tank ( →P. 386)
Fuse box (if equipped) (→ P. 402)

372
4-3. Do-it-yourself maintenance
URBAN CRUISER_OM_OM52F47E_(EE)
Engine oil With the engine at operating temperature and turned off, check the oil
level on the dipstick.
■ Checking the engine oil
Park the vehicle on level ground. After warming up the engine
and turning it off, wait more than 5 minutes for the oil to drain
back into the bottom of the engine.
Hold a rag under the end and
pull the dipstick out.
Wipe the dipstick clean.
Reinsert the dipstick fully.
STEP1
STEP2
STEP3
STEP4

373
4-3. Do-it-yourself maintenance
4
Maintenance and care
URBAN CRUISER_OM_OM52F47E_(EE)
Holding a rag under the end, pull
the dipstick out and check the oil
level.
Low
Normal
Excessive
The shape of the dipstick may dif-
fer depending on the type of vehi-
cle or engine.
Wipe the dipstick and reinsert it fully.
■ Adding engine oil
If the oil level is below or near
the low level mark, add engine
oil of the same type as already in
the engine.
STEP5
STEP6