JOBNAME: 1491140-2014-r4eWG-E PAGE: 41 SESS: 11 OUTPUT: Thu Aug 1 07:50:38 2013
/tweddle/toyota/sched-maint/1491140-en-r4e/wg
120,000 miles or 144 months
Check installation of driver’s floor matInspect and adjust all fluid levelsInspect wiper bladesReplace cabin air filterReplace battery coolant3
Replace motor/inverter coolant4
Rotate tires
Inspect the following:
__ Ball joints and dust covers
__ Battery coolant
__ Brake lines and hoses
__ Brake linings/drums and brakepads/discs
5
__ Drive shaft boots
__ Health check __ Heater coolant
__ Motor/Inverter coolant
__ Radiator, condenser, hoses and/or
intercooler
__ Steering gear box
__ Steering linkage and boots
Additional Maintenance Items for Special Operating Conditions
1
Driving on dirt roads or dusty roads:Tighten nuts and bolts on chassis and body
Driving while towing, using a car-top carrier, or heavy vehicle loading2:Tighten nuts and bolts on chassis and body
DEALERSERVICEVERIFICATION:
D
AT E:
M
ILEAGE:
1Perform these service items only if you drive primarily under the conditions indicated.2Not all vehicles are designed for towing. Refer to your Vehicle Owner’s Manual for details.3Perform this service item at every 48 months or 50,000 miles whichever comes first. Refer to “Battery Coolant” in
the “Explanation of Maintenance Items” section in the back of this guide for more information.
4Perform this service item at every 48 months or 50,000 miles whichever comes first. Refer to “Motor/Inverter
Coolant” in the “Explanation of Maintenance Items” section in the back of this guide for more information.
5Inspect thickness measurement and disc runout.
Maintenance Log
MAINTENANCE
Maintenance Log41
JOBNAME: 1491140-2014-r4eWG-E PAGE: 42 SESS: 11 OUTPUT: Thu Aug 1 07:50:38 2013
/tweddle/toyota/sched-maint/1491140-en-r4e/wg
T
he following descriptions are
provided to give you a better
understanding of the maintenance
items that should be performed on your
vehicle. The scheduled maintenance log
indicates at which mileage/time intervals
each item should be performed. Please
note that many maintenance items should
be performed only by a qualified
technician.
For further information on maintenance
items you can perform yourself, see
the “Vehicle Maintenance and Care”
and “Do-It-Yourself Maintenance”
sections of the
Owner’s Manual.
Ball Joints and Dust Covers
Check the suspension and steering linkage
ball joints for looseness and damage.
Check all dust covers for deterioration and
damage. Replace any deteriorated or
damaged parts. A qualified technician
should perform these operations.
Battery Coolant
Replace at specified intervals. When
performing inspections, check that the
battery coolant level is between the FULL
and LOW lines on the see-through
reservoir tank.
Notice: A qualified technician should
perform this operation.
• Only use Zerex G 48 orGlysantin G
48. The dilution ratio for both Zerex
G 48 andGlysantin G 48 is 50%
coolant and 50% deionized water.
Therefore, dilution is needed when
coolant in the vehicle is added.
• Do not use TOYOTA Super Long Life
Coolant (SLLC) or similar high quality
ethylene glycol based non-silicate,
non-amine, non-nitrite, and non-borate
coolant with long-life hybrid organic
acid technology.
• To prevent foreign matter such as
dust or dirt from entering the cooling
system, make sure to confirm that the
container used to add coolant is clean
and free of foreign matter such as
dust or dirt.
Brake Lines and Hoses
Visually inspect for proper installation.
Check for chafing, cracks, deterioration
and signs of leakage. Replace any
deteriorated or damaged parts. A qualified
technician should perform these
operations.
Brake Linings/Drums and Brake
Pads/Discs
Check the brake linings (shoes) and
drums for scoring, burning, fluid leakage,
broken parts and excessive wear. Check
the pads for excessive wear and the discs
for runout, excessive wear and fluid
leakage. Replace any deteriorated or
damaged parts. A qualified technician
should perform these operations.
Explanation of Maintenance Items
42Maintenance Log
MAINTENANCE
